Page 76 of 141
24-03-2003
REAR SEATS Rear seat with fold-down backs Before carrying out any operation, in order to prevent damage to theseat belts, place them in the loca-tions provided. The rear seat back folds down in two sections.To
fold down the seat back
The release controls are situated inthe boot. Pull the control corresponding to the part of the seat back that you wish tofold down. When returning the seat back to its original position, ensure that it islocked correctly to guarantee your
safety.
YOUR 406 COUPE IN DETAIL
96
Ski flap Lower the arm rest to access the ski flap.
Page 96 of 141
24-03-2003
The outside of the mirror on the driver's side is con-vex (area at edge definedby dotted line) in order toeliminate the 'blind spot'.
Objects observed in the driver'sand passenger's mirrors are in
reality closer than they appear. This must be taken into account to judge correctly the distance ofvehicles approaching from behind
EXTERIOR MIRRORS Electric rear view mirrors T urn knob 6to the right or to the left
to select the corresponding mirror.Move knob 6in all four directions to
adjust.When parked, the mirrors can be
folded back manually. Fold-back electric mirrors With the ignition on, turn knob 6to
position A.
P
ARTIALLY OPENING REAR
WINDOWS
To partially open the rear windows,
tilt the lever and push it fully to lock the windows in the open position.
YOUR 406 COUPE IN DETAIL 119
Page 103 of 141

24-03-2003
Sport and Snow programmes In addition to the autoadaptive programme, two special
programmes are available. Theindicator light corresponding to theprogramme selected lights up on theinstrument panel. Sport programme ☞Once the vehicle has been started and position Dselected, press the
S button.
The gearbox automatically favoursdynamic driving. Snow programme This programme makes starting
easier and offers smooth driving in
conditions when traction is poor. ☞ Once the vehicle has been started and position Dselected, press the
button.
The gearbox adapts to driving onslippery roads. Note : You can return to the
autoadaptive programme at any time. ☞ Press the Sor button again to
cancel the current programme. Operating anomalyAny disruption of the system is indicated by the alternate flashing ofthe sport and snow lights on theinstrument panel. In such a case, the gearbox will operate in downgrade mode (locked
in 3rd gear). You may feel asubstantial knock when reverse isselected from position
Por N(this
does not damage the gearbox). Do not exceed 60 mph (100 km/h), if regulations permit this.
Contact a PEUGEOT dealer without
delay.
DRIVING YOUR 406 COUPE
126
MANUAL GEARBOX Reverse*
To
change to reverse gear, lift the
ring under the gear lever knob and push the gear lever to the left then tothe front. Reverse gear can only be engaged when the vehicle is stationary withthe engine idling.
* According to engine.
Page 104 of 141

24-03-2003
Sport and Snow programmes In addition to the autoadaptive programme, two special
programmes are available. Theindicator light corresponding to theprogramme selected lights up on theinstrument panel. Sport programme ☞Once the vehicle has been started and position Dselected, press the
S button.
The gearbox automatically favoursdynamic driving. Snow programme This programme makes starting
easier and offers smooth driving in
conditions when traction is poor. ☞ Once the vehicle has been started and position Dselected, press the
button.
The gearbox adapts to driving onslippery roads. Note : You can return to the
autoadaptive programme at any time. ☞ Press the Sor button again to
cancel the current programme. Operating anomalyAny disruption of the system is indicated by the alternate flashing ofthe sport and snow lights on theinstrument panel. In such a case, the gearbox will operate in downgrade mode (locked
in 3rd gear). You may feel asubstantial knock when reverse isselected from position
Por N(this
does not damage the gearbox). Do not exceed 60 mph (100 km/h), if regulations permit this.
Contact a PEUGEOT dealer without
delay.
DRIVING YOUR 406 COUPE
126
MANUAL GEARBOX Reverse*
To
change to reverse gear, lift the
ring under the gear lever knob and push the gear lever to the left then tothe front. Reverse gear can only be engaged when the vehicle is stationary withthe engine idling.
* According to engine.
Page 105 of 141

24-03-2003
DRIVING YOUR 406 COUPE
128
Handbrake Applying When parking, pull the handbrake to immobilise your vehicle. Warning: when parking on a slope,
direct your wheels towards the pave- ment and apply the handbrake. Releasing Pull the handle and press the button to release the handbrake.
Disarming the ESP / ASR systems In certain conditions (vehicle stuck in
mud or snow, or on loose ground...),it could prove useful to disarm theASR system to make the wheelsspin and regain grip. ☞
Press the switch "ESP OFF",
situated to the left of the steering wheel.
The switch lights up and the indicatorlights come on, accompanied by themessage ''ASR/ESP de-activated''
on the multifunction display: the ESP
and ASR systems no longer affectthe operation of the engine or thebrakes. They engage again:☞ automatically when the ignition is
switched off,
☞ manually by pressing the switchagain. The ESP system offersincreased safety duringnormal driving, but shouldnot incite the driver to take
risks or to drive at high speed.The operation of the system isassured to the extent to which therecommendations of the manufac-turer regarding the wheels (tyresand wheel rims), the braking com-ponents, the electronic compo-nents and the assembly andrepair procedures within thePEUGEOT network are respect-ed.After an accident or impact, havethe system checked by a
PEUGEOT dealer.
Operating check When a system malfunctionoccurs, the switch lightflashes and the indicatorlight comes on.
Contact a PEUGEOT dealer tocheck the system.
TRACTION CONTROL (ASR)
AND DYNAMIC STABILITY
CONTROL (ESP) These systems are linked and com-
plement the ABS.
The ASR system optimises drive to prevent the wheels skidding, by act-ing on the brakes of the drive wheelsand on the engine. It also allows thedirectional stability of the vehicle tobe improved on acceleration. Ifthere is a variation between the tra-jectory followed by the vehicle and
that required by the driver, the ESPsystem automatically acts on theengine and the brake of one or morewheels, in order to put the vehicleback on course.
Operation of the ASR and ESP systems
When one of these two sys-tems is operating, this lightflashes.
Page 122 of 141

24-03-2003
MAINTENANCE OF YOUR 406 COUPE35
CHANGING A BULB
1 - Dipped beam headlamps
2 - Main beam headlamps T
wo bulbs (H7-55W) .
- Remove the red plastic cover.
- Press the tab and remove the protective cover corresponding to the faulty bulb.
- Disconnect the connector.
- Press the end of the securing clip to remove it. Change the bulb.
- When fitting, ensure that the direction notches are positioned correctly and that the securing clip is corrrectly fixed.
- Reconnect the connector.
- Replace the protective cover.
3 - Side lights (W 5 W) T urn the socket using the lever and remove it. Change the bulb.
4 - Direction indicators (P 21 W)T urn the bulb holder a quarter turn and remove it. Change the bulb.
Notes: only handle H7 bulbs using a dry cloth.
To replace the left-hand bulbs, remove the battery protective cover. Direction indicator repeater (W 5 W) -
Pull the rear section of the transpa- rent cover and release the assem-
bly.
-T urn the connector a quarter turn
and remove it.
- Change the bulb.
Amber bulbs must be replaced by bulbs of iden-tical specification and
colour.
In certain climatic conditions (lowtemperatures, humidity), the pre-
sence of condensation on theinside of the headlamp glass isnormal ; it disappears a few
minutes after the lights switch on.
Page 125 of 141

24-03-2003
The electrical system of your vehicle is designedto operate with standardor optional equipment.
Before installing other electricalequipment or accessories on yourvehicle, contact a PEUGEOT
dealer. Some electrical accessories or the way in which they are fitted canhave damaging effects on theoperation of your vehicle; theelectronic control circuits, theaudio circuit and the battery charging circuit. PEUGEOT will not accept respon- sibility for the cost incurred inrepairing your vehicle or for recti-fying malfunctions resulting fromthe installation of accessories notsupplied and not recommendedby PEUGEOT and not installed inaccordance with its instructions, inparticular where the equipment inquestion consumes more than 10 milliamperes.
MAINTENANCE OF YOUR 406 COUPE
40
Engine compartment fuses Fuse box
To
access the fuse box in the engine
compartment (beside the battery),
unclip the cover. Carefully close the cover when you have finished.
Fuse N° Rating Functions
1* 10 A Reversing lights - Double injection relay - Engine oil
temperature - Oil level - Air conditioning compressor.
2* 15 AFuel pump - Canister solenoid valve.
3* 10 A Control unit.
4* 10 A Engine control unit and automatic gearbox.
5 10 AParticulate emission filter control unit.
6 15 AFront fog lamps.
7 20 AHeadlamp wash.
8* 20 A Direct injection petrol engine control unit - Clutch pedal.
9* 15 A Left-hand dipped beam.
10* 15 A Right-hand dipped beam.
Page:
< prev 1-8 9-16 17-24