2003 MITSUBISHI SHOGUN brake light

H04F071A
LHDCooling
(Vehicles with air conditioning)
EH04FOH
Set the mode selection dial to the“
”
position.
Set the air selection switch (A) to the out-
side position and push the air condition-
ing switch (B).
Adjust the temperature by turning the tem-
perature control dial clockwise or anticlock-
wise. Select the desired blower speed.
H04F078A
RHDNOTE
If the outside air is dusty or otherwise con-
taminated, or if high cooling performance
is desired, set air selection switch to the
recirculation position and the tempera-
ture control dial all the way to the left.
Switch to the outside position periodically
to increase ventilation so that the win-
dows do not become fogged up.
CAUTION
When using the air conditioning, the
idling speed may slightly increase as
the air conditioning compressor is
switched on/off automatically. Espe-
cially for vehicles with an auto-
matic transmission, while the vehicle
is stationary, fully depress the brake
pedal to prevent the vehicle from
creeping.
For pleasant driving
6-42Div:
Out put date:

H14A059A
Front automatic air
conditioning*
EH14AOH
By setting the blower speed selection dial
and mode selection dial to the“AUT”
(AUTO) position and select the desired
temperature, the air conditioning oper-
ates to cool or warm automatically in order
to maintain the selected temperature. To
stop the air conditioning, set the blower
speed selection dial to the“
”(OFF)
position.
You can also operate it manually if neces-
sary.
The air conditioning can only be oper-
ated while the engine is running.
CAUTION
When using the air conditioning, the
idling speed may slightly increase as
the air conditioning compressor is
switch on/off automatically. Espe-
cially for vehicles with an auto-
matic transmission, while the vehicle
is stationary, fully depress the brake
pedal to prevent the vehicle from
creeping.
H14B104A
NOTE
(1) There is a photo sensor, and interior air
temperature sensor inside the vehicle.
A- Photo sensor
B- Interior air temperature sensor
Never place anything on top of the
cover for these sensors, doing so will
prevent them from functioning prop-
erly.
(2) May slightly increase as the air condi-
tioning compressor is switched on/off
automatically
For pleasant driving
6-43
Div:
Out put date:

CAUTION
(1) When using the air condition-
ing, the idling speed may slightly
increase as the air condition-
ing compressor is switched
on/off automatically. Especially
for vehicles with an automatic
transmission, while the vehicle
is stationary, fully depress the
brake pedal to prevent the
vehicle from creeping.
(2) On 3500 models, if a problem is
detected in the air conditioning
compressor, the air condition-
ing operation indicator lamp
blinks. Stop the vehicle in a safe
place, turn off the engine, then
restart the engine. If the air con-
ditioning operation indicator
lamp does not blink, there is no
problem. If it does blink, have it
checked at an authorized MIT-
SUBISHI dealer.
Demisting of the windscreen and
door windows
EH03DOH
CAUTION
For safety, make sure you have a
clear view through all windows.
To remove the frost or mist from the wind-
screen and door windows, use the mode
selection dial (“
”or“
”).
H03D151A
- To keep the windscreen and door
windows clear of mist, and to keep
leg area heating (when driving in rain
or snow).
1- Set the air selection switch (A) to the
outside position.
2- Set the mode selection dial to the“
”
position.
3- Select the desired blower speed by turn-
ing the blower speed selection dial.
4- Select the desired temperature by turn-
ing the temperature control dial.
5- Push the air conditioning switch (B).
For pleasant driving
6-50Div:
Out put date:

H03D152A
- For quick demisting
1- Set the mode selection dial to the“
”
position.
2- Set the blower speed to the maximum
blower speed position.
3- Set the temperature to the maximum
temperature position.
NOTE
(1) While the mode selection dial is set to
the“
”position, the air condition-
ing will operate automatically and the
outside air position will also be selected
automatically. This is done for opti-
mum performance.
(In the case, the air conditioning indi-
cator lamp will not change.)
(2) Do not set the temperature control dial
around the max. cool position. Cool air
will blow against the window glasses
and form mist on them.
H04F099A
Cooling
EH04FAOb
Set the mode selection dial to the“
”
position.
Set the air selection switch (A) to the out-
side position and push the air condition-
ing switch (B).
Adjust the temperature by turning the tem-
perature control dial clockwise or anticlock-
wise. Select the desired blower speed.
NOTE
If the outside air is dusty or otherwise con-
taminated, or if high cooling performance
is desired, set the air selection switch to the
recirculation position and the tempera-
ture control dial all the way to the left.
Switch to the outside position periodically
to increase ventilation so that the win-
dows do not become fogged up.
CAUTION
(1) When using the air condition-
ing, the idling speed may slightly
increase as the air condition-
ing compressor is switched
on/off automatically. Especially
for vehicles with an automatic
transmission, while the vehicle
is stationary, fully depress the
brake pedal to prevent the
vehicle from creeping.
(2) On 3500 models, if a problem is
detected in the air conditioning
compressor, the air condition-
ing operation indicator lamp
blinks. Stop the vehicle in a safe
place, turn off the engine, then
restart the engine. If the air con-
ditioning operation indicator
lamp does not blink, there is no
problem. If it does blink, have it
checked at an authorized MIT-
SUBISHI dealer.
For pleasant driving
6-51
Div:
Out put date:

If the vehicle breaks down
EN40B-Bc
If the vehicle breaks down on the road,
move it to the shoulder and use the haz-
ard warning flashers.If the engine stops/failsVehicle operation and control are affected
if the engine stops. Before moving the
vehicle to a safe area be aware of the
following:
1. The brake booster becomes inopera-
tive and the pedal effort will increase.
Press down the brake pedal harder than
usual.
2. Since the power steering pump is no
longer operative, the steering wheel
feels heavy when turning it. Turn the
wheel with more effort than usual.
Operation under adverse driv-
ing conditions
EI43AAKa
If your vehicle is stuck in sand, mud
or snowIf the vehicle becomes stuck in snow, sand,
or mud, it can often be moved with a rock-
ing motion. Move the selector lever alter-
nately between the Sports-mode and “R”
(REVERSE) position (with manual trans-
mission, between 1st and Reverse), while
applying slight pressure to the accelera-
tor pedal.
Avoid racing the engine or spinning the
wheels. Prolonged efforts to free a stuck
vehicle may result in overheating and trans-
mission failure. Allow the engine to idle for
a few minutes to let the transmission cool
between rocking attempts.
If the vehicle remains stuck after several
rocking attempts, seek other assistance.
WARNING
When attempting to rock your vehicle
out of a stuck position, be sure that
the area around the vehicle is clear of
people and physical objects. The
rocking motion may cause the
vehicle to suddenly launch forward
or backward, causing injury or dam-
age to nearby people or objects.
For emergencies
8-2Div:
Out put date:

On a flooded road(1) Avoid flooded roads. Water could enter
the brake discs, resulting in tempo-
rarily ineffective brakes. In such cases,
lightly depress the brake pedal to see
if the brakes operate properly. If they do
not, lightly depress the pedal several
times while driving in order to dry the
brake pads.
(2) When driving in rain or on a road with
many puddles a layer of water may
form between the tyres and the road
surface.
This reduces a tyre’s frictional resis-
tance on the road, resulting in loss of
steering stability and braking capabil-
ity.
To cope with this, observe the follow-
ing items:
(a)Drive your vehicle at a slow speed.
(b)Do not drive on worn tyres. Always
maintain the specified tyre inflation
pressures.
On a snow-covered or frozen road(1) When driving on a snow-covered or fro-
zen road, it is recommended that you
use snow tyres or tyre chains.
Refer to the“Snow tyres”and“Tyre
chains”sections.
(2) Avoid high-speed operation, sudden
acceleration, abrupt brake applica-
tion and sharp cornering.
(3) Depressing the brake pedal during
travel on such a road may cause tyre
slippage and skidding. When traction
between the tyres and the road is
reduced the wheels may skid and the
vehicle cannot readily be brought to a
stop by conventional braking tech-
niques. Braking will differ, depending
upon whether you have anti-lock
brakes (ABS). If you do have ABS,
brake by pressing the brake pedal
hard, and keeping it pressed. If you do
not have ABS, pump the brake pedal
with short rapid jabs, each time fully
applying and fully releasing for great-
est effect.
(4) Allow extra distance between your
vehicle and the vehicle in front of you,
and avoid sudden braking.
Tools and jack
EN01BOI
The storage location of the tools and jack
should be remembered in case of an emer-
gency.
For emergencies
8-3
Div:
Out put date:

N29B269A
Fuse load capacity
EN29BOIb
The fuse capacity and the name of the
electric systems protected by the fuses are
indicated on the inside of the lid located at
the driver’s leg area and on the inside of
the fuse box lid for fuses located in the
engine compartment.
Passenger compartment
NOTE
Spare fuses are contained in the fuse hous-
ing. Always use a fuse of the same capac-
ity for replacement.LHD
NO Symbol Electric systemCapacity
1
Rear window wiper 15A
2- - -
3Radio 10A
4Cigarette lighter 15A
5Relay 10A
6Gauge 10A
7Engine control 20A
8Reversing lamps 10A
9Rear fog lamp 10A
10Central door locks 20A
11Rear window demister 30A
12Heater 30A
13Sunroof 20A
14Anti-lock brake system 10A
NO Symbol Electric systemCapacity
15
Heated seat 20A
16Heated door mirror 10A
1 7 - Spare fuse 10A
1 8 - Spare fuse 15A
1 9 - Spare fuse 20A
2 0 - Spare fuse 30A
•Some fuses may not be installed on your
vehicle, depending on the vehicle model
or specifications.
•The table above shows the main equip-
ment corresponding to each fuse.
For emergencies
8-30Div:
Out put date:

N29B270A
RHD
NO Symbol Electric systemCapacity
1
Rear window wiper 15A
2- - -
3Radio 10A
4Cigarette lighter 15A
5Relay 10A
6Gauge 10A
7Engine control 20A
8Reversing lamps 10A
9Rear fog lamp 10A
10Central door locks 20A
11Rear window demister 30A
12Heater 30A
13Heated door mirror 10A
14Heated seat 20A
NO Symbol Electric systemCapacity
15
Anti-lock brake system 10A
16Sunroof 20A
1 7 - Spare fuse 10A
1 8 - Spare fuse 15A
1 9 - Spare fuse 20A
2 0 - Spare fuse 30A
•Some fuses may not be installed on your
vehicle, depending on the vehicle model
or specifications.
•The table above shows the main equip-
ment corresponding to each fuse.
For emergencies
8-31
Div:
Out put date: