2003 Peugeot 307 CC sport mode

22-09-2003
11 7
Moving Off With the engine running, to move
off from position P:
 It is essential to press the
brake pedal to exit position P,
 Select the function R, D or M,
then gradually release thepressure on the brake pedal;
the vehicle will move off
immediately.
You can also move off fromposition N:
 Release the handbrake, withyour foot on the brake.
 Select function R, D or M,
then gradually release thepressure on the brake pedal;
the vehicle will move off
immediately.
When the engine is idlingwith the brakes notapplied, if function R, D
or Mis selected, the vehi-
cle moves without the acceleratorbeing pressed. For this reason, do not
leave children unsuper- vised inside the vehicle,with the engine running .
14
YOUR 307 CC AT A GLANCE
AUTOMATIC GEARBOX 'PORSCHE TIPTRONIC SYSTEM'
The four-speed
automaticgearbox offers a choice between the comfort
of automatic integral regulation enhanced by a sportand snow pro-
gramme , or the pleasure of manual gear changing .
Gear selection gate  Move the lever in the gate to select one of the functions.
Once the function is selected, the indicator light for that function is displayed on the instrument panel screen.
S:sport programme.


:snow programme.
P ark :to immobilise the vehicle or to start the
engine , with the handbrake on or off.
R everse :to reverse (select this function with the
vehicle stationary and the engine at idle). N eutral :to start the engine or to park, with the
handbrake on.Note: if position Nis engaged by mistake while
the car is moving, allow the engine to return to idling speed before engaging function Dto
accelerate. D rive :for automatic gear changing.
M anual :for manual gear changing.
To change the four gearsmanually:
 Push the lever to the +symbol to change up a gear and pull the lever
towards the Ðsymbol to change down a gear.
Note: the S(sport) and

(snow) programmes do not operate when in
manual mode.

INSTRUMENTS AND CONTROLS33
"SPORT" indicator light This comes on when the
"SPORT"programme on
the automatic gearbox is selected. "SNOW" indicator light This comes on when the "SNOW"programme on
the automatic gearbox is selected.
Operating fault This is displayed when an operating fault occurs, accompanied by the message "Automatic gear
fault" on the multi-function display, an audible signal
and flashing of the Sport and Snow indicator lightson the instrument panel.
Examples: "SPORT"programme and
Park position.
"SNOW" programme and
Drive position.
Park ReverseNeutral Drive
Manual mode: 1st gear engaged 2nd gear engaged3rd gear engaged 4th gear engaged
Selector lever positions on the automatic gearbox display
Automatic gearbox indicator lights
22-09-2003

22-09-2003
YOUR 307 CC IN DETAIL45
PTY function This allows you to listen to stations broadcasting a specific type of programme (news, culture, sport, rock etc.). With FMselected, press the "TA" button for more than two seconds to switch this function on or off.
To search for a PTYprogramme:
Ð select the PTYfunction,
Ð briefly press button Jor Lto scroll down the list of the various types of programmes offered.
Ð when the programme of your choice is displayed, keep button Jor Lpressed for more than
two seconds to carry out an automatic search (after an automatic search the PTYfunction is
switched off).
In PTY mode the different types of programmes can be stored in memory. To do this, press the preselection buttons "1" to "6"
for more than two seconds. Briefly press the corresponding button to recall the type of programme stored in the memory.
EON system
This connects stations which are part of the same network. It enables the broadcasting of traffic information or a PTYpro-
gramme by a station that is part of the same network as the station to which you are listening. This service is available when you have selected the TAtraffic information programme or the PTYfunction.

22-09-2003
YOUR 307 CC IN DETAIL57
PTY function This allows you to listen to stations broadcasting a specific type of programme (news, culture, sport, rock etc.) When FM is selected, press button "TA/PTY"for more than two seconds to switch the function on or off.
To find a PTYprogramme:
Ð select the PTYbutton,
Ð turn button Gto scroll down the different types of programmes offered, then confirm your choice,
Ð when the programme of your choice is displayed press button Mor Nto carry out an automatic
search (after an automatic search the PTYfunction is switched off if no station has been found).
In PTY mode the different types of programmes can be stored in the memory. To do this, press the preselection buttons "1"
to "6" for more than two seconds. To recall the type of programme stored in the memory, briefly press the corrresponding
button.
EON system
This system connects stations which are part of the same network. It enables the broadcast of traffic information or a PTY
programme, by a station that is part of the same network as the station to which you are listening. The service is available when you have selected the TAtraffic information programme or the PTYfunction.
Contextual menu The contextual menu allows you to access the following functions:Ð 'Inputting a frequency'Ð 'Display Radio text' to display information connected with the station being listened to.

22-09-2003
YOUR 307 CC IN DETAIL
78
The contextual menu associated with the
"Navigation - Guidance" applica-
tion appears as a superimposed display,when this is the application currently in
use in the main screen window.
This menu is limited to the followingfunctions:
Ð changing of the initial route (ente- ring of a diversion),
Ð switching to "Selection - Movement on map" mode*,
Ð storing of the current location (postal address if available or, if it is not, the GPS co-ordinates),
Ð changing of the route calculation criteria,
Ð stopping or resuming of guidance (displaying of the message whichchanges depending on the pre-vious status). General notes on the "Map" application* The
"Map" application has two dis-
play modes: Ð "Vehicle following on map" mode, representing active guid-ance on the map on the right and alarge-scale view of the next inter-section on the left,
Ð "Selection-Movement on map"mode, representing consultation ofthe map on the right and a com-pass on the left.
To switch from one mode to the
other, press the dial on the right
briefly, then select the "Move the
map" or "Exit map mode" function.
In "Selection-movement on map"
mode, you can see symbols, repre-senting the various types of serviceswhich exist, sorted by category:
Ð "Administration and safety" symbol on a grey background,
Ð "Hotels, bars and restaurants" symbol on a yellow background,
Ð "Other businesses" symbol on a purple background,
Ð "Culture, tourism and entertain- ment" symbol on a white back- ground,
Ð "Sports centres and open air cen- tres" symbol on a green back-ground,
Ð "Transporation and automobiles" symbol on a blue background.
"Navigation - Guidance" contextual menu A
"Zoom" function enables you to
enlarge the map, in accordance withthe eleven preset levels relating tothe following scales:
Ð 100 m/cm, 200 m/cm, 500 m/cm,
Ð 1 km/cm, 2 km/cm, 5 km/cm,
Ð 10 km/cm, 20 km/cm, 50 km/cm,
Ð 100 km/cm, 200 km/cm. This is achieved by turning the dial. This mode permits:
Ð displaying of the vehicle on the map with the route proposed by the navigation if the guidance isactive,
Ð zooming in on the map in accor- dance with the eleven preset levels,
Ð displaying of the "Navigation -
Guidance" contextual menu.
"Vehicle following on map" mode

22-09-2003
YOUR 307 CC IN DETAIL
78
The contextual menu associated with the
"Navigation - Guidance" applica-
tion appears as a superimposed display,when this is the application currently in
use in the main screen window.
This menu is limited to the followingfunctions:
Ð changing of the initial route (ente- ring of a diversion),
Ð switching to "Selection - Movement on map" mode*,
Ð storing of the current location (postal address if available or, if it is not, the GPS co-ordinates),
Ð changing of the route calculation criteria,
Ð stopping or resuming of guidance (displaying of the message whichchanges depending on the pre-vious status). General notes on the "Map" application* The
"Map" application has two dis-
play modes: Ð "Vehicle following on map" mode, representing active guid-ance on the map on the right and alarge-scale view of the next inter-section on the left,
Ð "Selection-Movement on map"mode, representing consultation ofthe map on the right and a com-pass on the left.
To switch from one mode to the
other, press the dial on the right
briefly, then select the "Move the
map" or "Exit map mode" function.
In "Selection-movement on map"
mode, you can see symbols, repre-senting the various types of serviceswhich exist, sorted by category:
Ð "Administration and safety" symbol on a grey background,
Ð "Hotels, bars and restaurants" symbol on a yellow background,
Ð "Other businesses" symbol on a purple background,
Ð "Culture, tourism and entertain- ment" symbol on a white back- ground,
Ð "Sports centres and open air cen- tres" symbol on a green back-ground,
Ð "Transporation and automobiles" symbol on a blue background.
"Navigation - Guidance" contextual menu A
"Zoom" function enables you to
enlarge the map, in accordance withthe eleven preset levels relating tothe following scales:
Ð 100 m/cm, 200 m/cm, 500 m/cm,
Ð 1 km/cm, 2 km/cm, 5 km/cm,
Ð 10 km/cm, 20 km/cm, 50 km/cm,
Ð 100 km/cm, 200 km/cm. This is achieved by turning the dial. This mode permits:
Ð displaying of the vehicle on the map with the route proposed by the navigation if the guidance isactive,
Ð zooming in on the map in accor- dance with the eleven preset levels,
Ð displaying of the "Navigation -
Guidance" contextual menu.
"Vehicle following on map" mode

YOUR 307 CC IN DETAIL117
S
: sport programme


: snow programme
P ark: to immobilise the vehicle or start the engine ,
with the handbrake on or off.
R everse: to reverse(select this function with the vehi-
cle stationary, engine at idle).
N eutral: to start the engine and to park, with the hand-
brake on. Note: if function Nis engaged inadvertently while dri-
ving, allow the engine to return to idle before engaging function Dto accelerate.
D rive: for drivingin automatic mode.
M anual: for drivingin manual mode. Moving off
With the engine running, to move off from position
P:
 it is essential to press the
brake pedal to exit position P,
 select function R, D or M, then
gradually release the pressureon the brake pedal; the vehicle
moves off immediately.
You can also move off from positionN :
 release the handbrake, with yourfoot on the brake,
 select function R, D or M, then
gradually release the pressureon the brake pedal; the vehicle
moves off immediately.
WARNING When the engine is at idle, brakes not applied, if function R, D or Mis
selected the vehicle moves evenwithout the accelerator beingpressed. For this reason, do not leave chil-
dren unsupervised inside the vehicle, with the engine running .
When maintenance operations needto be carried out with the engine run-ning, apply the handbrake and selectposition P.
"PORSCHE TIPTRONIC SYSTEM" AUTOMATIC GEARBOX The four speed automaticgearbox offers a choice between the comfort of inte-
gral automatic operation , enhanced by a sportand a snow programme, or the
pleasure of manual gear changing .
Gear selection gate  Move the lever in the gate to select a function. Once the function is selected, the corresponding indicator light appears on
the instrument panel display.
22-09-2003

22-09-2003
YOUR 307 CC IN DETAIL
118
Automatic operation Automatic changing of the
four
gears :
 select function Din the gate.
The gearbox always selects the most suitable gear according to the follow-ing parameters:
Ð the style of driving,
Ð the road profile,
Ð the vehicle load. The gearbox is then operating in auto-adaptive mode, without anyaction on your part.
WARNING Never select function Nwhen the
vehicle is moving. Never select functions Por Runless
the vehicle is stationary.Never change between functions to optimise braking on a slippery sur-face. Notes For immediate maximum acceleration
without touching the gear lever, pressthe accelerator pedal down as far as
it will go (kickdown). The gearbox willautomatically change down or main-tain the gear selected until maximumengine speed is reached. When braking, the gearbox will auto- matically change down in order to
provide efficient engine braking. If you take your foot off the accelera-
tor suddenly, the gearbox will notchange to a higher gear for reasons
of safety.
Sport and snow programme In addition to the auto-adaptive pro- gramme, there are two special pro-grammes. The programme is displayed on the instrument panel screen. Sport programme  Press button Sonce the vehicle
has been started and function D
selected.
The gearbox automatically favours sporty driving and more dynamicacceleration. Snow programme This programme improves starting
and drive when traction is poor.  Press button

once the vehicle
has been started and function D
selected.
The gearbox adapts to driving on slippery roads. Note: you can return to the auto-
adaptive programme at any time.  Press button Sor

again to
switch off the programme you are in. Manual operation Manual changing of the
four gears:
 select function Min the gate,
 push the lever to the +sign to
change to a higher gear,
 pull the lever to the Ðsign to
change to a lower gear.
You can change from position D(dri-
ving in automatic mode) to position M (driving in manual mode) at any
time. Note It is only possible to change from one gear to another if the vehicle speedand engine speed permit. If they donot, the vehicle will operate tem-porarily in automatic mode. When the vehicle is stationary or
moving very slowly, the gearboxautomatically selects gear M1.
Programme S(sport) and

(snow)
do not operate in manual mode.