2003 Peugeot 206 SW key

87
4YOUR 206 AT A GLANCE
26-05-2003
KEYS The keys enable you to switch on the ignition, independently operatethe locks on the front doors andthe tailgate (saloon) as well asoperating the passenger air bagdisarming switch and the fuelfiller flap. Central locking
From the driver's door, you can lock and unlock the doors andthe boot. If one of the doors, theboot (206 SW) or the rear screen(206 SW) is open, the centrallocking will not work.Remote control Press button
Ato remotely lock
the vehicle. This is confirmed by fixed lighting of the direction indicators forapproximately two seconds. Press button Bto remotely
unlock the vehicle.This is confirmed by rapid flashing of the direction indicators forapproximately two seconds.
206 SW: press and hold button B
to unlock the vehicle and open the rear screen. Key in ignition If you leave the key in the igni- tion, a buzzer reminds you of this
when opening the driver's door. Locating the vehicle
To locate your vehicle, when you have left it locked in a car park:  press button A, the courtesy
lights will switch on and the indicator lights flash for a fewseconds. STARTING The 4 positions of the key in the ignition:
STOP position:
The ignition is off.1
st
notch, Accessories posi-
tion: the ignition is off but the
accessories can be used.2 nd
notch, Running position:
the ignition is on.Starting position:
Operates the starter. Steering lock Before starting, unlock the steering
if necessary, by gently turningthe steering wheel at the same
time as you turn the key. It is advisable to press the clutch
pedal while operating the starter,
to make starting easier.

87
4YOUR 206 AT A GLANCE
26-05-2003
KEYS The keys enable you to switch on the ignition, independently operatethe locks on the front doors andthe tailgate (saloon) as well asoperating the passenger air bagdisarming switch and the fuelfiller flap. Central locking
From the driver's door, you can lock and unlock the doors andthe boot. If one of the doors, theboot (206 SW) or the rear screen(206 SW) is open, the centrallocking will not work.Remote control Press button
Ato remotely lock
the vehicle. This is confirmed by fixed lighting of the direction indicators forapproximately two seconds. Press button Bto remotely
unlock the vehicle.This is confirmed by rapid flashing of the direction indicators forapproximately two seconds.
206 SW: press and hold button B
to unlock the vehicle and open the rear screen. Key in ignition If you leave the key in the igni- tion, a buzzer reminds you of this
when opening the driver's door. Locating the vehicle
To locate your vehicle, when you have left it locked in a car park:  press button A, the courtesy
lights will switch on and the indicator lights flash for a fewseconds. STARTING The 4 positions of the key in the ignition:
STOP position:
The ignition is off.1
st
notch, Accessories posi-
tion: the ignition is off but the
accessories can be used.2 nd
notch, Running position:
the ignition is on.Starting position:
Operates the starter. Steering lock Before starting, unlock the steering
if necessary, by gently turningthe steering wheel at the same
time as you turn the key. It is advisable to press the clutch
pedal while operating the starter,
to make starting easier.

Precautions regarding the passenger air bag For a vehicle fitted with a disarm- ing switch:Ð disarm the airbag if youinstall a rear-facing childseat,
Ð arm the air bag for anadult passen-
ger.
For a vehicle not fitted with adisarming switch: Ð do not installa rear-facingchild seat onthe front pas-senger seat.
In no circumstances should youplace your feet or any otherobject on the fascia.
11 4
5YOUR 206 AT A GLANCE
26-05-2003
Never race a cold engine. Never run the engine in a confined space.
Do not make any modifications tothe steering lock.
Starting a petrol engine
Do not press the accelerator.
Operate the starter, without
releasing the key, until theengine turns.
Starting a dieselengineDo not press the acce-
lerator.
Turn the key to the ''Running''
position. If the engine is warm enough, the pre-heat light does not come
on and you can start immediately. If the pre-heat light comes on, wait for it to go out before operating the
starter. If the engine stalls, it is necessary to return the key to the ''STOP''
position before restarting. FRONT AIR BAGS
Operating check
* According to destination.
Disarming the passenger airbag* Insert the ignition key into switch 1and turn it to:
Ð the ONposition; the passenger
air bag is armed.
Ð the OFFposition; the passen-
ger air bag is disarmed.
With the ignition on (2 nd
notch of
the ignition), illumination of thiswarning light, accompanied byan audible signal and the mes-sage "Passenger air bag deac-
tivated" on the multifunction
display, indicates that the pas-senger air bag is disarmed(switch in the "OFF"position).
The warning light remains onthroughout the disarming process.

26-05-2003
Windscreen wipers Front2 Fast wipe
1 Normal wipe
I Intermittent wipe
or
AUTO Automatic wipe
0 Off


Single wipe
Wash-wipe: pull the stalk towards you. Rear
Off Intermittent Wash- wipe wipe
Automatic wipe In the AUTO position, the
windscreen wiper oper- ates automatically andadjusts its speed to theintensity of the rainfall .
Rear fog lamp
(ring B)
Rear fog lamp (rotation of the ringforwards)
Front fog lamps/Rear foglamp (ring C)
Front fog lamps (1 st
rotation of the ring
forwards).
Front fog lamps andrear fog lamp (2 nd
rotation of the ringforwards).
9395
8YOUR 206 AT A GLANCE
STEERING WHEEL CONTROLS Lights Front lights (ring A)
Lights off Side lights
Dipped/ main beamheadlamps Automatic switching on
of lights
Automatic switching on of lights
To activate or deactivate thefunction, place the key in theaccessories position with thelights stalk in position 0and
press the end of the stalk formore than four seconds.

Precautions regarding the passenger air bag For a vehicle fitted with a disarm- ing switch:Ð disarm the airbag if youinstall a rear-facing childseat,
Ð arm the air bag for anadult passen-
ger.
For a vehicle not fitted with adisarming switch: Ð do not installa rear-facingchild seat onthe front pas-senger seat.
In no circumstances should youplace your feet or any otherobject on the fascia.
11 4
5YOUR 206 AT A GLANCE
26-05-2003
Never race a cold engine. Never run the engine in a confined space.
Do not make any modifications tothe steering lock.
Starting a petrol engine
Do not press the accelerator.
Operate the starter, without
releasing the key, until theengine turns.
Starting a dieselengineDo not press the acce-
lerator.
Turn the key to the ''Running''
position. If the engine is warm enough, the pre-heat light does not come
on and you can start immediately. If the pre-heat light comes on, wait for it to go out before operating the
starter. If the engine stalls, it is necessary to return the key to the ''STOP''
position before restarting. FRONT AIR BAGS
Operating check
* According to destination.
Disarming the passenger airbag* Insert the ignition key into switch 1and turn it to:
Ð the ONposition; the passenger
air bag is armed.
Ð the OFFposition; the passen-
ger air bag is disarmed.
With the ignition on (2 nd
notch of
the ignition), illumination of thiswarning light, accompanied byan audible signal and the mes-sage "Passenger air bag deac-
tivated" on the multifunction
display, indicates that the pas-senger air bag is disarmed(switch in the "OFF"position).
The warning light remains onthroughout the disarming process.

26-05-2003
TYPES OF SERVICE Each vehicle has its own servicing cycle, based upon the engine type.
This cycle consists of alternating two types of service, A and C, intermediate visits and a few additional operations depend- ing on your vehicle; these correspond to key stages in the life of your vehicle. When the first service is carried out and at each subsequent service, your dealer will advise you of the type and content of the next service due.
PEUGEOT SERVICING
22
THE MAINTENANCE CYCLE FOR YOUR SALOON and 206 SW PETROL
Service every 20,000 miles (30,000 km) or 2 years.
1st service at
6,000 miles (10,000 km) or 6 months*.
This is necessary
in order to benefit from the warranty
These services are to be carried with at least 10W40 synthetic based oil.
They can also be carried out with 5W30 Fuel Economy oilor with 5W40 synthetic oil .
Arduous conditions of use (see corresponding section).
* Whichever comes first.
Intermediate top-up visit included in the Servicing Schedule.
MILES (KM) 20,000 (30,000) 40,000 (60,000) 60,000 (90,000)
80,000 (120,000) 100,000 (150,000) 120,000 (180,000) 140,000 (210,000) 160,000 (240,000)

26-05-2003
TYPES OF SERVICE Each vehicle has its own servicing cycle, based upon the engine type.
This cycle consists of alternating two types of service, A and C, intermediate visits and a few additional operations depend- ing on your vehicle; these correspond to key stages in the life of your vehicle. When the first service is carried out and at each subsequent service, your dealer will advise you of the type and content of the next service due.
PEUGEOT SERVICING
22
THE MAINTENANCE CYCLE FOR YOUR SALOON and 206 SW PETROL
Service every 20,000 miles (30,000 km) or 2 years.
1st service at
6,000 miles (10,000 km) or 6 months*.
This is necessary
in order to benefit from the warranty
These services are to be carried with at least 10W40 synthetic based oil.
They can also be carried out with 5W30 Fuel Economy oilor with 5W40 synthetic oil .
Arduous conditions of use (see corresponding section).
* Whichever comes first.
Intermediate top-up visit included in the Servicing Schedule.
MILES (KM) 20,000 (30,000) 40,000 (60,000) 60,000 (90,000)
80,000 (120,000) 100,000 (150,000) 120,000 (180,000) 140,000 (210,000) 160,000 (240,000)

26-05-2003
GENERAL FUNCTIONSOn/off With the ignition key in the accessories or ignition position, press button Ato switch the audio system on
or off. The audio system can operate for 30 minutes without the vehicle ignition being switched on.
Anti-theft system The audio system is coded in such a way that it can operate only on your vehicle. It would not function if fitted to another vehicle The anti-theft system is automatic and requires no action on your part. ADJUSTING THE VOLUME Press button Cto increase the volume, or button Bto decrease it.
Continuous pressure on buttons Cand Ballows a gradual adjustment of the volume.
AUDIO SETTINGS Press button Hseveral times in succession to access the bass (BASS), treble (TREB), loudness (LOUD),
fader (FAD) , balance (BAL)and automatic volume correction settings.
Exit from audio mode is automatic after a few seconds without pressing any button, or by pressing button H
after configuration of the automatic volume correction. Note: bass and treble settings are specific to each source. It is possible to set them differently for radio, cassette
(RB3) , CD (RD3) and CD changer.
YOUR 206 IN DETAIL
46