243 Operation
Tires and wheels
Tire pressure changes by approximately
1.5 psi (0.1 bar) per 18°F (10°C) of air
temperature change. Keep this in mind
when checking tire pressure where the
temperature is different from the outside
temperature.
The tire temperature and with it the tire
pressure is increased also while driving,
depending on the driving speed and the
tire load.Check the spare tire periodically for condi-
tion and inflation. Spare tire will age and
become worn over time even if never used,
and thus should be inspected and replaced
when necessary.
Rotating wheels
The wheels can be rotated every 3 000 to
6 000 miles (5 000 to 10 000 km), or soon-
er if necessary, according to the degree of
tire wear. The same direction of tire rota-
tion must be retained.
Rotate the wheels before the characteris-
tic tire wear pattern becomes visible
(shoulder wear on front wheels and tread
center wear on rear wheels).
Thoroughly clean the inner side of the
wheels after each rotation. Check and en-
sure proper tire inflation pressure.
iThe pressures listed for light loads are
minimum values offering high driving
comfort.
Increased inflation pressures listed for
heavier loads may also be used for light
loads. These higher pressures produce
favorable handling characteristics. The
ride of the vehicle, however, will be
somewhat harder. Never exceed the
max. values or inflate tires below the
min. values listed in the fuel filler flap.
Warning!
G
Follow recommended inflation pressures.
Do not overinflate tires. Overinflated tires
can result in sudden deflation (blowout) be-
cause they are more likely to become punc-
tured or damaged by road debris, potholes
etc.
Do not underinflate tires. Underinflated tires
wear unevenly, adversely affect handling
and fuel economy, and are more likely to fail
from being overheated.
Do not overload the tires by exceeding the
specified vehicle capacity weight (as indicat-
ed by the label on the pillar in the driver’s
door opening). Overloading the tires can
overheat them, possibly causing a blowout.
Warning!
G
Have the tightening torque checked after
changing a wheel. Wheels could become
loose if not tightened with a torque of
80 ft.lb. (110 Nm).
Use only genuine Mercedes-Benz wheel
bolts specified for your vehicle's rims.
S203 MY03_A.book Page 243 Tuesday, January 28, 2003 2:22 PM
366 IndexTilt
Backrest 33
Head restraint 34
Seat cushion 33
Time
Setting hours 118
Setting minutes 118
Time display
Setting 119
Tire inflation pressure
Checking 233, 242
Tire speed rating 227
Tire traction 227
Tires 241, 323
Consumer information 337
Direction of rotation 242
Driving instructions 226
Retreads 241
Rims and tires 323
Service life 242
Temperature 243
Temperature grades 338
Traction 337
Tread depth 244
Wear pattern 243
Winter 244Tools 279
Tow-away alarm 25
Arming 80
Disarming 80
Disarming for transport 80
Tow-away alarm* 80
Towing eye bolt (vehicle tool kit)
Installing 313
Towing the vehicle 310
Tracking services
For stolen vehicle 217
Traction 139, 343
Traction (Tires) 337
Transmission see Automatic
transmission 237
Transmission selector lever 289
Unlocking manually 289
Traveling abroad 229
Tread depth (tires) 244
Tread wear 337
Trim panel
Opening 315
Trip computer 128
Trip odometer
Resetting 105Trunk
Closing the lid 87
Trunk see Cargo compartment 87
Turn signal lamps
Replacing bulbs 292, 293
Turn signals 47
Additional in mirrors 292
Cleaning lenses 250
Front bulbs 292, 294, 296
Indicator lamps 23
Rear bulbs 293, 298
Turning off
Engine 52
Twin-reel roller blind
Installing 199
Luggage cover and partition net 197
Removing 198
U
Units
Setting speedometer units 119
Setting temperature units 119
Unlocking 30, 84
Centrally from inside 89
Driver’s door in an emergency 285
Fuel filler flap 232
Global 85S203 MY03_A.book Page 366 Tuesday, January 28, 2003 2:22 PM
