233 Practical hints
What to do if …
7
The indicator lamp does not light
up with a BabySmart
TM child
seat properly installed on the
front passenger seat.
The system is malfunctioning.
Make sure that there is nothing be-
tween seat cushion and child seat and
check installation of the child seat
(page 63).
If the light remains out, have the sys-
tem checked as soon as possible by
an authorized Mercedes-Benz Light
Truck Center.
Do not use the BabySmart
TM restraint
to transport children on the front pas-
senger seat until the system has been
repaired.
The yellow fuel tank reserve
warning lamp lights up while
driving.
The fuel level has gone below the reserve
mark.
Refuel at the next gas station
(page 200).
#
The red charge indicator lamp
lights up when the engine is run-
ning.
The battery is no longer charging.
Possible causes:
alternator malfunctioning
broken poly-V-belt
Stop immediately and check the
poly-V-belt.
If it is broken
Do not continue to drive, before the
poly-V-belt is replaced.
Notify an authorized Mercedes-Benz
Light Truck Center.
Problem
Possible cause
Suggested solution
234 Practical hintsWhat to do if …<
The red seat belt warning lamp
blinks for a brief period after
starting the engine.
The warning lamp reminds you to fasten seat
belts.
Fasten your seat belt (
page 60).
W
The yellow low washer system
fluid level lamp lights up after
starting the engine or while driv-
ing.
There is approximately 1.3 US qt. (1.25 l) of
washer fluid remaining in the reservoir.
Add washer fluid (
page 208).
The washer fluid may have frozen
Move the vehicle to a warmer environ-
ment so that the washer fluid will
thaw.
Correct the concentration level after
the washer fluid in the reservoir
thaws.
2
The yellow brake indicator lamp
lights up during braking or after
starting the engine.
The brake pads are worn down.
Have the system checked at an autho-
rized Mercedes-Benz Light Truck
Center.
Problem
Possible cause
Suggested solution
!Brake pad thickness must be visually
checked by a qualified technician at the
intervals specified in the Service book-
let.
261 Practical hints
Battery
Battery
The battery is located in the engine com-
partment on the right-hand side.
Disconnecting the battery
Turn off all electrical consumers.
Open the hood (
page 202).
Disconnect the battery negative lead.
Remove the cover from the positive ter-
minal.
Disconnect the battery positive lead.
Warning!
G
Failure to follow these instructions can re-
sult in severe injury or death.
Never lean over batteries while connecting,
you might get injured.
Battery fluid contains sulfuric acid. Do not
allow this fluid to come in contact with eyes,
skin or clothing. In case it does, immediately
flush affected area with water and seek
medical help if necessary.
A battery will also produce hydrogen gas,
which is flammable and explosive. Keep
flames or sparks away from battery, avoid
improper connection of jumper cables,
smoking etc.
!Never loosen or detach battery termi-
nal clamps while the engine is running
or the key is in the steering lock. Other-
wise the alternator and other electronic
components could be severely dam-
aged.
Have the battery checked regularly by
an authorized Mercedes-Benz Light
Truck Center.
Refer to Service Booklet for mainte-
nance intervals or contact your autho-
rized Mercedes-Benz Light Truck
Center for further information.Warning!
G
Do not place metal objects on the battery as
this could result in a short circuit.
Use leak-proof battery only to avoid the risk
of acid burns in the event of an accident.
Warning!
G
With a disconnected battery
y o u w i l l n o l o n g e r b e a b l e t o t u r n t h e k e y
in the steering lock
the selector lever will remain locked in
positionP
265 Practical hints
Jump starting
The battery is located in the engine com-
partment.
Make sure that the two vehicles do not
touch.
Turn off all electrical consumers.
Apply parking brake.
Shift selector lever to positionP.1Positive terminal
2Cable clamps
3Negative terminal
4Cover
Remove cover4 from positive terminal
on both vehicles.
Connect positive terminals1 on the
batteries with the jumper cables. Start
with the charged battery.
!Jump starting may only be performed
on the battery installed in the engine
compartment.
Avoid repeated and lengthy starting at-
tempts.
Do not attempt to start the engine us-
ing a battery quick charge unit.
If engine does not run after several un-
successful starting attempts, have it
checked at the nearest authorized
Mercedes-Benz Light Truck Center.
Excessive unburned fuel generated by
repeated failed starting attempts may
damage the catalytic converter.
Make sure the jumper cables do not
have loose or missing insulation.
Make sure the cable clamps do not
touch any other metal part while the
other end is still attached to a battery.
Warning!
G
Keep flames or sparks away from battery.
Do not smoke.
Observe all safety instructions and precau-
tions when handling automotive batteries
(page 261).
266 Practical hintsJump starting
Let the engine of the assisting vehicle
run at idle speed.
Connect the negative terminals3 of
the batteries with the jumper cables.
Start with the charged battery.
Start the engine of the disabled vehi-
cle.Now you can again turn on the electrical
consumers. Do not turn on the lights under
any circumstances.
Remove the jumper cables first from
the negative terminals3 of the batter-
ies and then from the positive
terminals1.
Have the battery checked at the
nearest authorized Mercedes-Benz
Center.iThe vehicle cannot be started via
tow-start.
288 Technical dataFuels, coolants, lubricants etc.The coolant solution must be used year
round to provide the necessary corrosion
protection and increase in boil-over pro-
tection. You should have it replaced every
3years.
To provide important corrosion protection,
the solution must be at least 45% anticor-
rosion/antifreeze (equivalent to freeze
protection to approx. - 22°F [-30°C]). If
you use a solution that is more than 55%
anticorrosion/antifreeze (freeze protec-
tion to approx. - 49°F [-45°C]), the engine
temperature will increase due to the lower
heat transfer capability of the solution.
Therefore, do not use more than this
amount of anticorrosion/antifreeze.If the coolant level is low, water and MB
anticorrosion /antifreeze should be used
to bring it up to the proper level (have cool-
ing system checked for signs of leakage).
Please make sure that the mixture is in ac-
cordance with label instructions.
The water in the cooling system must meet
minimum requirements, which are usually
satisfied by normal drinking water. If you
are not sure about the water quality, con-
sult your authorized Mercedes-Benz Light
Truck Center.
Anticorrosion/antifreeze
Your vehicle contains a number of alumi-
num parts. The use of aluminum compo-
nents in motor vehicle engines
necessitates that anticorrosion/antifreeze
coolant used in such engines be specifical-
ly formulated to protect the aluminum
parts. (Failure to use such anticorro-
sion/antifreeze coolant will result in a sig-
nificantly shortened service life.)
Therefore, the following product is strongly
recommended for use in your vehicle:
Mercedes-Benz Anticorrosion/Antifreeze
agent.
Before the start of the winter season (or
once a year in hot southern regions), you
should have the anticorrosion/antifreeze
concentration checked. The coolant is also
regularly checked each time you bring your
vehicle to your authorized Mercedes-Benz
Light Truck Center for service.
302 IndexCargo floor plates 144
Installing 144
Removing 144
Storing 144
Cargo tie-down rings 140
Catalytic converter 198
CD-changer* 238
Center console 27
Lower part 28
Upper part 27
Central locking
Automatic 89
From inside 89
Switch 90
Unlocking from inside 89, 90
Central locking switch 90
Certification label 276
Charge indicator lamp 233
Charging
Vehicle battery 262
Chart
Fuses 271
CHECK ENGINE malfunction indicator
lamp 232
Checking
Coolant level 201, 206Oil level 201, 203
Tire inflate pressure 201
Vehicle lighting 201
Checking weights
Trailer and vehicle 193
Checklist
Off-road driving 187
Returning from off-road driving 191
Child safety 63
Airbags 56
Infant and child restraint systems 54,
60, 63
LATCH child seat mounts 68
Child safety switch see Blocking of rear
door window operation 69
Cigarette lighter
Front center console 156
Cleaning
Cup holder 221
Gear selector lever 221
Hard plastic trim items 221
Headlamps 121
Headliner 221
Instrument cluster 221
Leather upholstery 222
Light alloy wheels 221MB Tex upholstery 222
Plastic and rubber parts 222
Seat belts 221
Steering wheel 221
Windows 220
Windshield 48
Wiper blades 220
Cleaning and care of the vehicle see
Vehicle care 217
Clock 26, 112
Closing
Glove box 152
Hood 203
Liftgate 88
Rear quarter windows* 136
Side windows 135
Sliding/pop-up roof 246
Sliding/pop-up roof* 137
Closing sliding/pop-up roof
In an emergency 246
Cockpit 22, 293
Combination switch 102
High beam flasher 47, 102
Turn signals 47
Windshield wipers 47
308 IndexInterior lighting 107
Activating automatic control 107
Deactivating automatic control 107
Manual operation 108
Reading lamps 108
Interior storage spaces 152
Armrest 153
Cup holder 155
Glove box 152
Storage compartment in front of
armrest 153
Storage compartment under front
passenger seat* 152
Intermittent wiping 122
J
Jack 237, 238
Jump starting 264
K
Key
Global locking 85
Global unlocking 85
Loss of 86
Positions in steering lock 33
Remote control with folding key 84
Unlocking liftgate 85Unlocking the driver’s door, fuel filler
flap 85
Key positions in steering lock 33
Key, Mechanical 242
Key, Remote control
Unlocking with 32
Kickdown 117, 294
L
Labels, identification 276
Lamp bulbs, exterior 247
Lamps, exterior
Front 247
Rear 248
Lamps, indicator and warning
4-ETS 224, 226
ABS 225
Adjustable steering column 229
AIRBAG OFF 59, 232
BAS 73, 225, 226
Battery indicator lamp 233
Brake pad wear 234
Brakes 228
CHECK ENGINE 232
Coolant 230
EBP 229Engine diagnostics 232
ESP 224, 225, 226
Front fog lamps 229
Fuel reserve 233
Instrument cluster ??–233
Low engine oil level 229
LOW RANGE 226
Low washer system fluid level 234
Seat belts 234
Service indicator 215
SRS 54, 227
Turn signals 25
LATCH child seat anchors 68
LATCH child seat mounts 68
Layout of poly-V-belt drive 277
Leather upholstery
Cleaning 222
Lever
For cruise control 146
License plate lamps
Replacing bulbs 248, 252
Liftgate
Closing 88
Opening 85, 87
Opening from inside 87
Opening from outside 87