
3-3
STARTING & OPERATING
STARTING & OPERATING STARTING & OPERATING
STARTING & OPERATING
STARTING & OPERATING
GT30060A
4. Operate the accelerator pedal as described
below in accordance with the atmospheric temperature and/or engine condition.
(1) When the atmospheric temperature is moderate or the engine is warm: Start the engine without depressing the accelerator pedal.
(2) When the atmospheric temperature is low and the engine is cold: Start the engine while depressing the accelerator pedal. If the atmospherictemperature is very low, setting the igni-tion switch to ON for one or two sec-onds before attempting to start the en-gine will make it easier to start.
5. Start the engine D041A02P-GAT
STARTING AND STOPPING THE EN-
STARTING AND STOPPING THE EN- STARTING AND STOPPING THE EN-
STARTING AND STOPPING THE EN-
STARTING AND STOPPING THE EN-
GINE FOR TURBO CHARGER OR
GINE FOR TURBO CHARGER OR GINE FOR TURBO CHARGER OR
GINE FOR TURBO CHARGER OR
GINE FOR TURBO CHARGER OR
TURBO CHARGER INTERCOOLER
TURBO CHARGER INTERCOOLER TURBO CHARGER INTERCOOLER
TURBO CHARGER INTERCOOLER
TURBO CHARGER INTERCOOLER
(If installed)
(If installed) (If installed)
(If installed)
(If installed)
(1) Do not race the engine or sudden accelerate the engine immediately after start it. If theengine is cold, allow the engine to idle forseveral seconds before it is driven to ensuresufficient lubrication of the turbo chargerunit.
(2) After high speed or extended driving, requir- ing a heavy engine load, the engine shouldbe allowed to idle, as shown in the chartbelow, before turning it off. This idle time will allow the turbo charger to cool prior to shutting the engine off.
Required Idle Time
Required Idle Time Required Idle Time
Required Idle Time
Required Idle Time
High speed driving Driving Condition
Driving Condition Driving Condition
Driving Condition
Driving Condition
Normal drivingNot necessary About 20 seconds About 1 minute
Up to 100km/h
Up to 80 km/h
Steep mountain slopes or contin- ued driving in excess of 100km/h About 2 minutes
WARNING:
WARNING: WARNING:
WARNING:
WARNING:
Do not turn the engine off immediately after
Do not turn the engine off immediately after Do not turn the engine off immediately after
Do not turn the engine off immediately after
Do not turn the engine off immediately after
it has been subjected to a heavy load. Doing
it has been subjected to a heavy load. Doing it has been subjected to a heavy load. Doing
it has been subjected to a heavy load. Doing
it has been subjected to a heavy load. Doing
so may cause severe damage to the engine
so may cause severe damage to the engine so may cause severe damage to the engine
so may cause severe damage to the engine
so may cause severe damage to the engine
or turbo charger unit.
or turbo charger unit. or turbo charger unit.
or turbo charger unit.
or turbo charger unit.
D040A01P-GAT
Tips for starting
Tips for starting Tips for starting
Tips for starting
Tips for starting
(1) Do not operate the starter motor continu-
ously for longer than ten seconds; doing so could run down the battery. If the enginedoes not start, turn the ignition switch backto "LOCK", wait a few minutes, and then tryagain.
(2) If the engine cannot be started because the battery is weak or dead, refer to the emer-gency starting section for instructions onEmergency Starting.
(3) After starting the engine, do not keep the engine idling without driving. Once when the atmospheric temperature is very low, warm up the engine at a high idlingspeed to ensure proper circulation of the oil.
CAUTION:
CAUTION: CAUTION:
CAUTION:
CAUTION:
(1)(1)
(1)(1)
(1) Do not run the engine at high rpm or
Do not run the engine at high rpm or Do not run the engine at high rpm or
Do not run the engine at high rpm or
Do not run the engine at high rpm or
drive the vehicle at high speed until the
drive the vehicle at high speed until the drive the vehicle at high speed until the
drive the vehicle at high speed until the
drive the vehicle at high speed until the
engine has had a chance to warm up.
engine has had a chance to warm up. engine has had a chance to warm up.
engine has had a chance to warm up.
engine has had a chance to warm up.
(2)(2)
(2)(2)
(2) Release the ignition key as soon as the
Release the ignition key as soon as the Release the ignition key as soon as the
Release the ignition key as soon as the
Release the ignition key as soon as the
engine starts to avoid damaging the
engine starts to avoid damaging the engine starts to avoid damaging the
engine starts to avoid damaging the
engine starts to avoid damaging the
starter motor.
starter motor. starter motor.
starter motor.
starter motor.

IN CASE OF EMERGENCY
IN CASE OF EMERGENCY IN CASE OF EMERGENCY
IN CASE OF EMERGENCY
IN CASE OF EMERGENCY
4-14 The following points should be observed:
1. Both batteries must be 12V. The capacity
(Ah) of the battery supplying current should not be significantly below that of the dis-charged battery.
2. Use only heavy-duty jumper cables.
3. A discharged battery can freeze. A frozen battery must be thawed out before connect- ing the jumper cables.
4. There should be no contact between the two vehicles; otherwise current may flow whenthe positive terminal is connected.
5. The discharged battery must be correctly connected to the vehicle electrical system.
6. Run the engine of the vehicle supplying current.
7. Connect the jumper cables as follows:
(1) Connect one end of one jumper cable to the positive terminal of the flat battery, and the other end to the positive terminal of thebooster battery.
(2) Connect one end of the other jumper cable to the negative terminal of the booster bat-tery, and the other end to the engine blockof the vehicle with the flat battery at the pointfarthest from the battery.
GS40330A
E110A02P-GAG
If the engine cannot be started because the battery is weak or dead, the battery from an-other vehicle can be used with jumper cables tostart the engine.
E110A01P-GAT
EMERGENCY STARTING
EMERGENCY STARTING EMERGENCY STARTING
EMERGENCY STARTING
EMERGENCY STARTING
CAUTION:
CAUTION: CAUTION:
CAUTION:
CAUTION:
Do not attempt to start the engine by pulling
Do not attempt to start the engine by pulling Do not attempt to start the engine by pulling
Do not attempt to start the engine by pulling
Do not attempt to start the engine by pulling
or pushing the vehicle.
or pushing the vehicle. or pushing the vehicle.
or pushing the vehicle.
or pushing the vehicle.
2. Operate the hand pump slowly 6 or 7 times
in order to force the water out through thedrain plug.
3. Tighten the drain plug when water no longer comes out.
4. Loosen the air plug and bleed the air. (Refer to "Bleeding the fuel system".)
5. Check to be sure that the warning lamp illuminates when the ignition key is turned to"ON", and that it goes off when the engine isstarted.If in doubt, consult your nearest authorizedHYUNDAI dealer.
WARNING:
WARNING: WARNING:
WARNING:
WARNING:
(1)(1)
(1)(1)
(1) Do not smoke or have any other open
Do not smoke or have any other open Do not smoke or have any other open
Do not smoke or have any other open
Do not smoke or have any other open
flame near the vehicle while bleeding the
flame near the vehicle while bleeding the flame near the vehicle while bleeding the
flame near the vehicle while bleeding the
flame near the vehicle while bleeding the
fuel system.
fuel system. fuel system.
fuel system.
fuel system.
(2)(2)
(2)(2)
(2) Be sure to carefully wipe away any water
Be sure to carefully wipe away any water Be sure to carefully wipe away any water
Be sure to carefully wipe away any water
Be sure to carefully wipe away any water
drained out in this manner, because the
drained out in this manner, because the drained out in this manner, because the
drained out in this manner, because the
drained out in this manner, because the
fuel mixed in the water might be ignited
fuel mixed in the water might be ignited fuel mixed in the water might be ignited
fuel mixed in the water might be ignited
fuel mixed in the water might be ignited
and result in a fire.
and result in a fire. and result in a fire.
and result in a fire.
and result in a fire.