2003 MERCEDES-BENZ S55AMG oil additives

Contents
Technical data................................. 357
Spare parts service ............................ 358
Warranty coverage............................. 359
Loss of Service and Warranty
Information Booklet ..................... 359
Identification labels ........................... 360
Layout of poly-V-belt drive ................. 361
S 430 / S 500.............................. 361
S 55 AMG..................................... 361
S 600 ........................................... 361
Engine................................................ 362
Rims and tires.................................... 364
Same size tires............................. 365
Mixed size tires ............................ 366
Spare wheel ................................. 367
Electrical system ............................... 368
Main dimensions ............................... 369
Weights.............................................. 370
Fuels, coolants, lubricants etc. .......... 371
Capacities .................................... 371
Engine oils.................................... 373
Engine oil additives ...................... 373
Air conditioning refrigerant .......... 373
Brake fluid .................................... 373
Premium unleaded gasoline ......... 374Fuel requirements ......................... 374
Gasoline additives......................... 374
Coolants ....................................... 375
Windshield and headlamp washer
system .......................................... 377
Consumer information ........................ 378
Uniform tire quality grading .......... 378
Technical terms................................ 381Index.................................................. 387

373 Technical data
Fuels, coolants, lubricants etc.
Engine oils
Engine oils are specifically tested for their
suitability in our engines. Therefore, only
use engine oils recommended by
Mercedes-Benz. Information on recom-
mended brands is available in the Factory
Approved Service Products pamphlet, or at
your authorized Mercedes-Benz Center.
Please follow FSS recommendations for
scheduled oil changes. Failure to do so
could result in engine damage not covered
by the Mercedes-Benz Limited Warranty.
Engine oil additives
Do not blend oil additives with engine oil.
They may be harmful to the engine opera-
tion.
Damage or malfunctions resulting from
blending oil additives are not covered by
the Mercedes-Benz Limited Warranty.Air conditioning refrigerant
R-134a (HFC) refrigerant and special PAG
lubricating oil is used in the air condition-
ing system.
Never use R-12 (CFC) or mineral-based lu-
bricating oil, as otherwise damage to the
system will occur.
Brake fluid
During vehicle operation, the boiling point
of the brake fluid is continuously reduced
through the absorption of moisture from
the atmosphere. Under extremely strenu-
ous operating conditions, this moisture
content can lead to the formation of bub-
bles in the system, thus reducing the sys-
tem’s efficiency.
Therefore, the brake fluid must be re-
placed every two years, preferably in the
spring.
Only brake fluid approved by
Mercedes-Benz is recommended. Your au-
thorized Mercedes-Benz Center will pro-
vide you with additional information.

374 Technical dataFuels, coolants, lubricants etc.Premium unleaded gasoline
Fuel requirements
Use only premium unleaded gasoline
meeting ASTM standard D 439:

The octane number (posted at the
pump) must be 91 min (93 for S 600).
It is an average of both the Research
(R) octane number and the Motor (M)
octane number: (R+M) / 2). This is also
known as the ANTI-KNOCK INDEX.
Unleaded gasoline containing oxygenates
such as ethanol, IPA, IBA and TBA can be
used provided the ratio of any one of these
oxygenates to gasoline does not exceed
10%; MTBE must not exceed 15%.
The ratio of methanol to gasoline must not
exceed 3% plus additional co-solvents.
Using mixtures of ethanol and methanol is
not allowed. Gasohol, which contains 10%
ethanol and 90% unleaded gasoline, can be
used.
These blends must also meet all other fuel
requirements, such as resistance to spark
knock, boiling range, vapor pressure, etc.
Gasoline additives
A major concern among engine manufac-
turers is carbon build-up caused by gaso-
line. Mercedes-Benz recommends only the
use of quality gasoline containing additives
that prevent the build-up of carbon depos-
its.
After an extended period of using fuels
without such additives, carbon deposits
can build up especially on the intake valves
and in the combustion area, leading to en-
gine performance problems such as:

Warm-up hesitation


Unstable idle


Knocking / pinging


Misfire


Power loss
Do not blend any specific fuel additives
with fuel. This only results in unnecessary
cost and may be harmful to the engine op-
eration.
!To maintain the engine’s durability and
performance, premium unleaded gaso-
line must be used. If premium unleaded
gasoline is not available and low octane
fuel is used, follow these precautions:

Have the fuel tank only partially
filled with unleaded regular and fill
up with premium unleaded as soon
as possible.


Avoid full throttle driving and abrupt
acceleration.


Do not exceed an engine speed of
3000 rpm if the vehicle is loaded
with a light load such as two per-
sons and no luggage.


Do not exceed 2 / 3 of maximum ac-
celerator pedal position if the vehi-
cle is fully loaded or operating in
mountainous terrain.

375 Technical data
Fuels, coolants, lubricants etc.
Damage or malfunctions resulting from
poor fuel quality or from blending specific
fuel additives are not covered by the
Mercedes-Benz Limited Warranty.Coolants
The engine coolant is a mixture of water
and anticorrosion / antifreeze, which pro-
vides:

Corrosion protection


Freeze protection


Boiling protection (by increasing the
boiling point)
The cooling system was filled at the factory
with a coolant providing freeze protection
to approximately -22°F (-30°C) and corro-
sion protection.If the antifreeze mixture is effective to
-22°F (-30°C), the boiling point of the cool-
ant in the pressurized cooling system is
reached at approximately 266°F (130°C).
The coolant solution must be used
year-round to provide the necessary corro-
sion protection and increase boil-over pro-
tection. You should have it replaced every
15 years or 150 000 miles (250 000 km),
whichever comes first.
Coolant system design and coolant used
stipulate the replacement interval. The
above replacement interval is only applica-
ble if MB 325.0 anticorrosion/antifreeze
solution or other Mercedes-Benz approved
products of equal specification (see
Factory Approved Service Products pam-
phlet) are used to renew the coolant con-
centration or bring it back up to the proper
level.
To provide important corrosion protection,
the solution must be at least 45%
anticorrosion / antifreeze [equivalent to
freeze protection to approximately - 22°F
(-30°C)]. If you use a solution that is more than 55% anticorrosion / antifreeze [freeze
protection to approximately - 49°F
(-45°C)], the engine temperature will in-
crease due to the lower heat transfer capa-
bility of the solution. Therefore, do not use
more than this amount of
anticorrosion / antifreeze.
If the coolant level is low, water and
MB 325.0 Anticorrosion / Antifreeze
should be used to bring it up to the proper
level (have cooling system checked for
signs of leakage).
The water in the cooling system must meet
minimum requirements, which are usually
satisfied by normal drinking water. If you
are not sure about the water quality, con-
sult your authorized Mercedes-Benz
Center.

394 IndexEmergency call system* 237
Emergency calls
Initiating an emergency call 240
With Tele Aid* 238
Emergency engine shut-down 355
Emergency operation (Limp Home Mode)
165
Emergency operations
Closing sliding/pop-up roof 330
Locking the vehicle 327
Opening sliding/pop-up roof 330
Remote door unlock 244
Unlocking the trunk lid 327
Unlocking the vehicle 326
Emergency tensioning device see ETD 65,
382
Emission control 259
Ending
A call (telephone) 140
Engine 362
Compartment 263
Message in display 294
Starting 43
Starting with KEYLESS-GO* 43
Starting with the Smartkey 43
Turning off with the Smartkey 52Engine cleaning 284
Engine compartment 263
Fuse box in 354
Hood 263
Engine malfunction indicator lamp 294
Engine number 382
Engine oil 264
Adding 266, 267
Additives 373
Checking level 264
Consumption 264
Display messages 308
Filler neck 267
Messages in display 265, 309
Viscosity 382
Engine oil level see Oil level 262
Engine shut down in an emergency 355
Entry position
Messages in display 321
ESP 78, 382
Four wheel electronic traction system
with ESP 81
Switching off 80
Switching on 80
Warning lamp 290ETD 382
Safety guidelines 60
ETD (Emergency tensioning device) 65
Exterior lamp switch 120
Exterior rear view mirrors
Adjusting 39
Folding electrically 170
Parking position for 158
F
Fahrenheit
Setting temperature units 149
Fastening the seat belts 40
Fine adjustment
Cruise control 198
Distronic* 205
First aid kit 322
Flat tire 339
Lowering the vehicle 342
Mounting the spare wheel 339
Preparing the vehicle 339
Flexible Service System (FSS) 280, 383
Fog lamp, rear 123, 332
Fog lamps
Replacing bulbs 331