Page 34 of 135
30-06-2003
YOUR 206 CC IN DETAIL
34
AUDIO RD3
Stalk movementFunction
1 - Press (behind) Increase volume
2 - Press (behind) Decrease volume
1 + 2 - Simultaneous press Sound cut-off (mute); restoring of the sound by pressing any button
3 - Press Automatic search of higher frequencies (radio)
Selection of the next track (CD)
4 - Press Automatic search of lower frequencies (radio)
Selection of the previous track (CD)
5 - Press the end Change of source (radio/CD/CD changer)
6 - Rotation Selection of next station stored in memory (radio)
(clockwise) Selection of following CD
7 - Rotation Selection of previous station stored in memory (radio)
(anti-clockwise) Selection of previous CD
Page 74 of 135

30-06-2003
Deadlocking Deadlocking of the doors is an additional security device. It disables the exterior and interior door controls. There are two methods of deadlocking :
- with the ignition key, from the driver's door;
- with the remote control, which has two buttons :A. deadlocking/locking of the doors and boot lid.
B. unlocking.
Using the ignition key Deadlocking , turn the key towards the rear of the vehicle.
Locking , within 5 seconds of deadlocking, turn the key again towards the rear
of the vehicle.Unlocking , turn the key towards the front of the vehicle. Using the remote controlDeadlocking
, press button Aonce
to deadlock the vehicle.This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds.
Press button A again within
5 seconds of deadlocking; this changes deadlocking to normal loc-
king. This is confirmed by fixed ligh-ting of the direction indicators forapproximately two seconds. Unlocking Press button Bto unlock the vehicle.
This is confirmed by the rapid fla- shing of the direction indicators.
To unlock the boot lid Place the ignition key in the boot lock and turn it anti-clockwise.
SPECIAL FEATURES
128
Page 107 of 135

30-06-2003
PRACTICAL INFORMATION
100
PUNCTURES Because this version does not pos- sess a spare wheel, you have twoaerosols for temporary tyre repairsstored in an insulated storage box
1
secured by a strap to the right-handside of the boot. Using a repair aerosol (See also the instructions on the aerosols).
If possible remove the foreign body which caused the puncture.
Position the wheel so that thevalve is at the 2 o'clock or 10o'clock position.
Shake the aerosol vigorously
before use. (In very cold weather,warm the aerosol for a few min-utes in your hands).
In one hand hold the valve.
With the other, firmly push thespray end of the aerosol onto thevalve, keeping it centralised.
Maintain the pressure firmly forone minute, then immediatelydrive at moderate speed to the
nearest garage. Aersosols enable a tem-porary repair to be car-ried out (maximum speed50 mph (80 km/h)).
After use, it is necessary toreplace the tyre. Because the aerosols are pres- surised, they must not be exposedto a temperature higher than
50 ¡C. Keep them away from heat in their insulated storage box.