2003 MERCEDES-BENZ C240 WAGON remote start

214 Controls in detailUseful featuressystem mutes and the message
TELE AID
– ROADSIDE ASSISTANCE CALL ACTIVE
ap-
pears in the multifunction display.

Describe the nature of the need for as-
sistance.
The Mercedes-Benz Roadside assistance
dispatcher will either dispatch a qualified
Mercedes-Benz technician or arrange to
tow your vehicle to the nearest
Mercedes-Benz Center. For services such
as labor and/or towing, charges may ap-
ply. Refer to the Roadside Assistance man-
ual for more information.
These programs are only available in the
USA:


Sign and Drive services: Services such
as jump start, a few gallons of fuel or
the replacement of a flat tire with the
vehicle spare tire are obtainable.


Remote Vehicle Diagnostics: This func-
tion permits the Mercedes-Benz Road-
side Assistance dispatcher to
download malfunction codes and actu-
al vehicle data.Information button
¡
Located below the center armrest cover is
the Information button
¡
.

Press and hold the button (for longer
than 2 seconds).
A call to the Customer Assistance Cen-
ter will be initiated. The button will
flash while the call is in progress. The
message
INFO – CONNECTING CALL
will
appear in the multifunction display.
When the connection is established, the
message
INFO – CALL CONNECTED
appears
in the multifunction display. The Tele Aid
system will transmit data generating the
vehicle identification number, model, color
and location (subject to availability of cel-
lular and GPS signals).
A voice connection between the Customer
Assistance Center representative and the
occupants of the vehicle will be estab-
iThe indicator lamp in the Roadside As-
sistance button
•
remains illumi-
nated in red for approx. 10 seconds
during the system self-check after turn-
ing the key in the starter switch to
position2 (together with the SOS but-
ton and the Information button
¡
).
See system self-check (
page 211)
when the indicator lamp does not light
up in red or stays on longer than ap-
proximately 10 seconds.
If the indicator lamp in the Roadside
Assistance button
•
is illuminated
continuously and there was no voice
connection to the Response Center es-
tablished, then the Tele Aid system
could not initiate a Roadside Assis-
tance call (e.g. the relevant cellular
phone network is not available). The
message
ROADSIDE ASSISTANCE –
CALL FAILED
appears in the multifunc-
tion display.
Roadside Assistance calls can be ter-
minated using the
ì
button on the
multifunction steering wheel.
S203 MY03_A.book Page 214 Tuesday, January 28, 2003 2:22 PM

219 Controls in detail
Useful features
Programming or reprogramming the in-
tegrated remote control
Turn key in the starter switch to
position1 or2.

Hold the end of the hand-held transmit-
ter of the device you wish to train
approximately 2 to 5 inches (5 cm to
12 cm) away from the surface of the in-
tegrated remote control located on the
inside rear view mirror, keeping the in-
dicator lamp in view.

Using both hands, simultaneously push
the hand-held transmitter button and
the desired integrated remote control
button. Do not release the buttons until
completing next step.

The indicator lamp on the integrated
remote control will flash, first slowly
and then rapidly. The rapid flashing
lamp indicates successful program-
ming of the new frequency signal.

When the indicator lamp flashes rapid-
ly, release both buttons.

To program the remaining two buttons,
repeat the above steps.
Rolling code programming
To train a garage door opener (or other roll-
ing code devices) with the rolling code fea-
ture, follow these instructions after
completing the “Programming” portion of
this text. (A second person may make the
following training procedures quicker and
easier.)

Locate training button on the garage
door opener motor head unit. Exact location and color of the button
may vary by garage door opener brand.
If there is difficulty locating the trans-
mitting button, refer to garage door
opener operator’s manual.

Press “training” button on the garage
door opener motor head unit.
The “training light” is activated.
You have 30 seconds time to initiate the
following step.

Firmly press and release the pro-
grammed integrated remote control
transmit button.

Press and release same button a sec-
ond time to complete the training pro-
cess.
Some garage door openers may require
you to do this procedure a third time to
complete the training.

Confirm the garage door operation by
pressing the programmed button on
the integrated remote control transmit-
ter.
iIf, after several attempts, you do not
successfully program the integrated re-
mote control device to learn the signal
of the hand-held transmitter, the ga-
rage door opener could be equipped
with the “rolling code feature”.
S203 MY03_A.book Page 219 Tuesday, January 28, 2003 2:22 PM

220 Controls in detailUseful featuresCanadian programming
During programming, your hand-held
transmitter may automatically stop trans-
mitting. 
Continue to press and hold the inte-
grated remote control transmitter but-
ton (refer to steps two through four in
the “Programming” portion) while you
press and re-press (“cycle”) your
hand-held transmitter every two sec-
onds until the frequency signal has
been learned.
Upon successful training, the indicator
lamp will flash slowly and then rapidly
after several seconds.Operating the remote control

Turn key in starter switch to position1
or2.

Select and press the appropriate but-
ton to activate the remote controlled
device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.Erasing the remote control memory

Turn key in starter switch to position1
or2.

Simultaneously hold down the left and
right side buttons for approximately
20 seconds, or until the indicator lamp
blinks rapidly.
The codes of all three channels are
erased.iIf you sell your vehicle, erase the codes
of all three channels.
S203 MY03_A.book Page 220 Tuesday, January 28, 2003 2:22 PM

232 OperationAt the gas station
At the gas station
The fuel filler flap is located on the
right-hand side of the vehicle towards the
rear. Locking/unlocking the vehicle with
the remote control automatically
locks/unlocks the fuel filler flap.
Remove the key from the starter
switch.

Open the fuel filler flap by pushing at
the point indicated by the arrow.

Turn the fuel cap to the left and hold on
to it until possible pressure is released.

Take off the cap and set it in the recess
on the fuel filler flap.

Only fill your tank until the filler nozzle
unit cuts out – do not top up or overfill.

Replace the fuel cap by turning it to the
right.
You will hear when the fuel cap is tight-
ened.

Close the fuel filler flap.
Warning!
G
Gasoline is highly flammable and poisonous.
It burns violently and can cause serious inju-
ry. Whenever you are around gasoline, avoid
inhaling fumes and skin contact, extinguish
all smoking materials. Never allow sparks,
flame or smoking materials near gasoline!Warning!
G
Flexible Fuel Vehicles (MY 2003
Mercedes-Benz C 320 models, except those
equipped with manual transmission or
4MATIC*) only:
Ethanol fuel (E85) and its vapors are highly
flammable, poisonous and burn easily. Etha-
nol fuel can cause serious injuries if ignited
or if you come into contact with it or inhale
fumes of it. Avoid inhalation of Ethanol
fumes and skin contact with Ethanol. Extin-
guish all open flames before refueling. Never
smoke or create sparks close to Ethanol.
Warning!
G
Overfilling of the fuel tank may create pres-
sure in the system which could cause a gas
discharge. This could cause the gas to spray
back out when removing the fuel pump noz-
zle, which could cause personal injury.
S203 MY03_A.book Page 232 Tuesday, January 28, 2003 2:22 PM

351 Index
Downhill driving
Cruise control 191
Downshifting 134, 136
Drink holder see Cup holder 204
Drinking and driving 223
Driving
General instructions 40, 223
Hydroplaning 226
In winter 228
Problems 50
Safety systems 73
Through standing water 229
Traveling abroad 229
Driving instructions 223
Driving off 225
Driving safety systems
4MATIC 78
ABS 73
BAS 75
ESP 75
Driving systems 190
Cruise control 190
Driving safety systems 73E
Easy-entry/exit feature 90
Activating 126
Interrupting movement 126
Electrical fuses 314
Electrical outlet 208
Electrical system
Technical data 325
Electronic stability program (ESP) 340
Electronic Stability Program see ESP 23,
75
Emergency call
Telephone 181
Emergency call system* 210
Emergency calls
Initiating an emergency call 213
With Tele Aid* 211
Emergency operation (Limp Home
Mode) 140
Emergency operations
Closing sliding/pop-up roof 290
Locking the vehicle 286
Opening sliding/pop-up roof 290
Remote door unlock 217
Unlocking the vehicle 285
Emergency tensioning device (ETD) 340Emergency tensioning device see
ETD 64
Emission control 231
Emission control label 320
Ending
A call (telephone) 132
Engine
Compartment 234
Message in display 258
Starting with automatic
transmission 44
Starting with manual
transmission 44
Starting with the key 44, 45
Technical data 322
Turning off with the key 52
Engine cleaning 250
Engine compartment 234
Fuse box in 314
Hood 234
Engine malfunction indicator lamp 23,
258
Engine number 340
Engine oil 235, 330
Adding 236
Additives 330
S203 MY03_A.book Page 351 Tuesday, January 28, 2003 2:22 PM

353 Index
Reserve warning 23
Switching (Flexible fuel vehicle) 332
Technical data 328
Fuel additives 332
Fuel consumption statistics
After start 129
Since last reset 129
Fuel filler flap 232
Locking 232
Opening 288
Unlocking 232
Fuel requirements 331
Fuel reserve tank
Message in display 271
Fuel tank
Capacity 329
Filler flap 232
Fuel, coolants, lubricants etc.
Flexible fuel vehicles 329
Fuels, coolants, lubricants etc.
Capacities 328
Functions (control system) 108, 111
Resetting 117
Fuse box 314
Fuse chart 314
Fuse extractor 315Fuses 314
Auxiliary fuse box in cargo
compartment 315
Fuse box in engine compartment 314
Fuse box in passenger
compartment 314
Fuse chart 314
Fuse extractor 315
Spare fuses 315
G
Garage door opener 27, 218
Erasing in remote control 220
Integrated remote control 219
Rolling code programming 219
Gasoline see Fuel 233
Gasoline additives 332
Gear range 340
Automatic transmission 137
Limiting 137
Shifting into optimal 136
Gear range limit
Canceling 136
Gear selector lever
Cleaning 251
Position 138Global
Locking 85
Unlocking 85
Global positioning system (GPS) 340
Glove box 21, 203
Closing 203
Opening 203
Good visibility 141
GPS 340
GPS see COMAND* 216
H
Halogen-type
Front lamp bulbs 294
Hand-held transmitter
Programming integrated remote
control 219
Hands-free microphone 27
Hard plastic trim items
Cleaning 252
Hazard warning flasher 101
Switching off 101
Switching on 101
Head restraints 91
Manual seats 33
Power seats* 35
Rear seats 35
S203 MY03_A.book Page 353 Tuesday, January 28, 2003 2:22 PM

355 Index
Operating 220
Rolling code programming 219
Interior lighting 102
Activating automatic control 102
Deactivating automatic control 102
Delayed shut-off 124
Manual operation 102
Interior storage spaces 203
Armrest 206
Cup holder 204
Glove box 203
Parcel net in front passenger
footwell 206
Storage compartment in front of
armrest 205
Interval wiping 50
Switching off 50
Switching on 50
J
Jack 280
Jump starting 308
K
Key dependency memory
Settings 127
Key positions in starter switch 31Key, mechanical 285
Key, SmartKey
Battery check lamp 85
Changing the batteries 287
Checking the batteries 86
Factory setting 85
Global locking 85
Global unlocking 85
Loss of 86
Positions in starter switch 31
Remote control 84
Restoring to factory setting 85
Selective setting 85
Starting the engine 44, 45
Turning off the engine 52
Unlocking with 30
Keys 84
Kickdown 140, 341
Kilometers/miles in speedometer 119
Km/h or mph in speedometer 119
L
Labels, identification 320
Lamp bulbs, exterior 292
Lamps, exterior
Front 292
Light sensor 271Messages in display 272–275
Rear 293
Lamps, indicator and warning
ABS 255
Airbag Off 61
Battery (SmartKey) 85
CHECK ENGINE 258
Coolant 265
Engine diagnostics 258
ESP 254
Fuel reserve 258
Instrument cluster 254–258
Seat belts 258
Service indicator 246
SRS 57
Turn signals 23
Language
Multifunction display 120
Setting 120
LATCH child seat anchors 70
LATCH child seat anchors
Folding back 70
Layout of poly-V-belt drive 321
Leather upholstery
Cleaning 252
S203 MY03_A.book Page 355 Tuesday, January 28, 2003 2:22 PM