217 Controls in detail
Useful features
The Response Center will then unlock your
vehicle with the remote door unlocking
feature.Stolen vehicle tracking services
In the event your vehicle was stolen:
Report the incident to the police.
The police will issue a numbered inci-
dent report.
Give this number to the Mercedes-Benz
Response Center along with the pass-
word which was issued to you when
you subscribed to the service.
The Response Center will then attempt
to covertly contact the vehicle’s
Tele Aid system. Once the vehicle is lo-
cated, the Response Center will con-
tact the local law enforcement and you.
The vehicle’s location will only be pro-
vided to law enforcement.
Garage door opener
The built-in remote control is capable of
operating up to three separately controlled
objects.
1Indicator lamp
2, 3, 4Signal transmitter key
5Hand-held remote control trans-
mitter (not part of vehicle equip-
ment)
iThe remote door unlocking feature is
available if the relevant cellular phone
network is available.
The SOS button will flash and the mes-
sage
EMERGENCY CALL –
CALL CONNECTED
will appear in the mul-
tifunction display to indicate receipt of
the door unlock command.
Once the vehicle is unlocked, a Re-
sponse Center specialist will attempt
to establish voice contact with the ve-
hicle occupants.
If the trunk button was pressed for
more than 20 seconds before door un-
lock authorization was received by the
Response Center, you must wait
15 minutes before pressing the trunk
lock again.
218 Controls in detailUseful features
Programming or reprogramming the in-
tegrated remote control
Turn key in the starter switch to
position1 or2.
Hold the end of the hand-held transmit-
ter of the device you wish to train
approximately 2 to 5 inches (5 cm to
12 cm) away from the surface of the in-
tegrated remote control located on the
inside rear view mirror, keeping the in-
dicator lamp in view.
Using both hands, simultaneously push
the hand-held transmitter button and
the desired integrated remote trunk lid
switch. Do not release the buttons until
completing next step.
Warning!
G
When programming a garage door opener,
the door moves up or down.
When programming or operating the remote
control, make sure there is no possibility of
anyone being injured by the moving door.iCertain types of garage door openers
are incompatible with the integrated
opener. If you should experience diffi-
culties with programming the transmit-
ter, contact your authorized
Mercedes-Benz Center, or call
Mercedes-Benz Customer Assistance
Center (in the USA only) at
1-800-FOR-MERCedes, or Customer
Service (in Canada) at
1-800-387-0100.
iFor operation in the USA only: This de-
vice complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference.
(2) This device must accept any inter-
ference received, including interfer-
ence that may cause undesired
operation.
Any unauthorized modification to this
device could void the user’s authority
to operate the equipment.
219 Controls in detail
Useful features
The indicator lamp on the integrated
remote control will flash, first slowly
and then rapidly. The rapid flashing
lamp indicates successful program-
ming of the new frequency signal.
When the indicator lamp flashes rapid-
ly, release both buttons.
To program the remaining two buttons,
repeat the above steps.Rolling code programming
To train a garage door opener (or other roll-
ing code devices) with the rolling code fea-
ture, follow these instructions after
completing the “Programming” portion of
this text. (A second person may make the
following training procedures quicker and
easier.)
Locate training button on the garage
door opener motor head unit.
Exact location and color of the button
may vary by garage door opener brand.
If there is difficulty locating the trans-
mitting button, refer to garage door
opener operator’s manual.
Press “training” button on the garage
door opener motor head unit.
The “training light” is activated.You have 30 seconds time to initiate the
following step.
Firmly press and release the pro-
grammed integrated remote control
transmit button.
Press and release same button a sec-
ond time to complete the training pro-
cess.
Some garage door openers may require
you to do this procedure a third time to
complete the training.
Confirm the garage door operation by
pressing the programmed button on
the integrated remote control transmit-
ter.
iIf, after several attempts, you do not
successfully program the integrated re-
mote control device to learn the signal
of the hand-held transmitter, the ga-
rage door opener could be equipped
with the “rolling code feature”.
220 Controls in detailUseful featuresCanadian programming
During programming, your hand-held
transmitter may automatically stop trans-
mitting.
Continue to press and hold the inte-
grated remote control transmitter but-
ton (refer to steps two through four in
the “Programming” portion) while you
repeatedly press (“cycle”) your
hand-held transmitter every two sec-
onds until the frequency signal has
been learned.
Upon successful training, the indicator
lamp will flash slowly and then rapidly
after several seconds.Operating the remote control
Turn key in starter switch to position1
or2.
Select and press the appropriate but-
ton to activate the remote controlled
device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.Erasing the remote control memory
Turn key in ignition to position1 or2.
Simultaneously hold down the left and
right side buttons for approximately
20 seconds, or until the indicator lamp
blinks rapidly.
The codes of all three channels are
erased.iIf you sell your vehicle, erase the codes
of all three channels.
350 Technical termsMON
(M
otor O
ctane N
umber)
The Motor Octane Number for gasoline
as determined by a standardized meth-
od. It is an indication of a gasoline's
ability to resist undesired detonation
(knocking). The average of both the
MON (Motor Octane Number) and
->RON (Research Octane Number) is
posted at the pump, also known as AN-
TI-KNOCK INDEX.
Multifunction display
Display field in the speedometer used
to present information provided by the
control system.
Multifunction steering wheel
Steering wheel with buttons for operat-
ing the control system.
Overspeed range
Engine speeds within the red marking
of the tachometer dial. Avoid this en-
gine speed range, as it may result in se-
rious engine damage that is not
covered by the Mercedes-Benz Limited
Warranty.Parktronic*
System which uses visual and acoustic
signals to assist the driver during park-
ing maneuvers.
Poly-V-belt drive
Drives engine-components (alternator,
AC compressor, etc.) from the engine.
Power train
Collective term designating all compo-
nents used to generate and transmit
motive power to the drive axles, includ-
ing:
Engine
Clutch/torque converter
Transmission
Transfer case
Drive shaft
Differential
Axle shafts/axlesProgram mode selector switch
Used to switch the automatic transmis-
sion between sport operationS and
comfort operationC.
CL 55 AMG with steering wheel gear-
shift control and manual shift program:
in addition toS andC (see above), you
can use theM for manual operation.
Remote Vehicle Diagnostics
Transmission of vehicle data and cur-
rent location to the Mercedes-Benz
Customer Assistance Center for sub-
scribers to Tele Aid service.
REST
(Residual engine heat utilization)
Feature that uses the engine heat
stored in the coolant to heat the vehi-
cle interior for a short time after the en-
gine has been turned off.
Restraint systems
Seat belts, belt tensioners, airbags and
child restraint systems. As indepen-
dent systems, their protective func-
tions complement one another.
360 IndexDriving systems 176
ABC 190
Cruise control 176
Distronic* 179
Driving safety systems 71
Parktronic* 193
Vehicle level control 191
E
Easy-entry/exit feature 96
Activating 140
Electrical fuses 322
Electrical system 334
Electronic Stability Program see ESP 23,
73, 348
Emergency calls
Initiating an emergency call 212
With Tele Aid 211
Emergency engine shut-down 324
Emergency operation (Limp Home
Mode) 148
Emergency operations
Closing sliding/pop-up roof 301
Locking the vehicle 298
Opening sliding/pop-up roof 301
Remote door unlock 216
Unlocking the trunk lid 298Unlocking the vehicle 297
Emergency tensioning device see
ETD 63, 349
Emission control 233
Ending
A call (telephone) 126
Engine 330
Compartment 237
Message in display 268
Starting 43
Starting with KEYLESS-GO* 43
Starting with the key 43
Turning off with the key 51
Engine cleaning 257
Engine compartment 237
Fuse box in 324
Hood 237
Engine malfunction indicator lamp 23,
268
Engine number 348Engine oil 238
Adding 241
Additives 339
Checking level 238
Consumption 238
Display messages 281
Filler neck 241
Messages in display 239, 282
Viscosity 348
Engine oil level
see Oil level 236, 238, 240
Entry position
Messages in display 294
ESP 23, 73, 348
Switching off 75
Switching on 75
Warning lamp 264
ETD 349
Safety guidelines 58
ETD (Emergency tensioning device) 63
Exterior lamp switch 108
Exterior rear view mirrors
Adjusting 38
Folding 152
Parking position for 142
361 Index
F
Fahrenheit
Setting temperature units 134
Fastening the seat belts 40
Fine adjustment
Cruise control 178
Distronic* 185
First aid kit 295
Flat tire 308
Lowering the vehicle 312
Mounting the Spare wheel 308
Preparing the vehicle 308, 309
Flexible Service System (FSS) 254, 349
Fog lamp, rear 110, 303
Replacing bulb 305
Fog lamps
Replacing bulbs 302
Fog lamps, front
Messages in display 287
Switching on 110
Folding
Exterior rear view mirrors 152
Front airbags 59Front lamps
Messages in display 286– 287
Replacing bulbs 302, 304
Switching on 108
Front seat
Head restraints 97
Head restraints installing 97
Head restraints removing 97
FSS (Flexible Service System) 254, 349
Fuel 235
Fuel reserve warning lamp 268
Premium unleaded gasoline 235
Reserve warning lamp 23
Fuel consumption statistics
After start 129
Since last reset 129
Fuel filler flap 235
Locking 235
Opening 300
Unlocking 235
Fuel reserve tank
Message in display 284
Fuel tank
Filler flap 235
Fuels, coolants, lubricants etc. 337Functions (control system) 119, 121
Resetting 132
Fuse box 322, 324
Fuse chart 295
Fuses 322
Fuse box in dashboard 322
F us e box in engi ne comp ar tme nt 3 24
Fuse box in passenger
compartment 322
Fuse box in the rear passenger
compartment 323
Fuse chart 295
Fuse extractor 295
Spare fuses 295
G
Garage door opener 27, 217
Erasing in remote control 220
Integrated remote control 218
Rolling code programming 219
Gasoline see Fuel 235
Gear range 349
Automatic transmission 145
Limiting 145
Shifting into optimal 144
Gear range limit
Canceling 144
362 IndexGear selector lever
Cleaning 260
Position 146
Gearshift pattern for automatic
transmission 43
Global
Locking 81
Unlocking 81
Global Positioning System (GPS) 349
Glove box 21, 199
Closing 199
Opening 199
Good visibility 151
GPS 210, 349
H
Hand-held transmitter
Programming integrated remote
control 218
Hands-free microphone 27
Hard plastic trim items
Cleaning 260
Hazard warning flasher 111
Switching off 111
Switching on 111
Head restraints 97
Headlamp cleaning system 236Headlamps
Automatic control 109
Bi-Xenon 347
Cleaning 258
Cleaning system 154, 244, 344
Refilling washer fluid 244
Switching off 50
Switching on 46
Headliner
Cleaning 261
Heated steering wheel* 208
Height adjustment
Head restraints 36
Steering wheel 37
Height adjustments
Vehicle level 191
High beam flasher 46, 111
High beam headlamps
Messages in display 286
Replacing bulbs 302
Switching on 111
High mounted brake lamp 303
Hood 237
Closing 238
Message in display 284
Opening 237Hydroplaning 229
I
Identification labels
Certification label 328
Emission control label 328
Engine number 328
Information label, California version
Vacuum line routing for emission
control system 328
VIN (vehicle identification
number) 328
VIN, visible 328
Ignition 31
Immobilizer 76
Activating 76
Deactivating 76
Indicator lamps see Lamps, indicator and
warning
Infant and child restraint systems 63
Installing 67
LATCH child seat mounts 68
Information
About service and warranty 10
Button for Tele Aid 214