2003 MERCEDES-BENZ E320 Set clock

23 At a glance
Instrument cluster
Item
Page
1
LLeft turn signal indi-
cator lamp
2
vElectronic Stability
Program (ESP)
warning lamp
288
3
Speedometer
4
Multifunction display
with:Basic display with outside
temperature display
126
Status indicator with mal-
function warning messageTrip odometer
119
5
lDistance warning
lamp
1
1Vehicles without Distronic*: Warning lamp without
function. It illuminates with key in starter switch
position 2. It should go out when the engine is run-
ning.
289
6
KRight turn signal in-
dicator lamp
Item
Page
7
Coolant temperature dis-
play with:•Coolant tempera-
ture warning lamp
292
8
Tachometer with:1Supplemental
restraint system
indicator lamp
290
-Antilock Brake Sys-
tem (ABS) malfunc-
tion indicator lamp
289
warning lamp
293
AHigh beam head-
lamp indicator
115
9
Main odometer with:

Selector lever position
43


Program mode
155
Item
Page
10
Clock with:;Brake warning
lamp, except
Canada
291
3Brake warning
lamp, Canada only
291
?Engine malfunction
indicator lamp
293
11
Fuel display with:AFuel reserve warn-
ing lamp
293
12
Reset knob for:

Resetting trip
odometer
119


Adjusting instrument
cluster illumination
118


Confirming new time
settings
136

45 Getting started
Driving

Get a jump start (
page 346).
If the engine does not start after several
starting attempts, there could be a mal-
function in the engine electronics or in the
fuel supply system.

Notify an authorized Mercedes-Benz
Center.
Parking brake
1Parking brake pedal
2Parking brake release handle

Release the parking brake by pulling on
handle2.
The indicator lamp ; (USA only) or
3 (Canada only) in the clock goes
out.
Driving

Depress the brake pedal.

Move selector lever to positionDorR.

Release the brake pedal.

Carefully depress the accelerator
pedal.
Once the vehicle is in motion, the automat-
ic central locking system engages and the
locking knobs drop down.
Warning!
G
When leaving the vehicle always remove the
key from the starter switch, take the Smart-
Key with KEYLESS-GO* (if so equipped) with
you and lock the vehicle. Do not leave chil-
dren unattended in the vehicle, or with ac-
cess to an unlocked vehicle. Children could
release the parking brake, which could re-
sult in an accident or serious injury.
iWait for the gear selection process to
complete before setting the vehicle in
motion.iYou can open a locked door from the
inside. Open door only when conditions
are safe to do so.!If you hear a warning signal when driv-
ing off, you have forgotten to release
the parking brake.
Release the parking brake.

118 Controls in detailInstrument cluster
Instrument clusterA full view illustration of the instrument
cluster can be found in the "At a glance"
section of this manual (
page 22).
The instrument cluster is activated when
you


open a door


turn on the ignition


press the reset knob (
page 22)


switch on the exterior lamps
You can change the instrument cluster set-
tings in the instrument cluster submenu of
the control system (
page 134).
Instrument cluster illumination
Use the reset knob (
page 22) to adjust
the illumination brightness for the instru-
ment cluster.To brighten illumination

Turn the reset knob in the instrument
cluster clockwise (
page 22).
The instrument cluster illumination will
brighten.
To dim illumination

Turn the reset knob in the instrument
cluster counterclockwise (
page 22).
The instrument cluster illumination will
dim.
iThe instrument cluster illumination is
dimmed or brightened automatically to
suit ambient light conditions.
The instrument cluster illumination will
also be adjusted automatically when
you switch on the vehicle’s exterior
lamps.

137 Controls in detail
Control system
Set time (hours)
Move the selection marker with
theæ orç button to the Time/Date
submenu.

Press buttonj ork repeatedly
until you see this message in the dis-
play:
Clock, hours
.
The selection marker is on the hour set-
ting.

Pressæ orç to set the hour.

Confirm by pressing reset knob.Set time (minutes)

Move the selection marker with
theæ orç button to the Time/Date
submenu.

Press buttonj ork repeatedly
until you see this message in the dis-
play:
Clock, minutes
.
The selection marker is on the minute
setting.

Pressæ orç to set the minutes.

Confirm by pressing reset knob.Set date (month)

Move the selection marker with
theæ orç button to the Time/Date
submenu.

Press buttonj ork repeatedly
until you see this message in the dis-
play:
Set date month
.
The selection marker is on the month
setting.

Pressæ orç to set the month.

335 Practical hints
Replacing bulbs
Front turn signal lamp bulb
Switch off the lights.

Open the hood (
page 261).

Twist bulb socket1 counterclockwise
and pull out.

Push bulb into socket, turn counter-
clockwise and remove.

Insert new bulb in socket, push in and
twist clockwise.

Reinsert bulb socket in lamp and twist
clockwise.Parking and standing lamp bulb

Switch off the lights.

Open the hood (
page 261).

Press the clamp and remove headlamp
cover.

Pull out the bulb socket3 with the
bulb.

Pull the bulb out of the bulb socket.

Insert a new bulb in the socket.

Reinstall the bulb socket.

Align headlamp cover and click into
place.Side marker lamp bulb

Switch off the lights.

Carefully slide lamp towards front.

Remove rear end first.

Twist bulb socket counterclockwise
and pull out.

Pull bulb out of the bulb socket.

Insert new bulb in socket.

Reinstall bulb socket, push in and twist
clockwise.

To reinstall lamp, set rear end in
bumper and let front end snap into
place.

345 Practical hints
Batteries
Reconnecting the batteries
Turn off all electrical consumers.

Connect the positive lead and fasten its
cover.

Connect the negative lead.Batteries contain materials that can harm
the environment if disposed of improperly.
Large 12-volt storage batteries contain
lead. Recycling of batteries is the preferred
method of disposal. Many states require
sellers of batteries to accept old batteries
for recycling.Warning!
G
Never charge a battery while still installed in
the vehicle. Gases may escape during charg-
ing and cause explosions that may result in
paint damage, corrosion or personal injury.!NEVER invert the terminal connections!
The battery, its filler caps and the vent
tube must always be securely installed
when the vehicle is in operation.
iThe following procedures must be car-
ried out following any interruption of
battery power (e.g. due to reconnec-
tion):

Set the clock (
page 136) (vehi-
cles with COMAND*: see COMAND
operator’s manual).


Resynchronize the front seat head
restraints (
page 104).


Resynchronize the ESP
(page 75).


Re-enter the radio code (see radio
operating instructions).


Resynchronize the side windows
(page 186).


Resynchronize the sliding/pop-up
roof* (
page 189).

384 IndexClock 137
Closing
Glove box 226
Side windows 184
Side windows with KEYLESS-GO* 92
Sliding/pop-up roof* 187
Sliding/pop-up roof* with
KEYLESS-GO* 92
Sliding/pop-up roof* with
SmartKey 188, 192
Trunk lid 96
Windows 184
Windows with SmartKey 185
Cockpit 20, 375
COMAND* see separate operating instruc-
tions
Combination switch 115
High beam flasher 47
Turn signals 46
Windshield wipers 47
Consumer information 373
Control system 121, 376
AUDIO menu 126
Convenience submenu 143
Display digital speedometer 126
Distronic* menu 128Functions 125
Instrument cluster submenu 134,
136
Lighting submenu 138
Malfunction memory menu 129
Menus 124, 125, 378
Multifunction display 121
Multifunction steering wheel 122
Selecting radio system 127
Settings menu 130
Standard display menu 126
Submenus 123, 125
TEL* menu 147
Trip computer menu 145
Vehicle submenu 142
Convenience submenu 143
Activating easy-entry/exit
feature* 143
Setting key dependency 144
Setting parking position for exterior
rear view mirror 144
Coolant
Messages in display 311, 312
Temperature display 119
Warning lamp 292, 311
Cruise control 194, 376Canceling 195
Driving downhill 195
Driving uphill 195
Fine adjustment 196
Lever 201
Saving current speed 195
Setting speeds 196
Cruise control lever 194
Customer Assistance Center (CAC) 375
D
Daytime running lamp mode 114
Setting 139
Deactivating
Air conditioner 170
Air recirculation mode 168, 179, 180
Alarm 82
Anti-theft alarm system 82
Automatic climate control 169, 174
Central locking (control system) 142
Climate control 164
Cruise control 195
Defrost 167, 178
Distance warning function* 206
Distronic* 204
Engine with KEYLESS-GO* 53
Engine with the key 52

394 Index
Easy entry/exit feature* 102
Heater* 107
Multicontour seat 104
Split rear bench seat 219
Ventilation 108
Securing cargo
Cargo tie-down rings 225
Selecting
Display 135
Selecting display 136
Selector lever
Lock 43
Position 151
Self-test
BabySmart
TM airbag deactivation
system 68
Tele Aid* 235
Service
Batteries 343
Calling up the service indicator 276
Overdue 276
When due 275
Service and warranty information 10
Service indicator 275
Clearing 275
Service System see FSS 275Setting
Convenience functions 132, 143
Cruise control 195
Daytime running lamp mode 139
Exterior rear view mirror parking
position 111
Higher speed in cruise control 196
Higher speed in Distronic* 202
Hours (clock) 137
Individual vehicle settings 130
Instrument lighting 118, 119
Interior lighting delayed
switch-off 141
Key dependent memory 144
Lamps and lighting (control
system) 138
Language, multifunction display 135
Locator lighting 139
Lower speed in cruise control 196
Lower speed in Distronic* 203
Miles/kilometers in
speedometer 134
Minutes (clock) 137, 138
Parking position for exterior rear view
mirrors 144
Slower speed in cruise control 196Slower speed in Distronic* 203
Speed in cruise control 196
Speed in Distronic* 202
Speedometer display mode 134
Temperature (interior) 165, 176
Temperature indicator 134
Tire inflation pressure 136
Units
Speedometer 134
Temperature 134
Tire inflation pressure 136
Vehicle level control 209
Settings
Calling up Distronic* 128, 200
Convenience functions 143
Factory, KEYLESS-GO* 91
Factory, SmartKey 87
Individual (SmartKey) 144
Lighting (control system) 138
Menus and submenus 123
Resetting all (control system) 131
Resetting in the submenu 131
Selective 87
Settings menu
Functions in 130
Individual vehicle settings 130