2003 NISSAN MURANO driver seat adjustment
[x] Cancel search: driver seat adjustmentPage 8 of 265
Forward and backwardPull the lever up while you slide the seat forward
or backward to the desired position. Release the
lever to lock the seat in position.
RecliningTo recline the seatback, pull the lever up and
lean back. To bring the seatback forward again,
pull the lever and move your body forward. The
seatback moves forward.
FRONT POWER SEAT
ADJUSTMENT
WARNING
Do not adjust the driver’s seat while
driving so full attention may be given
to vehicle operation.
Do not leave children unattended in-
side the vehicle. They could unknow-
ingly activate switches or controls.
Unattended children could become
involved in serious accidents.Operating tipsThe seat motor has an auto-reset overload
protection circuit. If the motor stops during
operation, wait 30 seconds, then reactivate
the switch.
Do not operate the power support seat
for a long period of time when the engine is
off. This will discharge the battery.
See “Automatic drive positioner” in the “3. Pre-
driving checks and adjustments” for automatic
seat positioner operation.
SSS0179Seats, restraints and supplemental air bag systems
1-3
03.1.28/Z50-D/V5.0
Page 10 of 265
Lumbar support (if so equipped for
driver’s seat)The lumbar support feature provides lower back
support to the driver. Move the lever up or down
to adjust the seat lumbar area.
REAR SEAT ADJUSTMENT
Folding1. Secure the seat belt at the belt hooks on the
side wall. See “Seat belt hook” later in this
section.
2. Secure the center seat belt and tongues into
the retractor base. See “Stowing rear center
seat belt” later in this section.
3. Put the seat belt buckles into the seat cush-
ion.
See “Storing rear seat belt buckles” later in
this section.4. Remove the head restraints.
5. After removing the tonneau cover (if so
equipped) from each rear seatback, pull the
strap on the rear seat
Aor pull the lever
B
beside the cargo area and fold the seatback.
6. When returning the seatbacks, be sure to
install the head restraints and attach the rear
center seat belt connector.
WARNING
Never allow anyone to ride in the
cargo area or on the rear seat when it
is in the fold-down position. Use of
these areas by passengers without
proper restraints could result in seri-
ous injury in an accident or sudden
stop.
It is extremely dangerous to ride in a
cargo area inside of a vehicle. In a
collision, people riding in these areas
are more likely to be seriously in-
jured or killed.
Do not allow people to ride in any
area of your vehicle that is not
equipped with seats and seat belts.
SPA0467
SSS0226Seats, restraints and supplemental air bag systems
1-5
03.1.28/Z50-D/V5.0
Page 113 of 265
ignition switch is in the ACC or ON position.
Move the switch to right
A
or left
B
to select
the right or left outside mirror, then adjust the
mirror to the desired position by pushing the
button
C.
Foldable outside mirrorsPush the outside mirror backward to fold it.
AUTOMATIC DRIVE POSITIONER
OPERATIONThis system is designed so that the driver’s seat,
outside mirror and pedals (Brake, Accelerator)
will automatically move when the selector lever is
in the P (Park) position. This allows the driver to
get in and out of the driver’s seat more easily.
When one of the following conditions is met, the
driver’s seat will slide backward while the selec-
tor lever is in the P (Park) position:
When the key is removed from the ignition
switch.
When the driver’s door is opened with the
key turned to LOCK.
When the key is turned from ACC to LOCK
with the driver’s door open.
When one of the following conditions is met
while the selector lever is in the P (Park) position,
the driver’s seat will return to the positions
before being set.
When the key is inserted into the ignition
switch.
When the driver’s door is closed with the key
turned to LOCK.
When the key is turned from ACC to ON.
MPA0008
AUTOMATIC DRIVE POSITIONER
(if so equipped)
3-16
Pre-driving checks and adjustments
03.1.28/Z50-D/V5.0
Page 114 of 265
PROCEDURE FOR STORING
MEMORYTwo positions can be stored in the automatic
drive positioner memory.Follow these proce-
dures to use the memory system.
1. Set the selector lever to the P (Park)
position.
2. Turn the ignition ON.
3. Adjust the driver’s seat, outside mirrors and
pedals to the desired positions by manually
operating each adjusting switch. For addi-
tional information, see “Seats” in the “1.
Seats, restraints and supplemental air bag
systems” section and “Pedal position adjust-
ment” earlier in this section.
During this step, do not turn the ignition to
any positions other than ON.
4. Push the SET switch and, within 5 seconds,push the memory switch 1 or 2 fully for at
least 1 second.
The indicator light for the pushed memory
switch will come on and stay on for approxi-
mately 5 seconds after pushing the switch.
After the indicator light goes off, the selected
positions are stored in the selected memory
(1 or 2). Pushing the unlock button on the
keyfobwithin this 5 seconds, will link the
selected memory to the keyfob.
When the link is completed, the indicator light
of the selected memory switch will blink for
approximately 5 seconds.
When you unlock the door with the link
completed keyfob, the driver’s seat will move
back and move to the memorized position.
If memory is stored in the same memory
switch, the previous memory and the memory
which is linked to the keyfob, will be deleted.
Confirming memory storageTurn the ignition ON and push the SET
switch. If the main memory has not been
stored, the indicator light will come on for
approximately 0.5 seconds. When the
memory has stored the position, the indicator
light will stay on for approximately 5 seconds.
If the battery cable is disconnected, or if the
SPA1584
Pre-driving checks and adjustments
3-17
03.1.28/Z50-D/V5.0
Page 115 of 265
fuse blows, the memory will be canceled. In
such a case, reset the desired positions
using the following procedures.
1. Open and close the driver’s door more than
two times with the ignition key in the LOCK
position.
2. Reset the desired position using the previous
procedure.
Selecting the memorized position1. Set the selector lever to the P (Park) position.
2. Turn the ignition ON.
3. Push the memory switch 1 or 2 fully for at
least 1 second.
The driver’s seat, pedals and outside mirror
will move to the memorized position with the
indicator light flashing. Then the light will stay
on for approximately 5 seconds.Cancellation of the systemThe automatic drive positioner system can be
canceled.
See “4. Display screen, heater, air conditioner
and audio systems” section.System operationThe automatic drive positioner system will notwork or will stop operating under the following
conditions:
when the vehicle speed is above 4 MPH (7
km/h).
when either of the memory switches is
pressed while the automatic drive positioner
is operating.
when the adjusting switch for the driver’s
seat, pedal or outside mirror is turned on
while the automatic drive positioner is oper-
ating.
when the memory switch 1 or 2 is not pushed
for at least 1 second.
when the seat, pedal and outside mirror has
already been moved to the memorized posi-
tion.
when no seat position is stored in the
memory switch.3-18
Pre-driving checks and adjustments
03.1.28/Z50-D/V5.0
Page 262 of 265
S
Safety
Child seat belts ................................................... 1-24
Reporting safety defects (US only)................ 9-22
Towing safety....................................................... 9-18
Seat
Belt warning light................................................ 1-22
Belt warning light and chime ........................... 2-11
Seat adjustment
Front manual seat adjustment............................ 1-2
Front power seat adjustment ............................. 1-3
Rear seat adjustment ........................................... 1-5
Seat belt(s)
Child safety .......................................................... 1-24
Infants and small children ................................. 1-24
Injured persons.................................................... 1-25
Larger children .................................................... 1-25
Pre-tensioner seat belt system ....................... 1-19
Precautions on seat belt usage ...................... 1-22
Pregnant women ................................................. 1-25
Rear center seat belt ......................................... 1-29
Seat belt cleaning ................................................. 7-4
Seat belt extenders ............................................ 1-31
Seat belt hooks ................................................... 1-28
Seat belt maintenance ...................................... 1-32
Seat belts ............................................................. 1-22
Three-point type with retractor ....................... 1-25
Seat(s)
Driver-side memory ............................................ 3-16
Heated seats........................................................ 2-25
Seats ........................................................................ 1-2
Security system, vehicle security system ............ 2-15Security systems (Nissan Vehicle Immobilizer
System), Engine start ............................................... 2-16
Security systems (See vehicle security
system) ......................................................................... 2-15
Servicing air conditioner .............................. 4-15, 4-18
Shifting, CVT (Continuously Variable
Transmission) ............................................................. 5-10
Shift lock release ....................................................... 5-13
Shoulder belt height adjustment, Except for rear
center seat .................................................................. 1-28
Side air bag system (See supplemental side air bag
and curtain side-impact air bag system)............. 1-17
Spark plugs................................................................. 8-16
Speedometer ................................................................ 2-4
Starting
Before starting the engine .................................. 5-9
Jump starting .......................................................... 6-8
Precautions when starting and driving ............ 5-2
Push starting ........................................................ 6-10
Starting the engine............................................. 5-10
Steering
Power steering fluid ........................................... 8-12
Power steering system ...................................... 5-21
Steering switch for audio system ................... 4-30
Tilting steering wheel......................................... 3-13
Storage ........................................................................ 2-28
Sun shade ................................................................... 2-36
Sun visors ................................................................... 3-14
Sunroof ........................................................................ 2-35
Supplemental air bag warning labels................... 1-20
Supplemental air bag warning light .......... 1-20, 2-12
Supplemental front air bag system....................... 1-15
Supplemental side air bag and curtain side-impact
air bag systems.......................................................... 1-17Supplemental restraint system ................................. 1-9
Precautions on supplemental restraint
system ...................................................................... 1-9
Switch
Autolight switch .................................................. 2-21
AWD lock switch operations........................... 5-18
Fog light switch................................................... 2-24
Hazard warning flasher switch ........................ 2-24
Headlight aiming control switch ..................... 2-22
Headlight switch ................................................. 2-20
Ignition switch ........................................................ 5-8
Power door lock switch....................................... 3-4
Rear window and outside mirror defroster
switch..................................................................... 2-19
Turn signal switch .............................................. 2-24
Vehicle dynamic control (VDC) off switch ... 2-26
T
Tachometer.................................................................... 2-4
Temperature gauge, Engine coolant temperature
gauge .............................................................................. 2-5
Theft (Nissan Vehicle Immobilizer System), Engine
start ............................................................................... 2-16
Three way catalyst ....................................................... 5-3
Tilting steering wheel ............................................... 3-13
Tire
Flat tire ..................................................................... 6-2
Uniform tire quality grading .............................. 9-21
Tire pressure, Low tire pressure warning
light ............................................................................... 2-12
Tires
Low tire pressure warning system .................... 5-3
Spare tire .............................................................. 8-32
03.1.28/Z50-D/V5.0
10-5