2003 MERCEDES-BENZ C230 COUPE sensor

49 Getting started
Driving
Single wipe
Press switch briefly in the direction of
arrow1.
The windshield wipers wipe one time
without washer fluid.
Wiping with windshield washer fluid

Push switch in the direction of arrow1
past the resistance point.
The windshield wiper operates with
washer fluid.
iVehicles without rain sensor*: Fast
wiper speed III goes to setting II when
the vehicle is standing still.
Vehicles with rain sensor*: Intermittent
wiping interval dependent on wetness
of windshield. Wiping will not occur
with a door open.!Vehicles with rain sensor*: Do not
leave in intermittent setting when vehi-
cle is taken to an automatic car wash or
during windshield cleaning. Wipers will
operate in presence of water sprayed
on the windshield, and wipers may be
damaged as a result.
The switch should not be left in inter-
mittent setting as the wipers will wipe
the windshield once every time the en-
gine is started. Dust that accumulates
on the windshield might scratch the
glass when wiping occurs on a dry
windshield.
!If leaves, snow, etc. block the wind-
shield wipers, switch off the wipers.

For safety reasons, withdraw key
from starter switch. Remove block-
age.


Turn the windshield wipers on
again.
If windshield wipers fail to function at
all in switch positionI,


set the combination switch to the
next highest wiper speed.


have the windshield wipers
checked at the nearest authorized
Mercedes-Benz Center.

104 Controls in detailInstrument clusterOutside temperature indicatorThe temperature sensor is located in the
front bumper area. Due to its location, the
sensor can be affected by road or engine
heat during idling or slow driving. This
means that the accuracy of the displayed
temperature can only be verified by com-
parison to a thermometer placed next to
the sensor, not by comparison to external
displays (e.g. bank signs etc.).When moving the vehicle into colder ambi-
ent temperatures (e.g. when leaving your
garage), you will notice a delay before the
lower temperature is displayed.
A delay also occurs when ambient temper-
atures rise. This prevents inaccurate tem-
perature indications caused by heat
radiated from the engine during idling or
slow driving.Warning!
G
The outside temperature indicator is not de-
signed to serve as an ice-warning device and
is therefore unsuitable for that purpose.
Indicated temperatures just above the freez-
ing point do not guarantee that the road sur-
face is free of ice. The road may still be icy,
especially in wooded areas or on bridges.

138 Controls in detailGood visibility
Good visibilityInformation on the windshield wipers
(page 48) and for setting the rear view
mirrors (
page 39) is found in the “Get-
ting started” section.
Rear view mirror
Inside rear view mirror, antiglare posi-
tion
Tilt the mirror to the antiglare night posi-
tion using the lever at its lower edge.Automatic antiglare rear view mirror*
The reflection brightness of the exterior
rear view mirror on the driver’s side and
the inside rear view mirror will respond au-
tomatically to glare when


the ignition is switched on, and


incoming light from headlamps falls on
the sensor in the inside rear view mir-
ror.The rear view mirror will not react if


reverse gear is engaged


the interior lighting is turned onWarning!
G
The automatic antiglare function does not
react if incoming light is not aimed directly
at sensors in the inside rear view mirror.
The inside rear view mirror and the exterior
rear view mirror on the driver’s side do not
react, for example, if the rear window sun-
shade is in raised position.
Glare can endanger you and others.

222 OperationDriving instructionsControl and operation of radio trans-mitter
COMAND*, radio and telephone*Telephones and two-way radios
Radio transmitters, such as a portable tele-
phone or a citizens band unit should only
be used inside the vehicle if they are con-
nected to an antenna that is installed on
the outside of the vehicle.
Refer to the radio transmitter operation in-
structions regarding use of an external an-
tenna.
Catalytic converter
Your Mercedes-Benz is equipped with
monolithic type catalytic converters, an
important element in conjunction with the
oxygen sensors to achieve substantial con-
trol of the pollutants in the exhaust emis-
sions. Keep your vehicle in proper
operating condition by following our rec-
ommended maintenance instructions as
outlined in your Service Booklet.
Warning!
G
Please do not forget that your primary re-
sponsibility is to drive the vehicle safely.
Only operate the COMAND (Cockpit Man-
agement and Data System), radio or tele-
phone
1 if road, weather and traffic
conditions permit.
Bear in mind that at a speed of just 30 mph
(approximately 50 km / h), your vehicle is
covering a distance of approximately
44 feet (approximately 13.5 m) every sec-
ond.
1Observe all legal requirements
Warning!
G
Never operate radio transmitters equipped
with a built-in or attached antenna (i.e. with-
out being connected to an external antenna)
from inside the vehicle while the engine is
running. Doing so could lead to a malfunc-
tion of the vehicle’s electronic system, pos-
sibly resulting in an accident and/or
personal injury.
!To prevent damage to the catalytic con-
verters, use only premium unleaded
gasoline in this vehicle.
Any noticeable irregularities in engine
operation should be repaired promptly.
Otherwise, excessive unburned fuel
may reach the catalytic converter,
causing it to overheat and start a fire.

263 Practical hints
What to do if …
When the “ENGINE OIL LEVEL – CHECK
LEVEL!” message appears while the engine
is running and at operating temperature,
the engine oil level is low.
When this occurs, the warning will first
come on intermittently and then stay on if
the oil level drops further.If no oil leaks are noted, continue to drive
to the nearest gas station where the en-
gine oil should be filled up with an ap-
proved oil (
page 227).
!The engine oil level warnings should
not be ignored. Extended driving with
the symbol displayed could result in se-
rious engine damage that is not cov-
ered by the Mercedes-Benz Limited
Warranty.
Display
Possible cause
Suggested solution
A
RESERVE FUEL
VISIT FILLING STATION!
The fuel level has dropped below the re-
serve mark.

Refuel at the next gas station
(page 224).
Y
HOOD OPEN!
You are driving with the hood open.

Close the hood (
page 226).
I
REPLACE KEY
VISIT WORKSHOP!
No additional code available for SmartKey.

Change the batteries (
page 294).
AUTOM. LIGHT ON
REMOVE KEY!
You have forgotten to remove the key.

Remove the key from the starter
switch.
.
LAMP SENSOR
VISIT WORKSHOP!
The lamp sensor is malfunctioning. The
headlamps switch on automatically.

Set lamp operation to manual.

Switch on headlamps using the exte-
rior lamp switch.

327 Technical terms
ABS
(A
ntilock B
rake S
ystem)
Prevents the wheels from locking up
during braking so that the vehicle can
continue to be steered.
Alignment bolt
Metal pin with thread. The centering
pin is an aid used when changing a tire
to align the wheel with the wheel hub.
BabySmart
TM
airbag deactivation
system
This system detects if a special system
compatible child restraint seat is in-
stalled on the front passenger seat. The
system will automatically deactivate
the passenger front airbag when such a
seat is properly installed (indicator
lamp
7
in the center console lights
up). See your authorized
Mercedes-Benz Center for availability.BabySmart
TM
compatible child seats
Special restraint system for children.
The sensor system for the passenger
seat prevents deployment of the pas-
senger side airbag if a BabySmart
TM
compatible child seat is installed.
BAS
(B
rake A
ssist S
ystem)
System for potentially reducing braking
distances in emergency braking situa-
tions. The system is activated when it
senses an emergency based on how
fast the brake is applied.
Bi-Xenon headlamps*
Headlamps which use an electric arc as
the light source and produce a more in-
tense light than filament headlamps.
Bi-Xenon headlamps produce low
beam and high beam.CAC
(C
ustomer A
ssistance C
enter)
Mercedes-Benz customer service cen-
ter, which can help you with any ques-
tions about your vehicle and provide
assistance in the event of a break-
down.
CAN system
(C
ontroller A
rea N
etwork)
Data bus network serving to control ve-
hicle functions such as door locking or
windshield wiping.
Cockpit
All instruments, switches, buttons and
indicator/warning lamps in the passen-
ger compartment needed for vehicle
operation and monitoring.

342 IndexInflating
Spare tire 292
Information
Button for Tele Aid* 206
Inside rear view mirror
Adjusting 39
Antiglare 138
Installing
Infant and child restraint systems 69
Towing eye bolt 302
Wiper blades 287
Instrument cluster 22, 102, 329
Cleaning 243
Coolant temperature gauge 102
Illumination 102
Lamps in 246–250
Multifunction display 105
Outside temperature indicator 104
Selecting language 118
Instruments and controls see Cockpit 20
Integrated remote control
Canadian programming 211
Erasing memory 212
Hand-held transmitter 210
Operating 212
Rolling code programming 211Interior lighting 100
Activating automatic control 100
Deactivating automatic control 100
Delayed shut-off 121
Manual operation 100
Interior storage spaces 195
Armrest 197
Cup holder 196
Glove box 195
Parcel net in front passenger footwell
198
Storage compartment in front of arm-
rest 196
J
Jack 272
Jump starting 297
K
Key dependency memory
Settings 124
Key positions in starter switch 31
Key, mechanical 274, 275
Key, SmartKey
Battery check lamp 83
Changing the batteries 276
Checking the batteries 84Factory setting 83
Global locking 83
Global unlocking 83
Loss of 84
Positions in starter switch 31
Remote controls 82
Restoring to factory setting 83
Selective setting 83
Starting the engine 45
Turning off the engine 53
Unlocking with 30
Keys 82
Kickdown 137, 329
Kilometers/miles in speedometer 117
Km/h or mph in speedometer 117
L
Labels, identification 308
Lamp bulbs, exterior 280
Lamps, exterior
Front 280
Light sensor 263
Messages in display 264–267
Rear 281

343 Index
Lamps, indicator and warning
ABS 247
Airbag Off 61
Battery (SmartKey) 83
Brakes 249
CHECK ENGINE 250
Coolant 257
Engine diagnostics 250
ESP 246
Fuel reserve 250
Instrument cluster 246–250
Seat belts 250
Service indicator 238
SRS 57
Turn signals 23
Language
Multifunction display 118
Setting 118
LATCH child seat mounts 70
Folding back 70
Layout of poly-V-belt drive 309
Leather upholstery
Cleaning 244
License plate lamps
Messages in display 266
Replacing bulbs 281, 286Light alloy wheels
Cleaning 243
Technical data 311
Light sensor 263
Lighter see Cigarette lighter 199
Lighting 96
Automatic headlamp mode 97
Combination switch 99
Daytime running lamp mode 98
Exterior lamp switch 96
Front fog lamps 98
High beam flasher 99
High beams 99
Instrument cluster illumination 102
Interior 100
Locator lighting 98
Low beam 96
Manual headlamp mode 97
Night security illumination 98
Parking lamps 96
Rear fog lamp 98
Settings (control system) 119
Trunk 101
Limiting the gear range 134
Limp Home Mode 137Loading 192
Instructions 194
Roof rack 192
Split rear bench seat 192
Locator lighting 98
Setting 120
Lock button 329
Lock buttons 329
Locking 51, 82
Fuel filler flap 224
Global, SmartKey 83
Vehicle in an emergency 275
Loss of keys 84
Loss of Service and Warranty Information
Booklet 307
Low beam headlamps
Messages in display 264
Replacing bulbs 280, 282
Lowering
Vehicle 291
Lubricants
Technical data 317
Luggage cover 192
M
Main dimensions 315
Maintenance 238