2003 MERCEDES-BENZ SLK CLASS low beam
[x] Cancel search: low beamPage 3 of 304
Contents
Introduction.......................................... 7
Product information ................................ 7
Operator’s Manual .................................. 8
Service and warranty information ..... 8
Important notice for California
retail buyers and lessees of
Mercedes-Benz automobiles ............. 9
Maintenance .................................. 10
Roadside Assistance ...................... 10
Change of address or ownership.... 10
Operating your vehicle outside
the USA or Canada......................... 11
Where to find it .................................... 12
Symbols ............................................... 13
Operating safety .................................. 14
Proper use of the vehicle ............... 14
Problems with your vehicle .................. 15
Reporting safety defects...................... 16
Reporting safety defects ................ 16At a glance......................................... 17
Cockpit ................................................ 18
Instrument cluster ............................... 20
Center console .................................... 23Upper part ...................................... 23
Lower Part ...................................... 24
Overhead control panel ........................ 25
Getting started................................... 27
Unlocking ............................................. 28
Unlocking with the remote control.. 28
Adjusting .............................................. 30
Seats............................................... 30
Telescoping steering column* ........ 34
Mirrors ............................................ 35
Driving .................................................. 37
Fastening the seat belts.................. 37
Starting the engine ......................... 40
Switching on headlamps ................. 43
Turn signals and high beam ............ 43
Windshield wipers ........................... 44
Problems while driving .................... 45
Parking and locking .............................. 47
Parking brake.................................. 47
Switching off headlamps................. 48
Turning off engine ........................... 48
Safety and Security........................... 51
Occupant safety ................................... 52
Airbags ........................................... 53
Seat belts ....................................... 57
Children in the vehicle .................... 60
Panic alarm .......................................... 65
Activating........................................ 65
Deactivating.................................... 65
Driving safety systems ......................... 66
ABS ................................................. 66
BAS ................................................. 68
ESP ................................................. 68
Anti-theft systems ................................ 71
Immobilizer ..................................... 71
Anti-theft alarm system .................. 71
Tow-away alarm .............................. 72Controls in detail................................ 73
Locking and unlocking.......................... 74
Keys ................................................ 74
Opening the trunk ........................... 77
Closing the trunk ............................ 77
Opening the doors from the inside . 78
Trunk lid emergency release ........... 78
Page 21 of 304
21 At a glance
Instrument cluster
Item
Page
1
Left indicator lamps
with:W
Low windshield
washer and head-
lamp washer* sys-
tem fluid level
warning lamp
200
/
Low engine coolant
level warning lamp
201
N
Low engine oil level
warning lamp
200
1
Supplemental re-
straint system indi-
cator lamp
52,
197
2
Brake pad wear in-
dicator lamp
202
?
Engine malfunction
indicator lamp
199
_
Telescoping steer-
ing column warning
lamp*
200
Item
Page
2
Warning display with:D
Coolant tempera-
ture gauge
88
A
Fuel gauge with fuel
reserve warning
lamp
201
Outside temperature
indicator
90
3
Knob for:
Instrument cluster illu-
mination
88
Resetting trip odome-
ter
89
Activating Flexible Ser-
vice System (FSS) indi-
cator
185
4
Speedometer with:L
Turn signal
K
indicator lamps
v
Electronic Stability
Program (ESP)
warning lamp
68,
194
Trip odometer
89
Main odometer
5
Knob for:
Setting clock
90
6
Tachometer with:Selector lever position
41, 93
Digital clock
90
7
Right indicator lamps
with:$
Exterior lamp failure
indicator lamp
203
A
High beam head-
lamp indicator
43, 84
#
Charge indicator
lamp
202
Item
Page
Page 43 of 304
43 Getting started
Driving
Switching on headlampsExterior lamp switch1Off
2Low beam headlamps on
Turn the switch to
B
.More information can be found in the
“Controls in detail” section (
page 83).
Turn signals and high beam
The combination switch is on the left of the
steering column.Combination switch1Turn signals, right
2Turn signals, left
Press the combination switch up1 or
down2.
Warning!
G
Vehicles with automatic transmission: It is
dangerous to shift the selector lever out ofP
orN if the engine speed is higher than idle
speed. If your foot is not firmly on the brake
pedal, the vehicle could accelerate quickly
forward or in reverse. You could lose control
of the vehicle and hit someone or some-
thing. Only shift into gear when the engine is
idling normally and when your right foot is
firmly on the brake pedal.!Simultaneously depressing the acceler-
ator pedal and applying the brake re-
duces engine performance and causes
premature brake and drivetrain wear.
Warning!
G
On slippery road surfaces, never downshift
in order to obtain braking action. This could
result in drive wheel slip and reduced vehi-
cle control. Your vehicle’s ABS will not pre-
vent this type of loss of control.
Page 83 of 304
83 Controls in detail
Lighting
Lighting
For notes on how to switch on the head-
lamps and use the turn signals, see the
“Getting started” section (
page 43).
Exterior lamp switch
The exterior lamp switch is located on the
dashboard to the left of the steering wheel.Exterior lamp switch
M
Off
C
Parking lamps (also side marker
lamps, tail lamps, license plate
lamps, instrument panel lamps)
Canada only: When engine is run-
ning, the low beam is also switched
on.
B
Low beam plus parking lamps or
high beam headlamps (combination
switch pushed forward).
ˆ
Standing lamps, right (turn left one
stop)
‚
Standing lamps, left (turn left two
stops)Daytime running lamp mode (Canada
only)
Vehicles with automatic transmission
When the engine is running and the
selector lever is in driving position, the low
beam headlamps are automatically
switched on.
When you shift from a driving position to
positionN orP, the low beam switches off
(2 seconds delay).
Vehicles with manual transmission
With the engine running, the low beam
headlamps are automatically switched on.
iIf you remove the key and open the
driver’s door while the parking lamps or
low beam headlamps are switched on,
then a warning sounds.
iWith the daytime running lamp mode
activated and the engine running, the
low beam headlamps cannot be
switched off manually.
Page 84 of 304
84 Controls in detailLightingFor nighttime driving you should turn the
exterior lamp switch to position
B
to
permit activation of the high beam head-
lamps.
Switching on front fog lamps
Check that the low beam headlamps
are switched on.
Pull out exterior lamp switch to first
stop.
The green indicator lamp
‡
in the
lamp switch lights up.Switching on rear fog lamp
Check that the low beam headlamps
are switched on.
Pull out exterior lamp switch to second
stop.
The yellow indicator lamp
†
in the
lamp switch lights up.
Combination switch
The combination switch is located on the
left side of the steering column.
1High beam
2High beam flasher
iThe high beam flasher is always avail-
able.
iFog lamps will operate with the parking
lamps and/or low beam headlamps on.
Fog lamps should only be used in con-
junction with low beam headlamps.
Consult your State or Province Motor
Vehicle Regulations regarding allow-
able lamp operation.
Page 203 of 304
203 Practical hints
What to do if …?
Problem
Possible cause
Suggested solution
.
The yellow exterior lamp failure
indicator lamp lights up while
applying the brake and stays on
until the engine is turned off.
One of the brake lights is malfunctioning.
Visit an authorized Mercedes-Benz
Center as soon as possible.
.
The yellow exterior lamp failure
indicator lamp remains lit after
starting the engine or lights up
while driving.
One of the following lights is malfunctioning:
parking lamp
tail lamp
stop lamp
low beam head lamp
Replace the bulb as soon as possible
(page 221).
iAdditional lighting equipment, if not
properly installed (e.g. auxiliary head-
lamps etc.), could cause the failure in-
dicator monitoring unit to malfunction.
We therefore recommend that an au-
thorized Mercedes-Benz Center install
such equipment for you.
iIf an exterior lamp fails, the indicator
lamp will come on only when that lamp
is switched on.
Page 221 of 304
221 Practical hints
Replacing bulbs
Replacing bulbs
Safe vehicle operation depends on proper
exterior lighting and signaling. It is there-
fore essential that all bulbs and lamp as-
semblies are in good working order at all
times.
Correct headlamp adjustment is extremely
important. Have headlamps checked and
readjusted at regular intervals and when a
bulb has been replaced. See your autho-
rized Mercedes-Benz Center for headlamp
adjustment (
page 226).
Bulbs Front lamps
Lamp
Type
1
Additional turn
signal lamps
LED
2
Low beam
H7 (55 W)
Xenon*
D2R-35 W
3
Parking, standing
and turn signal lamp
2375 NA
4
High beam
H7 (55 W)
5
Fog lamp
HB4 (55 W)
6
Side marker lamp
W5W
Page 223 of 304
223 Practical hints
Replacing bulbs
Replacing bulbs for front lamps
Low and high beam headlamps (Halo-
gen headlamps only)
Switch off the lights.
Open the hood (
page 171).
1Headlamp cover with locking tab
Push down locking tab at top and end
of headlamp cover1 and remove.2Electrical connector for low beam
headlamp bulb
3Electrical connector for high beam
headlamp bulb
Pull off electrical connector2 or3.
Unhook clamping ring and pull out the
bulb together with clamping ring.
Remove bulb.
Insert new bulb so that bulb sits prop-
erly in cutouts of bulb socket.
Mount clamping ring and reinstall.
Plug electrical connector onto the bulb.
Reinstall headlamp cover1.Low and high beam headlamps (Xenon*
headlamps only)
Warning!
G
Do not remove the cover for the xenon head-
lamp. Because of high voltage in xenon
lamps, it is dangerous to replace the bulb or
repair the lamp and its components. We rec-
ommend that you have such work done by a
qualified technician.