After the hitch is removed, seal the
bolt holes to prevent exhaust fumes,
water or dust from entering the pas-
senger compartment.
Regularly check all hitch mounting
bolts are securely mounted.
To reduce the possibility of addi-
tional damage if your vehicle is
struck from the rear, where practical,
remove the hitch and/or receiver
when not in use.
Never connect a trailer brake system
directly to the vehicle brake system.Tire pressuresWhen towing a trailer, inflate the vehicle tires
to the recommended cold tire pressure indi-
cated on the tire placard (affixed to the glove
box lid).
Trailer tire condition, size, load rating and
proper inflation pressure should be in accor-
dance with the trailer and tire manufacturers’
specifications.Safety chains
Always use a suitable chain between your ve-
hicle and the trailer. The chain should be
crossed and should be attached to the hitch, not
to the vehicle bumper or axle. Be sure to leave
enough slack in the chain to permit turning
corners.Trailer lightsTrailer lights should comply with Federal and/or
local regulations.
When wiring vehicle for towing connection,
connect stop and tail light pickup into the
vehicle electrical circuit at point between
the sensor and stop light switch or light
switch.Trailer brakesIf your trailer is equipped with a braking system,
make sure it conforms to Federal and/or local
regulations and that it is properly installed.
WARNING
Never connect a trailer brake system
directly to the vehicle brake system.Trailer towing tipsIn order to gain skill and an understanding of thevehicle’s behavior, you should practice turning,
stopping and backing up in an area which is free
from traffic. Steering stability and braking perfor-
mance will be somewhat different than under
normal driving conditions.
Always secure items in the trailer to prevent
load shift while driving.
Avoid abrupt starts, acceleration or stops.
Avoid sharp turns or lane changes.
Always drive your vehicle at a moderate
speed.
Always block the wheels on both vehicle and
trailer when parking. Parking on a slope is not
recommended; however, if you must do so,
and if your vehicle is equipped with automatic
transmission, first block the wheels and apply
the parking brake, and then move the trans-
mission selector lever into the P position. If
you move the selector lever to the P position
before blocking the wheels and applying the
parking brake, transmission damage could
occur.
When going down a hill, shift into a lower
gear and use the engine braking effect.
When ascending a long grade, downshift the
transmission to a lower gear and reduce
speed to reduce chances of engine overload-
ing and/or overheating.
9-20
Technical and consumer information
03.1.28/R50-D/V5
ment, toll-free, at 1-800-NISSAN-1.
In Hawaii call (808) 836-0888.
Due to legal requirements in some states/
areas, your vehicle may be required to be in what
is called the ready condition for an
Inspection/Maintenance (I/M) test of the emis-
sion control system.
The vehicle is set to the ready condition when it
is driven through certain driving patterns. Usu-
ally, the ready condition can be obtained by
ordinary usage of the vehicle.
If a powertrain system component is repaired or
the battery is disconnected, the vehicle may be
reset to a not ready condition. Before taking the
I/M test, drive the vehicle through the following
pattern to set the vehicle to the ready condition.
If you cannot or do not want to perform the
driving pattern, a NISSAN dealer can conduct it
for you.
WARNING
Always drive the vehicle in a safe and
prudent manner according to traffic
conditions, and obey all traffic laws.
1. Start the engine. Allow the engine to idle until
the engine coolant temperature gauge needle
points between the C and H (normal operat-
ing temperature).2. Accelerate the vehicle to 55 MPH (88 km/h),
then quickly release the accelerator pedal
completely and keep it released for at least 6
seconds.
3. Quickly depress the accelerator pedal for a
moment, then drive the vehicle at a speed of
53 to 60 MPH (86 to 96 km/h) for at least 5
minutes.
4. Stop the vehicle. Leave the engine running.
5. Accelerate the vehicle to 35 MPH (55 km/h)
and maintain the speed for 20 seconds.
6. Repeat steps 4 and 5 at least 3 times.
7. Accelerate the vehicle to 55 MPH (88 km/h)
and maintain the speed for at least 3 minutes.
8. Stop the vehicle. Place the transmission gear
shift lever in the “P” or “N” position.
9. Turn the engine off.
10.Repeat steps 1 through 8 at least one more
time.
If step 1 through 7 is interrupted, repeat the
preceding step. Any safe driving mode is ac-
ceptable between steps. Do not stop the engine
until step 7 is completed.READINESS FOR INSPECTION/
MAINTENANCE (I/M) TEST (US
only)
Technical and consumer information
9-23
03.1.28/R50-D/V5
Front window open/close with key ......................... 3-3
Fuel
Capacities and recommended fuel/
lubricants ................................................................. 9-2
filler cap................................................................. 3-13
filler lid ................................................................... 3-13
Fuel economy ...................................................... 5-20
Fuel octane rating ................................................. 9-4
Fuel recommendation ........................................... 9-4
Gauge ...................................................................... 2-5
Fuses ............................................................................ 8-27
Fusible links ................................................................ 8-27
G
Garage door opener, HomeLink
Universal
Transceiver .................................................................. 2-44
Gas cap ....................................................................... 3-13
Gauge ............................................................................. 2-3
Engine coolant temperature gauge .................. 2-4
Fuel gauge .............................................................. 2-5
Odometer ................................................................ 2-3
Speedometer .......................................................... 2-3
Tachometer ............................................................. 2-4
General maintenance .................................................. 8-2
Glass hatch and outside mirror defogger
switch ........................................................................... 2-20
Glass hatch lock........................................................ 3-11
Glass hatch opener .................................................. 3-11
Glove box .................................................................... 2-32
Glove box lock ........................................................... 2-32H
Hazard warning flasher switch............................... 2-25
Head restraints ............................................................. 1-9
Headlights
Bulbreplacement ............................................... 8-31
Headlight switch ................................................. 2-21
Heated seats .............................................................. 2-26
Heater
Engine coolant heater ....................................... 5-39
Heater and air conditioner controls.................. 4-2
Heater operation.................................................... 4-4
Heater and air conditioner (Automatic — Type A)
(if so equipped) ..................................................... 4-8
Heater and air conditioner (Automatic — Type B)
(if so equipped) ................................................... 4-10
HomeLink
Universal Transceiver ......................... 2-44
Hood, release ............................................................... 3-9
Hook, Luggage hook ................................................ 2-34
Horn .............................................................................. 2-25
How to stop alarm, Vehicle security .................... 2-17
I
Ignition switch ............................................................... 5-7
Automatic transmission models ............. 5-7, 5-11
Key positions .......................................................... 5-9
Manual transmission models .................. 5-8, 5-15
Immobilizer system .................................................... 2-18
Indicator lights............................................................ 2-14
Inside mirror ................................................................ 3-16
Inspection/maintenance (I/M) test ........................ 9-23
Instrument panel........................................................... 2-2Interior lights ............................................................... 2-42
J
Jump starting................................................................. 6-9
K
Keyless entry (See remote keyless entry
system) ........................................................................... 3-5
Keys................................................................................. 3-2
L
Label, Air conditioner specification label ............ 9-14
Label, Emission control information label............ 9-14
Label, F.M.V.S.S. certification label ...................... 9-13
Labels
Air bag warning labels ...................................... 1-21
Engine serial number ......................................... 9-13
Vehicle identification number (VIN)................ 9-12
LATCH (Lower Anchors and Tether For Children)
system (if so equipped) ........................................... 1-41
Light
Air bag warning light ......................................... 1-21
Bulbreplacement ............................................... 8-30
Fog light switch................................................... 2-24
Front fog light switch......................................... 2-24
Headlight switch ................................................. 2-21
Headlights Bulbreplacement .......................... 8-31
Interior lights ........................................................ 2-42
Personal lights ..................................................... 2-43
Replacement ........................................................ 8-30
03.1.28/R50-D/V5
10-3