2003 MERCEDES-BENZ CL55AMG high beam

Contents
Introduction.......................................... 9
Product information ................................ 9
Operator’s Manual ............................... 10
Service and Warranty Information.. 10
Important notice for California
retail buyers and lessees of
Mercedes-Benz automobiles .......... 11
Maintenance .................................. 12
Roadside Assistance ...................... 12
Change of address or ownership.... 12
Operating your vehicle
outside the USA or Canada ............ 13
Where to find it .................................... 14
Symbols ............................................... 15
Operating safety .................................. 16
Proper use of the vehicle ............... 16
Problems with your vehicle .................. 17
Reporting safety defects...................... 18
Reporting safety defects ................ 18
At a glance.......................................... 19
Cockpit ................................................. 20
Instrument cluster ................................ 22
Multifunction steering wheel ................ 24
Center console ..................................... 25
Upper part ...................................... 25
Lower part ...................................... 26
Overhead control panel ........................ 27
Door control panel................................ 28
Getting started................................... 29
Unlocking ............................................. 30
Unlocking with the SmartKey ......... 30
Unlocking with KEYLESS-GO*......... 32
Adjusting .............................................. 34
Seats .............................................. 34
Steering wheel ................................ 37
Mirrors ............................................ 38
Driving .................................................. 40
Fastening the seat belts ................. 40
Starting the engine ......................... 42
Switching on headlamps ................. 46
Turn signals and high beam ............ 46
Windshield wipers ........................... 47
Problems while driving .................... 48
Parking and locking .............................. 49
Parking brake ................................. 50
Switching off headlamps................. 50
Turning off engine ........................... 51

21 At a glance
Cockpit
Item
Page
1
Combination switch

Turn signals
46


Windshield wipers
47


High beam
111
2
Cruise control lever

Cruise control
176


Distronic*
179
3
Instrument cluster
22,
111
4
Multifunction steering
wheel
24,
118
5
Gear range indicator, clock
22
Item
Page
6
Lever for voice control sys-
tem* (see separate operat-
ing instructions)
7
Parking assist* (Parktronic)
right front area warning in-
dicator
195
8
Overhead control panel
27
9
Glove box lock
199
10
Glove box lid release
199
11
Glove box
199
12
Center console
25,
26
13
Starter switch
31
14
Horn
Item
Page
15
Steering wheel adjustment
stalk
37
Heated steering wheel*
208
16
Parking brake pedal
44
17
Hood lock release
237
18
Parking brake release
44
19
Door control panel
28
20
Exterior lamp switch
46,
108
21
Headlamp washer button
154
22
Parking assist* (Parktronic)
left front area warning indi-
cator
195

23 At a glance
Instrument cluster
Item
Page
1
Coolant temperature
gauge
115
2
Fuel gauge with:Fuel reserve warning lamp
268
3
L
Left turn signal
indicator lamp
K
Right turn signal
indicator lamp
46
46
4
Speedometer with:v
Electronic Stability
Program (ESP)
warning lamp
264
l
Distance warning
lamp
1
1Vehicles without Distronic*: Warning lamp without
function. It illuminates with SmartKey in starter
switch position2. It should go out when the engine
is running.
265
5
Tachometer
115
Item
Page
6
Right display with:-
Antilock Brake Sys-
tem (ABS) malfunc-
tion indicator lamp
265
A
High beam head-
lamp indicator
111
<
Seat belt nonusage
warning lamp
266
7
J
Reset button
114
8
Display with:
Program mode
147
Gear range indicator
145
Digital clock (see
COMAND operating
instructions)
9
Multifunction display
with:
Trip odometer
117
Main odometer
117
Item
Page
Stored speed for:Cruise control or
176
Distronic*
179
10
Outside temperature indi-
cator
115
11
Left display with:1
Supplemental
restraint system
indicator lamp
266
;
Brake warning
lamp, except
Canada
267
3
Brake warning
lamp, Canada only
267
?
Engine malfunction
indicator lamp
268
12
Knob for instrument clus-
ter illumination
114

46 Getting startedDrivingSwitching on headlampsExterior lamp switch1Off
2Low beam headlamps on
Turn the switch to
B
.More information can be found in the
“Controls in detail” section (
page 108).
Turn signals and high beam
The combination switch is on the left of the
steering column.Combination switch1Turn signals, right
2Turn signals, left
Press the combination switch up1 or
down2.High beam

Push the combination switch forward.
The high beam headlights are switched
on.
The high beam symbol
A
in the
tachometer lights up.
More information can be found in the
“Controls in detail” section (
page 111).
Warning!
G
On slippery road surfaces, never downshift
in order to obtain braking action. This could
result in drive wheel slip and reduced vehi-
cle control. Your vehicle’s ABS will not pre-
vent this type of loss of control.
iTo signal minor directional changes,
e.g. passing or changing lanes, move
combination switch to point of resis-
tance only and release. The turn signal
blinks three times.

108 Controls in detailLighting
LightingFor notes on how to switch on the head-
lamps and use the turn signals, see the
“Getting started” section (
page 46).
Exterior lamp switch
The exterior lamp switch is located on the
dashboard to the left of the steering wheel.
M
Off
U
Automatic headlamp mode
C
Parking lamps (also side marker
lamps, tail lamps, license plate
lamps, instrument panel lamps)
Canada only: When engine is run-
ning, the low beams are also
switched on.
B
Low beam plus parking lamps or
high beam headlamps (combination
switch pushed forward).
ˆ
Standing lamps, right (turn left one
stop)
‚
Standing lamps, left (turn left two
stops)
iIf you remove the key and open the
driver’s door while the parking lamps or
low beam headlamps are switched on,
then

a warning sounds


$
appears in the multifunction
display


the message
TURN OFF LIGHTS!
ap-
pears in the multifunction display
iWith the daytime running lamp mode
activated and the engine running, the
low beam headlamps cannot be
switched off manually.

110 Controls in detailLightingDaytime running lamp mode
Turn exterior lamp switch to
position
M
or
U
.
When the engine is running, the low beam
headlamps are automatically switched on.
In low ambient light conditions the parking
lamps will also switch on.
Canada only
When you shift from a driving gear to
positionN orP, the low beam switches off
(with a three-minute delay).
For nighttime driving you should turn the
exterior lamp switch to position
B
to
permit activation of the high beam head-
lamps.
USA only
The high beam headlamps can also be ac-
tivated when driving with the daytime run-
ning lamp mode activated and exterior
lamp switch in position
M
.To activate the daytime running lamp
mode, see “Setting daytime running lamp
mode” (
page 136).
Locator lighting and night security illu-
mination
Locator lighting and night security illumi-
nation are described in the control system
section under “Setting locator lighting”
(
page 136) and “Setting night security il-
lumination” (
page 137).
Switching on front fog lamps

Make sure that the low beam head-
lamps are switched on.

Pull out exterior lamp switch to first
stop.
The green indicator lamp
‡
in the
lamp switch lights up.Switching on rear fog lamp

Make sure that the low beam head-
lamps are switched on.

Pull out exterior lamp switch to second
stop.
The yellow indicator lamp
†
in the
lamp switch lights up.
iSee notes on the exterior lamp switch
(page 108).
iFog lamps will operate with the parking
lamps and / or the low beam head-
lamps on. Fog lamps should only be
used in conjunction with low beam
headlamps. Consult your State or Prov-
ince Motor Vehicle Regulations regard-
ing permissible lamp operation.

111 Controls in detail
Lighting
Combination switch
The combination switch is located on the
left side of the steering column.
1High beam
2High beam flasher
Switching on high beams
Turn exterior lamp switch to
position
B
(page 108).

Push the combination switch in
direction1.
The high beam symbol
A
is illumi-
nated on the instrument cluster.High beam flasher

Pull the combination switch briefly in
direction2.
Hazard warning flasher
The hazard warning flasher can be activat-
ed with the ignition switched on or off. It is
activated automatically when an airbag is
deployed.
The switch is located on the center con-
sole.
1Hazard warning flasher switchSwitching on the hazard warning
flasher

Press the hazard warning flasher
switch.
All turn signals will blink.
Switching off the hazard warning
flasher

Press hazard warning flasher switch
again.iWith the hazard warning flasher acti-
vated and the combination switch set
for either left or right turn, only the re-
spective left or right turn signal will op-
erate when the key in the starter switch
is in position 1 or 2.iIf the hazard warning flasher was acti-
vated automatically, press switch1
twice.

286 Practical hintsWhat to do if …?.
TURN SIG., RF
CHECK LIGHT!

BACK-UP LIGHT ON!

The right front turn signal lamp is malfunc-
tioning. A back-up bulb is being used.

Replace the bulb as soon as possible.
HIGH BEAM, L
CHECK LIGHT!
The left high beam flasher lamp is malfunc-
tioning.

Replace the bulb as soon as possible.
HIGH BEAM, R
CHECK LIGHT!
The right high beam lamp flasher is mal-
functioning.

Replace the bulb as soon as possible.
MARKER LIGHT, FL
CHECK LIGHT!

The front left side marker lamp is malfunc-
tioning.

Replace the bulb as soon as possible.
MARKER LIGHT, FR
CHECK LIGHT!

The front right side marker lamp is mal-
functioning.

Replace the bulb as soon as possible.
FR. L. PARK. LAMP
CHECK LIGHT!

BACK-UP LIGHT ON!

The left parking lamps are malfunctioning.
A back-up bulb is being used.

Replace the bulb as soon as possible.
FR. R. PARK. LAMP
CHECK LIGHT!

BACK-UP LIGHT ON!

The right parking lamps are malfunctioning.
A back-up bulb is being used.

Replace the bulb as soon as possible.
STANDING LIGHT, L
CHECK LIGHT!

BACK-UP LIGHT ON!

The left standing lamp is malfunctioning. A
back-up bulb is being used.

Replace the bulb as soon as possible.
Display
Possible cause
Possible solution