2003 MERCEDES-BENZ CL55AMG remote start

218 Controls in detailUseful features
Programming or reprogramming the in-
tegrated remote control
Turn key in the starter switch to
position1 or2.

Hold the end of the hand-held transmit-
ter of the device you wish to train
approximately 2 to 5 inches (5 cm to
12 cm) away from the surface of the in-
tegrated remote control located on the
inside rear view mirror, keeping the in-
dicator lamp in view.

Using both hands, simultaneously push
the hand-held transmitter button and
the desired integrated remote trunk lid
switch. Do not release the buttons until
completing next step.
Warning!
G
When programming a garage door opener,
the door moves up or down.
When programming or operating the remote
control, make sure there is no possibility of
anyone being injured by the moving door.iCertain types of garage door openers
are incompatible with the integrated
opener. If you should experience diffi-
culties with programming the transmit-
ter, contact your authorized
Mercedes-Benz Center, or call
Mercedes-Benz Customer Assistance
Center (in the USA only) at
1-800-FOR-MERCedes, or Customer
Service (in Canada) at
1-800-387-0100.
iFor operation in the USA only: This de-
vice complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference.
(2) This device must accept any inter-
ference received, including interfer-
ence that may cause undesired
operation.
Any unauthorized modification to this
device could void the user’s authority
to operate the equipment.

220 Controls in detailUseful featuresCanadian programming
During programming, your hand-held
transmitter may automatically stop trans-
mitting. 
Continue to press and hold the inte-
grated remote control transmitter but-
ton (refer to steps two through four in
the “Programming” portion) while you
repeatedly press (“cycle”) your
hand-held transmitter every two sec-
onds until the frequency signal has
been learned.
Upon successful training, the indicator
lamp will flash slowly and then rapidly
after several seconds.Operating the remote control

Turn key in starter switch to position1
or2.

Select and press the appropriate but-
ton to activate the remote controlled
device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.Erasing the remote control memory

Turn key in ignition to position1 or2.

Simultaneously hold down the left and
right side buttons for approximately
20 seconds, or until the indicator lamp
blinks rapidly.
The codes of all three channels are
erased.iIf you sell your vehicle, erase the codes
of all three channels.

360 IndexDriving systems 176
ABC 190
Cruise control 176
Distronic* 179
Driving safety systems 71
Parktronic* 193
Vehicle level control 191
E
Easy-entry/exit feature 96
Activating 140
Electrical fuses 322
Electrical system 334
Electronic Stability Program see ESP 23,
73, 348
Emergency calls
Initiating an emergency call 212
With Tele Aid 211
Emergency engine shut-down 324
Emergency operation (Limp Home
Mode) 148
Emergency operations
Closing sliding/pop-up roof 301
Locking the vehicle 298
Opening sliding/pop-up roof 301
Remote door unlock 216
Unlocking the trunk lid 298Unlocking the vehicle 297
Emergency tensioning device see
ETD 63, 349
Emission control 233
Ending
A call (telephone) 126
Engine 330
Compartment 237
Message in display 268
Starting 43
Starting with KEYLESS-GO* 43
Starting with the key 43
Turning off with the key 51
Engine cleaning 257
Engine compartment 237
Fuse box in 324
Hood 237
Engine malfunction indicator lamp 23,
268
Engine number 348Engine oil 238
Adding 241
Additives 339
Checking level 238
Consumption 238
Display messages 281
Filler neck 241
Messages in display 239, 282
Viscosity 348
Engine oil level
see Oil level 236, 238, 240
Entry position
Messages in display 294
ESP 23, 73, 348
Switching off 75
Switching on 75
Warning lamp 264
ETD 349
Safety guidelines 58
ETD (Emergency tensioning device) 63
Exterior lamp switch 108
Exterior rear view mirrors
Adjusting 38
Folding 152
Parking position for 142

361 Index
F
Fahrenheit
Setting temperature units 134
Fastening the seat belts 40
Fine adjustment
Cruise control 178
Distronic* 185
First aid kit 295
Flat tire 308
Lowering the vehicle 312
Mounting the Spare wheel 308
Preparing the vehicle 308, 309
Flexible Service System (FSS) 254, 349
Fog lamp, rear 110, 303
Replacing bulb 305
Fog lamps
Replacing bulbs 302
Fog lamps, front
Messages in display 287
Switching on 110
Folding
Exterior rear view mirrors 152
Front airbags 59Front lamps
Messages in display 286– 287
Replacing bulbs 302, 304
Switching on 108
Front seat
Head restraints 97
Head restraints installing 97
Head restraints removing 97
FSS (Flexible Service System) 254, 349
Fuel 235
Fuel reserve warning lamp 268
Premium unleaded gasoline 235
Reserve warning lamp 23
Fuel consumption statistics
After start 129
Since last reset 129
Fuel filler flap 235
Locking 235
Opening 300
Unlocking 235
Fuel reserve tank
Message in display 284
Fuel tank
Filler flap 235
Fuels, coolants, lubricants etc. 337Functions (control system) 119, 121
Resetting 132
Fuse box 322, 324
Fuse chart 295
Fuses 322
Fuse box in dashboard 322
F us e box in engi ne comp ar tme nt 3 24
Fuse box in passenger
compartment 322
Fuse box in the rear passenger
compartment 323
Fuse chart 295
Fuse extractor 295
Spare fuses 295
G
Garage door opener 27, 217
Erasing in remote control 220
Integrated remote control 218
Rolling code programming 219
Gasoline see Fuel 235
Gear range 349
Automatic transmission 145
Limiting 145
Shifting into optimal 144
Gear range limit
Canceling 144

363 Index
Inside rear view mirror
Adjusting 38
Antiglare 151
Installing
Infant and child restraint systems 67
Wiper blades 307
Instrument cluster 21, 22, 114, 349
Cleaning 260
Coolant temperature gauge 115
Illumination 114
Multifunction display 117
Outside temperature indicator 116
Selecting language 135
Instruments and controls see Cockpit 20
Integrated remote control
Canadian programming 220
Erasing memory 220
Hand-held transmitter 218
Operating 220
Rolling code programming 219
Interior lighting 112
Activating automatic control 112
Deactivating automatic control 112
Delayed switch-off 138
Manual operation 113Interior storage spaces 199
Cup holder 202
Glove box 199
Parcel net 205
Storage compartment in front of
armrest 200, 201
J
Jump starting 316
K
Key positions in starter switch 31
Key, KEYLESS-GO* card
Changing the batteries 300
Key, mechanical 297
Key, SmartKey
Battery check lamp 81
Changing the batteries 299
Checking the batteries 82
Factory setting 81
Global locking 81
Global unlocking 81
Loss of 82
Positions in starter switch 31
Remote controls 80
Restoring to factory setting 81
Selective setting 81Starting the engine 43
Turning off the engine 51
Unlocking with 30
KEYLESS-GO start/stop button* 33
KEYLESS-GO* 349
Activating ignition with 33
Closing side windows 86
Closing sliding/pop-up roof 86
Closing sliding/pop-up roof
with 172, 175
Closing windows with 172, 175
Locking the vehicle 86
Messages in display 276
Starting the engine 43
Turning off engine 51
Unlocking with 32