2003 PEUGEOT BOXER DAG audio

Superimposed display In certain cases, when a function
(radio, telephone, trip computer, ...)changes status while another func-tion is displayed, a window opensto inform you of the change, thendisappears.
MULTI-FUNCTION
DISPLAYS Presentation Monochrome display Colour display These two multi-function displays are an integral part of the audio/tele-
phone/GPS . Therefore, they are
controlled by its control keypad andby its steering wheel stalk. They enable you to obtain the follow-ing information:
Ð displaying of the audio sources
(radio, CD),
Ð displaying of the telematic systems (telephone, services, ...),
Ð displaying of the satellite naviga- tion system (see corresponding section),
Ð displaying of the trip computer (see corresponding section),
Ð the warning messages (e.g. "Warning, maximum speedexceeded") or information mes-sages (e.g. "SIM card absent") dis-
played temporarily.
YOUR BOXER IN DETAIL
50
Main screen Press the
"MAIN/DARK" button to
display the main screen , display
the information relating to the active source (radio, CD, tele-phone or navigation) and gainaccess to the following functions:
Ð Voice memory,
Ð Setup. The "Voice Memory" function per-
mits management of the recorded
voice messages. You can listen tothem again or delete them.
The messages are played in sequence,from the oldest to the most recent.
Deleting deletes all of the messages. The "Setup" function permits
modification of the general system parameters (see ¤ "Parameterconfiguration").
17-11-2003

17-11-2003
YOUR BOXER IN DETAIL53
Modem The "Modem" function permits an
exchange of data between the sys- tem and a laptop.
To permit an exchange of data, you must:
Ð connect the computer to the sys- tem using its cable located in the centre of the fascia panel underthe storage compartment,
Ð configure the serial port of the computer to 9 600 bits/s; 8 databits; no parity; 1 stop bit; flux
Xon/Xoff check,
Ð install the modem on the computer,
Ð activate the "modem" function,
Ð insert the SIM card.
TRIP COMPUTER Each time the TRIPbutton on the
audio/telephone control panel is pressed, the following sequence ofdata is displayed:
Ð the average speed calculated
since the last trip computer zero reset (ignition on);
Ð the distance travelled since the
last trip computer zero reset;
Ð the duration of the journey or
time elapsed since the last tripcomputer zero reset, indicated in"hours and minutes";
Ð the distance remaining or distance
to the destination. This is calculatedat any time by the navigation systemif guidance is activated, or entered bythe user minus the distance travelledsince the data was entered; Ð the
time of arrival or the approxi-
mate time of arrival at the destina-
tion. This is obtained by adding
30 % to the remaining duration of
the journey, calculated from theaverage speed and added to thecurrent time.

17-11-2003
YOUR BOXER IN DETAIL53
Modem The "Modem" function permits an
exchange of data between the sys- tem and a laptop.
To permit an exchange of data, you must:
Ð connect the computer to the sys- tem using its cable located in the centre of the fascia panel underthe storage compartment,
Ð configure the serial port of the computer to 9 600 bits/s; 8 databits; no parity; 1 stop bit; flux
Xon/Xoff check,
Ð install the modem on the computer,
Ð activate the "modem" function,
Ð insert the SIM card.
TRIP COMPUTER Each time the TRIPbutton on the
audio/telephone control panel is pressed, the following sequence ofdata is displayed:
Ð the average speed calculated
since the last trip computer zero reset (ignition on);
Ð the distance travelled since the
last trip computer zero reset;
Ð the duration of the journey or
time elapsed since the last tripcomputer zero reset, indicated in"hours and minutes";
Ð the distance remaining or distance
to the destination. This is calculatedat any time by the navigation systemif guidance is activated, or entered bythe user minus the distance travelledsince the data was entered; Ð the
time of arrival or the approxi-
mate time of arrival at the destina-
tion. This is obtained by adding
30 % to the remaining duration of
the journey, calculated from theaverage speed and added to thecurrent time.

YOUR BOXER IN DETAIL
54
AUDIO/TELEPHONE/GPS
Action Function
1- Press Volume increase.
2- Press Volume decrease.
3- Press Activation/Deactivation of voice
commands. Pressing for more than 1 second:recording of a voice description.
4- Press Sound cut-off (MUTE) -
Restoration of sound.
5- Press Selection of the next stored
station (radio).Selection of the next track (CD).
6- Press Selection of the previous stored
station (radio).Selection of the previous track (CD).
7- Press
Pick up (Incoming call/Not in communication) -Hang up (In communication) - Redial.
Pressing for more than 1 second:
Hang up (Incoming call).
8- Press Change of audio source
(FM1/FM2/FM3/LW/MW/CD).
17-11-2003

YOUR BOXER IN DETAIL55
Button Function
A SRC Selection of the audio source: FM1, FM2, FM3, LW, MW, CD.
B ON/OFF VOL Press: system on/off - Rotation: volume adjustment.
C MAIN DARK Displaying of the main screen - Radio or CD on.
Pressing for more than 1 second: display on standby.
D AUDIO OFF Displaying of the audio source - Activation of the display.
Pressing for more than 1 second: radio or CD off.
E TEL OFF Displaying of the telephone source - Telephone system on.
Pressing for more than 1 second: telephone system off.
F NAV MUTE Displaying of the navigation source.
Pressing for more than 1 second: cut-off/restoration of voice messages.
G TRIP Displaying of the trip computer source.
H SEL Rotation: selection of the required function - Adjustment of the display brightness (video camera). Map zoom +/Ð.
Press: confirmation of the selected function - Displaying of the "MAIN" and "NAV" pull-down menu.
I ESC Cancellation of the current operation - Exit from the current screen and return to the previous screen.
Deletion of a character.Pressing for more than 1 second: deletion of all characters.
J SIM card flap.
K RPT Repetition of the last updated voice message (navigation).
L Displaying of the information and assistance services.
M

Ejection of the CD-Rom or audio CD.
N Activation/Deactivation of the voice commands. Pressing for more than 1 second: recording of a voice description.
17-11-2003

17-11-2003
YOUR BOXER IN DETAIL57
GENERAL FUNCTIONS On/Off With the ignition key in the "ON"position, the audio/telephone/GPS comes on automatically.
Switching off is also automatic when the key is turned to the "STOP"position.
You can also switch the audio/telephone/GPS on or off manually by pressing knob B.
In this case, the audio/telephone/GPS can operate for 20 minutes without the ignition being switched on. Notes:
Ð the SIM card must only be removed or inserted after switching off the audio/telephone/GPS,
Ð when the audio-telephone/GPS is switched off after 20 minutes, communication is possible by pressing button O,
Ð after the ignition has been switched off, the audio/telephone/GPS can be switched on again by pressing button Lor Oor
by inserting a CD in the player.
Anti-theft system The audio/telephone/GPS is coded so that it can only operate in your vehicle. If it is installed in another vehicle, contact yo ur
PEUGEOT dealer to have the system configured. The anti-theft system is automatic and does not require any intervention on your part. VOLUME ADJUSTMENT
Turn knob Bclockwise to increase the volume of the audio-telephone/GPS or anti-clockwise to decrease the volume.
Note: the volume setting is specific to each source. It is posible to have a different setting for the radio, CD, telephone or
voice messages.
SOUND CUT-OFF/RESTORATION
To gradually restore or cut off the volume of an audio source, press the "AUDIO OFF"button.
To gradually restore or cut off the volume of the navigation source voice messages, press the "NAV MUTE"button for more
than one second. Note: during telephone calls, the volume of the other sources is cut off automatically.

17-11-2003
YOUR BOXER IN DETAIL
58
AUDIO SETTINGS Select the audio source (radio or CD) for which you wish to adjust the settings by pressing the "SRC"button repeatedly.
Select the "Audio Setup" function from the audio source menu by turning knob H, then press this knob to confirm.
You will then gain access to the treble, bass, loudness, equalizer, manual equalizer, automatic volume adjustment and balance/fader settings.
Adjusting the treble Select the "Treble"function from the "Audio Setup"menu by turning knob H, then press this knob to confirm.
Turn knob Hto the right for the maximum treble setting.
Leave the cursor in the medium position for a normal setting.
Turn knob Hto the left for a minimum treble setting.
Following adjustment, press knob Hto confirm the change.
Adjusting the bass Select the "Bass"function from the "Audio Setup"menu by turning knob H, then press this knob to confirm.
Turn knob Hto the right for the maximum bass setting.
Leave the cursor in the medium position for a normal setting.
Turn knob Hto the left for a minimum bass setting.
Following adjustment, press knob Hto confirm the change.
Activation/deactivation of the loudness
This function permits automatic accentuation of the bass and treble when the volume is low. Select the "Loudness" function from the "Audio Setup"menu by turning knob H, then press this knob to confirm.
Turn knob Hto select "YES"or "NO" .
When the selection has been made, press knob Hto confirm the change.

17-11-2003
YOUR BOXER IN DETAIL59
Activation/deactivation of the equalizer This function permits selection of one of the pre-defined equalizer settings in relation to the type of music playing. Select the "Equalizer" function from the "Audio Setup"menu by turning knob H, then press this knob to confirm.
Turn knob Hto select the required setting "PRESET", "ROCK" , "JAZZ" , "CLASSIC" or "USER" .
When the selection has been made, press knob Hto confirm the change.
Note: by default, the "PRESET"standard setting is selected, you can also personalise your settings by selecting "USER".
Manual equalizer adjustment This function permits adjustment of the five frequency bands of the equalizer and deacitvation of the bass and treble settings. Select the "Manual equalizer" function from the "Audio Setup"menu by turning knob H, then press this knob to confirm.
Select a frequency band by turning knob H, then press this knob to confirm.
Leave the cursor in the medium position for a normal setting.
Turn knob Hto set.
After setting, press knob Hto confirm the change.
Repeat these operations for each frequency band, then select "OK"to apply all of your settings.
Activation/deactivation of the automatic volume adjustment (SDV) This function permits automatic adjustment of the volume in relation to the speed of the vehicle. Select the "SDV"function from the "Audio Setup"menu by turning knob H, then press this knob to confirm.
Turn knob Hto activate the function by selecting one of the settings between "Very low"and "Very high" or by selecting
"OFF" for deactivation.
When the selection has been made, press knob Hto confirm the change.
Balance/Fader adjustment Select the "Bal/Fader" function from the "Audio Setup"menu by turning knob H, then press this knob to confirm.
Select the "Balance" function by turning knob H, then press this knob to confirm.
Turn knob Hto distribute the sound between the right and the left.
Following adjustment, press knob Hto confirm the change.
Repeat these operations for the "Fader"function.
Select "OK"to apply the two settings.