2003 Peugeot 307 CC key battery

22-09-2003
YOUR 307 CC IN DETAIL93
Confidential card The confidential card contains the identification code necessary for anywork carried out by a PEUGEOTdealer on the electronic immobiliser
system. This code is hidden by afilm, which should be removed only
if necessary. Keep your card in a safe place, never inside the vehicle. Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition. Changing the battery of the remote control
Warning that the battery is flat is given by an audible signal accompa-nied by the message
''Remote con-
trol battery low'' on the multifunc-
tion display.
To replace the battery, remove the screw then unclip the casing using acoin at the ring (CR 2016/3 volt bat-tery). If the remote control does not work after the battery has been changed,reprogramme the remote control. Programming the remote control  Switch off the ignition.
 Switch the ignition on again.
 Press button Aimmediately.
 Switch off the ignition and remove the remote control key
from the ignition lock. The remotecontrol is now working again.
ELECTRONIC ENGINE IMMOBILISER This locks the engine control system as soon as the ignition has been
switched off and therefore preventsstarting of the vehicle by anyone
who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode must be recognised for startingto be possible. If the system does not function correctly , the central locking button
indicator light, situated in the centreof the fascia, flashes rapidly whenthe ignition is switched on (2ndnotch), accompanied by an audiblesignal and the message ''Anti-theft
device faulty'' on the multi-function
display. In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.

22-09-2003
YOUR 307 CC IN DETAIL93
Confidential card The confidential card contains the identification code necessary for anywork carried out by a PEUGEOTdealer on the electronic immobiliser
system. This code is hidden by afilm, which should be removed only
if necessary. Keep your card in a safe place, never inside the vehicle. Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition. Changing the battery of the remote control
Warning that the battery is flat is given by an audible signal accompa-nied by the message
''Remote con-
trol battery low'' on the multifunc-
tion display.
To replace the battery, remove the screw then unclip the casing using acoin at the ring (CR 2016/3 volt bat-tery). If the remote control does not work after the battery has been changed,reprogramme the remote control. Programming the remote control  Switch off the ignition.
 Switch the ignition on again.
 Press button Aimmediately.
 Switch off the ignition and remove the remote control key
from the ignition lock. The remotecontrol is now working again.
ELECTRONIC ENGINE IMMOBILISER This locks the engine control system as soon as the ignition has been
switched off and therefore preventsstarting of the vehicle by anyone
who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode must be recognised for startingto be possible. If the system does not function correctly , the central locking button
indicator light, situated in the centreof the fascia, flashes rapidly whenthe ignition is switched on (2ndnotch), accompanied by an audiblesignal and the message ''Anti-theft
device faulty'' on the multi-function
display. In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.

22-09-2003
YOUR 307 CC IN DETAIL
98
LOCKING/UNLOCKING WITH
A BATTERY FAILURE Driver's door Insert the key in the lock to lock or
unlock the door.Passenger's door
Ð to lock, insert the key in the lock
(located on the edge of the door) then turn an eighth of a turn to
the left.
Ð to unlock, use the interior door opening control (see correspond-ing section).
Boot
The boot is locked, contact a PEUGEOT
dealer.

22-09-2003
YOUR 307 CC IN DETAIL
110
EXTERIOR MIRRORS Electric rear view mirrors
Ð Slide switch Ato the right or to the
left to select the corresponding
mirror.
Ð Move knob Bin all four directions
to adjust.
Ð Return switch Ato the centre
position.
When parked, the mirrors can be folded back electrically by pullingknob Arearwards or automatically
when locking the vehicle.
The exterior mirrors are unfolded by switching on the ignition to the sec-ond notch or to the ON position.
Note: the function that controls fold-
ing of the mirrors when locking thevehicle can be disarmed. Contact a
PEUGEOT dealer.SIMULTANEOUS CONTROL
OF ALL 4 WINDOWS Control 6opens or closes all of the
windows simultaneously.
To disarm the action of control 6on
the rear windows, press the rear win- dows disarming control 5.
Operation of the simulta- neous control of all fourwindows is the sole
responsibility of the driver.
Always remove the key from the ignition whenleaving the vehicle, evenfor a short time.
In the event of contact duringoperation of the windows, youmust reverse the movement of the
window. To do this, press theswitch concerned. When the driver operates the pas- senger electric window switches,he must ensure that no one is preventing correct closing of thewindows. The driver must ensure that the passengers use the electric
windows correctly. Be aware of children when opera- ting the windows.
REINITIALISING THE ELECTRIC WINDOWS Following reconnection of the battery or in the event of a malfunction,release the switch and pull it again
until it closes completely. Hold theswitch for approximately one secondafter closing. The safety auto-reverse function is not active during these operations.

22-09-2003
PRACTICAL INFORMATION
142
CHANGING A WINDSCREEN WIPER BLADE Special front windscreen wiper position 
Within one minute of switching
off the ignition, operate thewipers stalk to position the wiperblades in the centre of the wind-screen (maintenance position).
Changing a wiper blade  Lift the wiper arm, then unclip the blade and remove it.
 Fit the new blade and push backthe arm.
Note: the shortest blade is fitted on
the vehicle's right-hand windscreenwiper arm.
To return the windscreen wipers to their normal position, switch onthe ignition and operate the wiperstalk. ECONOMY MODE FUNCTION After the engine has stopped, with the key in the accessories position,
certain functions (windscreen wiper,electric windows, courtesy lights,audio equipment etc.) can only beused for a cumulative duration ofthirty minutes, to prevent discharging
the battery.
Once the thirty minutes are over, the message
"Economy mode active"
appears on the multifunction displayand the active functions are put on
standby.
To resume the use of these functions
immediately, start the engine and letit run for a few seconds. LOAD REDUCTION FUNCTION When driving, certain functions (air conditioning, heated rear screen,
etc.) may be switched off temporari-
ly, depending on the level of batterycharge. Reactivation of these functions is automatic, once the battery charge is
sufficient. Note:
at the risk of discharging the
battery, the functions that have been
switched off may be reactivated
manually.
A flat battery will preventthe engine from starting.

PRACTICAL INFORMATION149
Manual closing of the roof (emergency mode) If the roof opening or closing cycle does not begin or does not function
correctly, check the following points: 
ignition key in position acces- sories or running position (1st or2nd notch),
 the screen must be pulled out,
 the boot must be closed,
 the vehicle speed must be below
6 mph (10 km/h),
 the roof fuse must be in good con-dition (see corresponding section),
 the windows must be initialised(see corresponding section),
 the battery voltage must be suffi-cient (the roof control button indi-cator light must be lit),
 the vehicle must not be subject to"Economy mode active" restric-
tions (see corresponding section),
 the exterior temperature must not
be below Ð20 ¡C.
When carrying out the roof closing operation, take carenot to catch your hands inthe mechanisms.
In the event of an electrical or hydraulic roof malfunction, it is
possible to close the roof manually.
Contact a PEUGEOT dealer to have the system checked. This possibility is a breakdown
solution.Following manual closing of the roof, the boot lid hinges will no longer belocked and the boot will no longer besealed.
Two people are required to carry out this operation. Considerable
force is necessary.  Park the vehicle, if possible on level ground.
 Lower the windows.
 Switch off the ignition.
 Apply the handbrake.
The following two tools are provided in the handbook pocket: Allen TM
key with 5 adaptor Aand
6 adaptor B,
 Torx TM
key with 20 adaptor Cand
30 adaptor D.
22-09-2003