2003 MITSUBISHI MONTERO door lock

ACX00492 AA AA
ALIGN THE BACK DOOR
GLASS END WITH THE
WINDOW DAM ENDWINDOW DAM
ALIGN WITH EDGE
OF GLASS
BACK DOOR GLASS
AB SECTION A A WINDOW DAM INSTALLATION POSITION
ACX00494
DUAL LOCK FASTENER
RAISED SECTION
OF BODY FLANGE
GLASS STOPPER
INSTALLATION HOLES
AB

ACX00542
INNER
CABLE OUTER
CABLE
CLIPCLIP
INSIDE LOCK RODDOOR INSIDE HANDLE
AB
AC000039
LOCK
UNLOCK
VIEW A
VIEW BUNLOCK
LOCK
B

AF
A
LEVER
LEVER

ACX01846
A-16 Y A-17 A-18A-19
Denotes connector No.
The same connector No. is used throughout the circuit diagrams to facilitate connector location searches.
The first alphabetical symbol indicates the location site of the connector and a number that follows is the unique number.
Numbers are assigned to parts in clockwise order on the diagram.
Example: A-19
Number specific to connector (serial number)
Connector location site symbol
A: ENGINE COMPARTMENT F: FRONT FLOOR AND ROOF
B: ENGINE G: REAR FLOOR AND UNDER FLOOR
C: TRANSMISSION H: DOOR
D: DASH PANEL I: BACK DOOR
E: FLOOR CONSOLE
Denotes ground point.
Same ground number is used throughout circuit
diagrams to facilitate search of ground point.
Refer to GROUP 70 SINGLE PART INSTALLATION
POSITION - GROUND MOUNTING LOCATIONS
for details of ground points.
Denotes a section covered by a
corrugated tube.
Denotes the color of the corrugated
tube (If not specified, it is black.)
R: Red
Y: Yellow
The number of connector pins and the connector color
(except milk white)* are shown for ease of retrieval.
Example: (2-B)
Connector color
(milk white if no color is indicated)
Number of connector pins
*: Typical connector colors
B: Black BR: Brown
Y: Yellow V: Violet
L: Blue O: Orange
G: Green GR: Gray
R: Red NONE: Milk white
A-16 (1) HORN (LOW)
A-17 (3-GR) HEADLIGHT (LOW:RH)
A-18 (2-B) HEADLIGHT (HIGH:RH)
A-19 (2) DUAL PRESSURE SWITCH
Indicates the device to which the
connector is connected.
The mark shows the
standard mounting position
of wiring harness.
AF
Denotes harness name.FRONT
WIRING
HARNESS