2003 RENAULT CLIO light
[x] Cancel search: lightPage 151 of 210
1
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T4.WIN 28/10/2002 11:44-page11
4.11
LEVELS(continued)FILTERS
Windscreen washer reservoir
Filling:via plug1.
This reservoir also supplies the
headlight washers (if fitted to the
vehicle).
Liquid:water + washer product
(antifreeze product in winter).
Jets:tilt each small sphere with a
pin to alter the angle of the spray.The replacement of filter elements
(air filter, passenger compartment
filter, diesel filter, etc.) is
anticipated in the maintenance
operations for your vehicle.
Frequency for replacing filter
components:see the Servicing
booklet for your vehicle.If there is an abnormal drop in
any of the fluid levels, consult
your Renault Dealer at once.
Take care when working
under the bonnet as the
engine cooling fan may
cut in at any moment.
Page 152 of 210
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T4.WIN 28/10/2002 11:44-page12
4.12
BODYWORK MAINTENANCE
Protection against the action of
corrosive agents
Although your vehicle has been
treated with very effective
anti-corrosion products, it is still
subject to the action of:
• corrosives in the atmosphere
- atmospheric pollution (urban
and industrial areas),
- saline atmosphere (near the sea,
particularly in hot weather),
- seasonal and humid climatic
conditions, especially road salt
in winter.
• abrasives
- wind-carried dust and sand, mud,
road grit thrown up by other
vehicles.
• minor impacts
To avoid losing the benefits of this
protection, a minimum number of
precautions should be taken to
ensure against this risk.
What you must not do
• Wash the vehicle in bright sunlight
or in freezing temperatures.
• Scrape off mud or dirt without
pre-wetting.
• Allow external dirt to accumulate.
• Allow rust to form after minor
impacts.
• Use solvents not recommended
by Renault's Technical Department
to remove spots as they may
damage the paintwork.
• Drive frequently in snow or muddy
conditions without periodically
washing the car, particularly
under the wheel arches and under
the body.• Degrease or clean mechanical
components (e.g. engine
compartment), underneath the
bodywork, parts with hinges (e.g.
inside the fuel tank flap, sunroof)
and painted plastic external
fittings (e.g. bumpers) using high
pressure cleaning apparatus or
spraying on products which are
not approved by our Technical
Department as this could give rise
to corrosion or incorrect operation.
Page 153 of 210
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T4.WIN 28/10/2002 11:44-page13
4.13
BODYWORK MAINTENANCE(continued)
What you should do
• Wash your car frequently, using our
recommended cleaning products
anduseahighpressurejettorinse
off the wheel arches and under the
body to get rid of:
- spots of tree resin and industrial
grime;
-bird droppings, which contain
chemicals whichrapidly
discolour paintwork and may
even cause the paint to peel off;
The vehiclemustbe washed
immediately to remove these
marks since they cannot be
removed by polishing;
- salt from the wheel arches and
under the body, after the vehicle
has been driven in areas where
the roads are chemically treated;
- mud forming damp patches in
the wheel arches and under the
body.• Keep well away from the vehicle
in front when driving on a freshly
laid surface to avoid damage to
your paintwork.
• Have patches where the paint has
been damaged repaired quickly to
avoid corrosion spreading.
• If your vehicle is covered by the
Renault anti-corrosion warranty,
remember to visit the bodyshop
periodically. Refer to your vehicle’s
Warranty and Servicing booklet.
• Respect local regulations relating
to washing your vehicle (e.g. do
not wash your vehicle on a public
highway).• Before using a revolving brush
type car wash, check the mounting
of exterior equipment, additional
headlights and rear view mirrors.
Secure the wiper blades and radio
aerial with adhesive tape.
Remove the car phone aerial if the
vehicle has one.
• If mechanical components such
as hinges have to be cleaned, their
protection must be reapplied by
spraying on products approved
by Renault's Technical Department.
We have selected special products
to care for your vehicle which
may be obtained from Renault
Accessory Outlets.
Page 154 of 210
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T4.WIN 28/10/2002 11:44-page14
4.14
MAINTAINING INTERIOR TRIM
Do
Whatever type of stain is on the
trim, use soapy water (if necessary,
with warm water) based on:
• natural soap,
• washing up liquid (with one part
washingupliquidto200parts
water).
Rinse off with a soft, damp cloth.
Special instructions
• Glass instrument panel(e.g.:
instrument panel, clock, exterior
temperature display, radio
display, etc...).
Use a soft cloth (or cotton wool).
If this does not clean them
properly, use a soft cloth or cotton
wool slightly moistened with
soapy water and then wipe clean
with a soft damp cloth.
Finally, dry offcarefullywith a
soft dry cloth.
Cleaning products containing
alcohol may not be used under
any circumstances.• Seat belts
These must be kept clean.
Use products selected by our
Technical Department or warm
soapy water using a sponge and
dry off with a dry cloth.
Do not use cleaning agents or
dyes.
We have selected special
products to care for your vehicle
and you can obtain these from
Renault accessory outlets.Do not
You are strongly recommended
not to use high pressure or
atomising cleaning equipment
inside the passenger
compartment: unless carefully
used, such equipment could
interfere with correct operation
of the electrical or electronic
components in the vehicle,
amongst other effects.
Page 155 of 210
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T5.WIN 30/10/2002 12:27-page1
5.01
Section 5: Practical advice
Emergency spare wheel .................................................................................................................................... 5.02
Toolkit (Jack - Wheelbrace - Tyre levers etc.) ................................................................................................ 5.03
Hubcaps - Wheels ............................................................................................................................................. 5.04
Changing a wheel ............................................................................................................................................. 5.05
Tyres (tyre safety, wheels, winter use) ............................................................................................... 5.06
¬5.08
Wiper blades ..................................................................................................................................................... 5.09
Changing the bulbs .............................................................................................................................. 5.10
¬5.18
Headlights ................................................................................................................................... 5.10
¬5.12
Front fog lights ........................................................................................................................................ 5.13
Rear lights ..................................................................................................................................... 5.14 - 5.15
Side-mounted repeaters .......................................................................................................................... 5.16
Interior lights ................................................................................................................................ 5.17 - 5.18
Battery ..................................................................................................................................................... 5.19 - 5.20
Remote control door locking (changing the batteries) ..................................................................................5.21
Fuses ....................................................................................................................................................... 5.22 - 5.23
Towing (breakdown - attachments) .................................................................................................... 5.24
¬5.26
Fitting a radio/accessories .................................................................................................................... 5.27 - 5.28
Operating incidents ............................................................................................................................. 5.29
¬5.34
Page 159 of 210
1
3
2
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T5.WIN 30/10/2002 12:27- page 5
5.05
CHANGING A WHEEL
•Remove the wheel embellisher
(see section on embellishers).
• Use the wheelbrace1to loosen
the wheel bolts slightly. Fit it so
that you press downwards and
not upwards.
• Offer up the jack horizontally, the
jack head must be slid
underneath the jacking point
under the body, nearest the wheel
concerned.
• Screw up the jack by hand at first
to align the base plate (which
should be inclined further
inwards than the jack head). Use a
piece of wood under the base
plate if on soft ground.• Insert the end of the wheelbrace2
into the jack3and turn a few
times to lift the wheel off the
ground:
• Remove the bolts.
• Take off the wheel.
• Position the emergency spare
wheel on the central hub and turn
it to locate the mounting holes in
the wheel and the hub.
• Tighten the bolts and lower the
jack.
• Tighten the bolts fully when the
wheel is on the ground.Park your vehicle on firm,
flat ground (if necessary,
placing a plank under the
base of the jack).
Switch on the hazard warning
lights.
Apply the handbrake and engage a
gear (first or reverse, orPon an
automatic gearbox).
Ask all the passengers to get out of
the vehicle and keep them away
from moving traffic.
If you have a puncture,
replace the wheel as soon
as possible.
A tyre which has been
punctured should always be
inspected (and repaired if possible)
by a specialist.
Page 164 of 210
AB1
5
4
3
2
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T5.WIN 30/10/2002 12:27-page10
5.10
HEADLIGHTS WITH HALOGEN BULBS: replacing bulbs
Headlight main beam
Remove the coverA.
Unclip bulb connector1.
Disengage the springs2and remove
the bulb.
Dipped beam headlights
Remove coverB.
Turn the connector a quarter of a
turn and remove bulb3.
Type of bulb:1
¶H1
3 ¶H7
anti-UV (see box).
Do not touch the Halogen bulb
glass. Hold it by its base.
Front side lights
Remove the bulb holder5to access
the bulb.
Bulb type: W5W.
Direction indicator lights
Turn the bulb holder4aquarterofa
turn and remove the bulb.
Bulb type: PY21W.
When the bulb has been changed,
please refit the cover.
Cleaning the headlights
As the headlights have plastic
lenses, use a soft cloth or cotton
wool.
If this is not sufficient, use a soft
cloth (or cotton wool) dampened
with soapy water then rinse using a
soft cloth or cotton wool.
Carefullydry off using a soft, dry
cloth.
Alcohol based cleaning products
must not be used under any
circumstances.
As the headlights are
fitted with plastic
“lenses”, it is essential to
use anti-UV bulbs.
(If other bulbs are used, this may
damage the headlight).
It is advisable to carry a set of
spare bulbs for emergencies.
Page 165 of 210
B
A
2
31
4
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T5.WIN 30/10/2002 12:27-page11
5.11
HEADLIGHTS WITH XENON BULBS: replacing bulbs
Dipped beam headlights with
xenon bulbs
They are marked on the label3
under the coverB.
This type of headlight bulb must be
changed by a RENAULT Dealer.
Bulb type: D2S.
A special mounting is
required to fit this type of
headlight.It is not
permitted to fit a headlight
fitted with xenon bulbs to a vehicle
which was not designed to accept
it.
Main beam headlights
Remove coverA.
Turn the connector1a quarter of a
turn and remove the bulb.
Type of bulb: anti U.V. (see box).
Do not touch the Halogen bulb
glass. Hold it by its base.
When the bulb has been changed,
refit coverAcorrectly.
As headlights are fitted
with plastic lenses, you
must use anti-UV 55 W
bulbs.(Using any other
type of H1 bulb may damage the
headlight).
It is advisable to carry a set of
spare bulbs for emergencies.