Page 5 of 229

ENGINE CONTROL SYSTEM
SECTION
EC
CONTENTS
PRECAUTIONS AND PREPARATION............... 4002
Supplemental Restraint System (SRS) ``AIR
BAG'' and ``SEAT BELT PRE-TENSIONER'' .. 4002
KA24DE
TROUBLE DIAGNOSIS FOR
NON-DETECTABLE ITEMS................................ 4003
Electrical Load Signal ...................................... 4003
IACV-FICD Solenoid Valve .............................. 4005
KA24DE (EURO OBD)
ENGINE AND EMISSION CONTROL OVERALL
SYSTEM...............................................................4006
Circuit Diagram ................................................ 4006IACV-FICD SOLENOID VALVE.......................... 4007
Wiring Diagram ................................................ 4007
Diagnostic Procedure....................................... 4009
YD25DDTi
ENGINE AND EMISSION CONTROL OVERALL
SYSTEM...............................................................4013
Circuit Diagram ................................................ 4013
DTC 0208 OVER HEAT....................................... 4014
Wiring Diagram ................................................ 4014
GLOW CONTROL SYSTEM............................... 4015
Wiring Diagram ................................................ 4015
AIR CONDITIONER CONTROL.......................... 4016
Wiring Diagram ................................................ 4016
When you read wiring diagrams:
lRead GI section, ªHOW TO READ WIRING DIAGRAMSº.
lSee EL section, ªPOWER SUPPLY ROUTINGº for power distribution circuit.
When you perform trouble diagnoses, read GI section, ªHOW TO FOLLOW FLOW CHART IN
TROUBLE DIAGNOSESº and ªHOW TO PERFORM EFFICIENT DIAGNOSIS FOR AN ELECTRICAL
INCIDENTº.
EC
Page 6 of 229

Supplemental Restraint System (SRS) ªAIR
BAGº and ªSEAT BELT PRE-TENSIONERº
The Supplemental Restraint System such as ªAIR BAGº and ªSEAT BELT PRE-TENSIONERº used along
with a seat belt, helps to reduce the risk or severity of injury to the driver and front passenger in a frontal
collision. The SRS system composition which is available to NISSAN MODEL D22 is as follows (The com-
position varies according to the destination and optional equipment.):
Driver air bag module (located in the center of the steering wheel), front passenger air bag module (located
on the instrument panel on passenger side), seat belt pre-tensioner, a diagnosis sensor unit, warning lamp,
wiring harness and spiral cable.
Information necessary to service the system safely is included in theRS sectionof this Service Manual.
WARNING:
lTo avoid rendering the SRS inoperative, which could increase the risk of personal injury or death
in the event of a collision which would result in air bag inflation, all maintenance must be per-
formed by an authorized NISSAN dealer.
lImproper maintenance, including incorrect removal and installation of the SRS, can lead to per-
sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and
Air Bag Module, see the RS section.
lDo not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. Spiral Cable and wiring harnesses (except ªSEAT BELT PRE-TENSIONERº) cov-
ered with yellow insulation either just before the harness connectors or for the complete harness
are related to the SRS.
PRECAUTIONS AND PREPARATION
EC-4002
Page 11 of 229
Wiring Diagram
MODEL WITH MANUAL AIR CONDITIONER
GEC389A
IACV-FICD SOLENOID VALVEKA24DE (EURO OBD)
EC-4007
Page 12 of 229
MODEL WITH AUTO AIR CONDITIONER
GEC390A
IACV-FICD SOLENOID VALVEKA24DE (EURO OBD)
Wiring Diagram (Cont'd)
EC-4008
Page 18 of 229
Wiring Diagram
GEC354A
DTC 0208 OVER HEATYD25DDTi
EC-4014
Page 19 of 229
Wiring Diagram
GEC385A
GLOW CONTROL SYSTEMYD25DDTi
EC-4015
Page 20 of 229
Wiring Diagram
GEC383A
AIR CONDITIONER CONTROLYD25DDTi
EC-4016
Page 21 of 229
GEC384A
AIR CONDITIONER CONTROLYD25DDTi
Wiring Diagram (Cont'd)
EC-4017