2003 MAZDA MODEL PROTÉGÉ climate control

6-7
Interior Comfort
Climate Control System
Form No. 8Q94-EA-02G
Recirculated air position ( )
Outside air is shut off. Air within the
vehicle is recirculated.
This position can be used when driving on
a dusty road or in similar conditions. It
also helps to provide quicker cooling of
the interior.

Heating
1. Set the mode selector dial to the
position.
2. Set the temperature control dial to the
hot position.
3. Set the fan control dial to the desired
speed.

Cooling (With Air Conditioner)
1. Set the mode selector dial to the
position.
2. Set the temperature control dial to the
desired position.
3. Set the fan control dial to the desired
speed.
4. Turn on the air conditioner.
The Recirculated Air Position:
Using the position in cold or
rainy weather will cause the glass to
fog up. Your vision will be hampered,
which could lead to a serious
accident. Do not use the
position in cold or rainy weather.
WARNING
NOTE
•If the windshield fogs up easily, set
the mode selector dial to the
position.
•If cooler air is desired at face level,
set the mode selector dial at the
position and adjust the temperature
control dial to maintain maximum
comfort.
•The air to the floor is warmer than
air to the face (except when the
temperature control dial is set at the
extreme hot or cold position).
•In the position, the outside air is
automatically selected.
J39L_EA.book Page 7 Saturday, June 8, 2002 5:35 PM

6-8
Interior Comfort
Climate Control System
Form No. 8Q94-EA-02G
5. Adjust the fan control dial and
temperature control dial to maintain
maximum comfort.
Ve n t i l a t i o n
1. Set the mode selector dial to the
position.
2. Set the air intake selector to the
position.
3. Set the temperature control dial to the
desired position.
4. Set the fan control dial to the desired
speed.

Windshield Defrosting and
Defogging
1. Set the mode selector dial to the
position.
2. Set the temperature control dial to the
desired position. When using the air conditioner while
driving up long hills or in heavy traffic,
closely monitor the temperature gauge
(page 5-25).
The air conditioner may cause engine
overheating. If the gauge indicates
overheating, turn the air conditioner
off.
NOTE
•When maximum cooling is desired,
set the temperature control dial to
the extreme cold position and set
the air intake selector to the
position, then set the fan control dial
to the position 4.
•If warmer air is desired at floor
level, set the mode selector dial at
the position and adjust the
temperature control dial to maintain
maximum comfort.
•The air to the floor is warmer than
air to the face (except when the
temperature control dial is set at the
extreme hot or cold position).
CAUTION
J39L_EA.book Page 8 Saturday, June 8, 2002 5:35 PM

6-9
Interior Comfort
Climate Control System
Form No. 8Q94-EA-02G
3. Set the fan control dial to the desired
speed.
Dehumidifying (With Air
Conditioner)
Operate the air conditioner in cool or cold
weather to help defog the windshield and
side windows.
1. Set the mode selector dial to the
desired position.
2. Set the air intake selector to the
position.
3. Set the temperature control dial to the
desired position.
4. Set the fan control dial to the desired
speed.
5. Turn on the air conditioner.
Foggy Windshield:
Using the position with the
temperature control set to the cold
position will cause the outside of the
glass to fog up. Your vision will be
hampered, which could lead to a
serious accident. Set the temperature
control to the hot or warm position
when using the position.
NOTE
•For maximum defrosting, set the
temperature control dial to the
extreme hot position and the fan
control dial to position 4.
•If warm air is desired at the floor,
set the mode selector dial to the
position.
•In the or position, outside air
is automatically selected. The air
intake selector cannot be changed to
the position.
WARNING
J39L_EA.book Page 9 Saturday, June 8, 2002 5:35 PM

9-12
Customer Information
Form No. 8Q94-EA-02G
Uniform Tire Quality Grading System (UTQGS)
This information relates to the tire grading system developed by the U.S. National
Highway Traffic Safety Administration for grading tires by tread wear, traction, and
temperature performance.

Tr e a d We a r
The tread wear grade is a comparative rating based on the wear rate of the tire when tested
under controlled conditions on a specified government test course.
For example, a tire graded 150 would wear one-and-a-half times as well on the government
course as a tire graded 100.
The relative performance of tires depends upon the actual conditions of their use, however,
and may depart significantly from the norm because of variations in driving habits, service
practices and differences in road characteristics and climate.

Traction-AA, A, B, C
The traction grades, from highest to lowest, are AA, A, B, and C. These grades represent
the tire’s ability to stop on wet pavement as measured under controlled conditions on
specified government test surfaces of asphalt and concrete. A tire marked C may have poor
traction performance.

Te m p e r a t u r e - A , B , C
The temperature grades are A (the highest), B, and C, represent the tire’s resistance to the
generation of heat and its ability to dissipate heat when tested under controlled conditions
on a specified indoor laboratory test wheel.
Sustained high temperature can cause the material of the tire to degenerate and reduce tire
life, and excessive temperatures can lead to sudden tire failure.
Grade C corresponds to a level of performance which all passenger vehicle tires must meet
under the Federal Motor Vehicle Safety Standard No. 109. Grades B and A represent
higher levels of performance on the laboratory test wheel than the minimum required by
law.
Uniform Tire Quality Grading System (UTQGS)
The traction grade assigned to this tire is based on braking (straight ahead) traction
tests and does not include acceleration cornering (turning), hydroplaning, or peak
traction characteristics.
WARNING
J39L_EA.book Page 12 Saturday, June 8, 2002 5:35 PM

11-2
Form No. 8Q94-EA-02G
Index
A
Add-On Non-Genuine Parts and
Accessories
...................................... 9-10
Air Bag Systems
.............................. 2-36
Air Filter
.......................................... 8-19
Antenna
............................................ 6-10
Anti-Lock Brake System (ABS)
........ 5-7
Warning light
.............................. 5-7
Appearance Care
.............................. 8-42
Ashtray
............................................. 6-38
Audio System
................................... 6-10
Audio set
................................... 6-17
Operating tips for
audio system
............................. 6-11
Safety certification
.................... 6-34
Automatic Transaxle
Driving tips
............................... 5-12
Fluid
.......................................... 8-16
Overdrive
.................................. 5-11
Shift-lock system
...................... 5-11
Transaxle ranges
....................... 5-10
Automatic Transaxle (Sport AT)
Driving tips
............................... 5-18
Indicators
.................................. 5-15
Manual shift mode
.................... 5-15
Shifting
..................................... 5-16
Shifting recommendation
......... 5-17
Shift-lock override
.................... 5-14
Shift-lock system
...................... 5-14
Transaxle ranges
....................... 5-13
B
Battery
Maintenance
............................. 8-23
Specifications
........................... 10-4
Beeps
Ignition key reminder
............... 5-35
Lights-on reminder
................... 5-35
B
Seat belt warning beep .............. 5-35
Before Starting the Engine
................. 4-5
After getting in
............................ 4-5
Before getting in
......................... 4-5
Body Lubrication
............................. 8-19
Brake/Clutch
Fluid
.......................................... 8-14
Brakes
Anti-lock brake system (ABS)
....5-7
Foot brake
................................... 5-4
Pad wear indicator
...................... 5-8
Parking brake
.............................. 5-5
Warning light
.............................. 5-5
Break-In Period
.................................. 4-6
Bulb Replacement
............................ 8-29
C
Capacities ......................................... 10-5
Carbon Monoxide
.............................. 4-4
Cargo Securing Loops
...................... 6-39
Catalytic Converter
............................ 4-3
Cell Phones
...................................... 9-11
Center Console
................................. 6-39
Child Restraint
Child restraint precautions
........ 2-22
Installing child-restraint
systems
...................................... 2-25
LATCH child-restraint
systems
...................................... 2-31
Child Safety Locks for Rear Door
..... 3-8
Cigarette Lighter
.............................. 6-37
Climate Control System
.....................6-2
Gas specifications
..................... 10-6
Cruise Control
.................................. 5-19
Cup Holder
....................................... 6-38
Customer Assistance
.......................... 9-2
J39L_EA.book Page 2 Saturday, June 8, 2002 5:35 PM