2003 MERCEDES-BENZ C240 WAGON brake light

275 Practical hints
What to do if …
Display
Possible cause
Suggested solution
.
TAIL LAMP, R
CHECK LAMP!

SUBSTITUTE LAMP ON!

The right tail lamp is malfunctioning. A
backup bulb is being used.

Visit an authorized Mercedes-Benz
Center as soon as possible.
SIDE MARKER LAMP, LF
CHECK LAMP!

SUBSTITUTE LAMP ON!

The left parking lamps are malfunctioning.
A backup bulb is being used.

Visit an authorized Mercedes-Benz
Center as soon as possible.
SIDE MARKER LAMP, RF
CHECK LAMP!

SUBSTITUTE LAMP ON!

The right parking lamps are malfunction-
ing. A backup bulb is being used.

Visit an authorized Mercedes-Benz
Center as soon as possible.
LIGHTS
TURN OFF LAMPS!
This display appears if the driver’s door is
opened with the engine shut off and no
key in the starter switch.

Insert key in the starter switch.

Switch off lights.
AUTOM. LIGHT ON
REMOVE KEY!
Key in the starter switch position1 or2.

Remove key from the starter switch.
!
(Canada only)
;
(USA only)
PARKING BRAKE
RELEASE PARKING BRAKE!
You are driving with the parking brake set.

Release the parking brake
(page 46).
<
SEAT BELT SYSTEM
VISIT WORKSHOP!
The seat belt system is malfunctioning.

Visit an authorized Mercedes-Benz
Center as soon as possible.
S203 MY03_A.book Page 275 Tuesday, January 28, 2003 2:22 PM

293 Practical hints
Replacing bulbs
Rear lamps Notes on bulb replacement


Use only 12 volt bulbs of the same type
and with the specified watt rating.


Switch lights off before changing a bulb
to prevent short circuits.


Always use a clean lint-free cloth when
handling bulbs.


Your hands should be dry and free of oil
and grease.


If the newly installed bulb does not light
up, visit an authorized Mercedes-Benz
Center.


Have the LEDs and bulbs for the follow-
ing lamps replaced by an authorized
Mercedes-Benz Center:

Additional turn signals in the
exterior rear view mirrors


High mounted brake lamp


Xenon lamps


Front fog lamps
Lamp
Type
7
High mounted brake
lamp
LED
8
Brake lamp
P21W
9
Turn signal lamp
PY 21 W
10
Backup lamp
P21W
11
Tail, parking, stand-
ing and side marker
lamp
P21/4W
12
License plate lamps
C5W
13
Rear fog lamp,
driver’s side
P21/4W
Warning!
G
Keep bulbs out of reach of children.
Bulbs and bulb sockets can be very hot. Al-
low the lamp to cool down before changing
a bulb.
Halogen lamps contain pressurized gas.
A bulb can explode if you:

touch or move it when hot


drop the bulb


scratch the bulb
Wear eye and hand protection.
Because of high voltage in Xenon lamps, it is
dangerous to replace the bulb or repair the
lamp and its components. We recommend
that you have such work done by a qualified
technician.
S203 MY03_A.book Page 293 Tuesday, January 28, 2003 2:22 PM

298 Practical hintsReplacing bulbs4Brake lamp
5Turn signal lamp
6Backup lamp
7Rear fog lamp (driver’s side)/tail lamp,
parking, standing and side marker
lamp

Twist bulb socket counterclockwise
and pull out.

Gently push bulb into socket, turn
counterclockwise and remove.

Insert new bulb and reinstall bulb sock-
et.

Reinstall bulb holder and close trim
panel.License plate lamp
1Screws

Switch off the lights.

Loosen both screws1 and remove
lamp.

Replace the tubular lamp and reinstall
lamp.

Retighten the screws.
S203 MY03_A.book Page 298 Tuesday, January 28, 2003 2:22 PM

309 Practical hints
Jump starting
The battery is located in the engine com-
partment on the right hand side. The termi-
nals for jump starting are located in front
of the battery.
Make sure that the two vehicles do not
touch.

Turn off all electrical consumers.

Apply parking brake.

Shift selector lever to positionP (man-
ual transmission to Neutral).1Positive terminal of charged battery
2Positive under hood terminal in front of
discharged battery
3Negative terminal of charged battery
4Negative under hood terminal in front
of discharged battery

Connect positive terminal1 of the
charged battery with the under hood
terminal2 in front of the discharged
battery with the jumper cables. Clamp
cable to charged battery1 first.

Start engine of the vehicle with the
charged battery and run at idle speed.

Connect negative terminal3 of the
charged battery with the under hood
terminal4 in front of the discharged
battery with the jumper cables. Clamp
cable to charged battery3 first.

Start the engine of the disabled vehi-
cle.
Now you can again turn on the electrical
consumers. Do not turn on the lights under
any circumstances.

Remove the jumper cables first from
negative terminals3 and4 and then
from positive terminals1 and2.

Have the battery checked at the near-
est authorized Mercedes-Benz Center.
Warning!
G
Keep flames or sparks away from battery.
Do not smoke.
Observe all safety instructions and precau-
tions when handling automotive batteries
(page 239).
!Vehicles with automatic transmission
or 4MATIC*:
Do not tow-start the vehicle.
S203 MY03_A.book Page 309 Tuesday, January 28, 2003 2:22 PM

339 Technical terms
ABS
(Antilock Brake System)
Prevents the wheels from locking up
during braking so that the vehicle can
continue to be steered.
Alignment bolt
Metal pin with thread. The centering pin is
an aid used when changing a tire to align
the wheel with the wheel hub.
BabySmartTM airbag deactivation
system
This system detects if a special system
compatible child restraint seat is installed
on the front passenger seat. The system
will automatically deactivate the passen-
ger front airbag when such a seat is prop-
erly installed (indicator lamp 7 on the
center console lights up). See your autho-
rized Mercedes-Benz Center for availabili-
ty.BabySmartTM compatible child seats
Special restraint system for children. The
sensor system for the passenger seat pre-
vents deployment of the passenger side
airbag if a BabySmartTM compatible child
seat is installed.
BAS
(Brake Assist System)
System for potentially reducing braking
distances in emergency braking situa-
tions. The system is activated when it
senses an emergency based on how
fast the brake is applied.
Bi-xenon headlamps*
Headlamps which use an electric arc as
the light source and produce a more in-
tense light than filament headlamps. Bi-xe-
non headlamps produce low beam and
high beam.CAC
(Customer Assistance Center)
Mercedes-Benz customer service cen-
ter, which can help you with any ques-
tions about your vehicle and provide
assistance in the event of a break-
down.
CAN system
(Controller Area Network)
Data bus network serving to control ve-
hicle functions such as door locking or
windshield wiping depending on vehi-
cle settings and/or ambient condi-
tions.
Cockpit
All instruments, switches, buttons and in-
dicator/warning lamps in the passenger
compartment needed for vehicle operation
and monitoring.
S203 MY03_A.book Page 339 Tuesday, January 28, 2003 2:22 PM

346 IndexAir volume
Adjusting 147, 155
AIRBAG OFF indicator lamp 259
Airbags 57
BabySmart
TM deactivation
system 67
Children 58
Front 60
Passenger 60
Safety guidelines 59
Side impact 61
Window curtain 61
Alarm
Audible 72, 80
Canceling 80
Visual 79
Alarm system
Anti-theft 79
Alignment bolt 302, 339
Anticorrosion/antifreeze 335
Antiglare
Automatic 141
Antilock brake system (ABS) 339
Anti-theft alarm system
Arming 79
Canceling alarm 80Disarming 80
Anti-theft systems 79
Anti-theft alarm system* 79
Immobilizer 79
Tow-away alarm 80
Aquaplaning see Hydroplaning 226
Armrest
Storage compartment in front of 205
Storage spaces 206
Ashtray 207
ATF (automatic transmission fluid) 237
AUDIO menu 112
Selecting radio station 113
Audio system
Audio and telephone, operation 161
Button and soft key operation 164
Cassette mode 170
CD mode 174
Operating and display elements 162
Operating safety 161
Operation 164
Radio mode 167
Switching off 164
Switching on 164
Telephone operation 178
Audio systems 161Automatic antiglare for rear view
mirror 141
Automatic central locking
Activating/deactivating (control
system) 125
Automatic climate control 152
Adjusting air distribution 155
Air recirculation mode 156
Deactivating 150
Defrosting 156
Rear window defroster 158
Residual heat utilization 159
Residual ventilation 159
Setting the temperature 154
Automatic headlamp mode 99
Automatic lighting control
Activating 102
Deactivating 102
Automatic locking when driving 88
Automatic transmission 135
Accelerator position 140
Emergency operation (Limp Home
Mode) 140
Fluid level 237
Gear ranges 137
Gear selector lever position 138
S203 MY03_A.book Page 346 Tuesday, January 28, 2003 2:22 PM

359 Index
Overhead control panel 27
P
Paintwork 249
Panic alarm 72
Panic button on SmartKey 72
Parcel net
In cargo compartment 196
In front passenger footwell 206
Parking 51, 225
Parking brake 46, 51
Engaging 51
Message in display 275
Releasing 46
Parking lamps
Replacing bulbs 292, 293, 295, 296
Switching on 98
Parking position
Exterior rear view mirrors 97, 128,
142
Partition net 197
Parts see Spare parts service 318
Passenger compartment 229
Fuse box in 314
Inside rear view mirror 38
Interior lighting 102Parcel net in front passenger
footwell 206
Passenger safety see Occupant
safety 56
Pedals 223
Performance
In cold weather 333
In hot weather 333
Phone book*
Loading 132
Quick search 133
Phone number*
Dialing 132
Redialing 133
Plastic and rubber parts
Cleaning 252
Playing
CDs 175
Poly-V-belt drive 341
Layout 321
Positions (Memory function*)
Recalling from memory 96
Storing into memory 96
Power assistance 223Power seat*
Adjusting 34
Adjusting backrest tilt 35
Adjusting head restraint height 35
Adjusting head restraint tilt 35
Adjusting seat cushion tilt 35
Adjusting seat height 35
Front seat head restraints 91
Seat fore and aft adjustment 34
Power train 342
Power washer 249
Power windows 184
Blocking of rear door window
operation 71
Side windows 184
Synchronizing 186
Practical hints
First aid kit 279
Fuses 314
Lamp in center console 259
Lamps in instrument cluster 254
Messages in the display 260
Spare wheel 281
Spare wheel bolts 282
Towing the vehicle 310
Vehicle jack 280
S203 MY03_A.book Page 359 Tuesday, January 28, 2003 2:22 PM