2003 HONDA CIVIC HATCHBACK ignition

There are two switches on the
ceiling near the f ront ceiling light.
The ignition switch must be ON (II)
to operate the moonrooof .To open the moonroof , pull the
OPEN/CLOSE switch backward and
hold it. Release the switch when the
moonroof gets to the desired
position.
To close the moonroof , push the
OPEN/CLOSE switch f orward and
hold it. The moonroof will not close
completely; it will stop about 5.1
inches (130 mm) away f rom being
closed. Make sure your passengers
are clear of the moonroof , then
release the switch and push it
f orward again to close the moonroof
completely.
When you push the TILT-UP switch,
the rear of the moonroof will tilt up
f or ventilation. To close it, push the
OPEN/CLOSE switch f orward.
Make sure everyone’s hands are
away f rom the moonroof bef ore
opening or closing it.
Moonroof
Inst rument s and Cont rols
87
OPEN/CLOSE
SWITCH
TILT-UP SWITCH Opening or closing the
moonroof on someone’s hands
or fingers can cause seriousinjury.
Make sure all hands and fingers
are clear of the moonroof
before opening or closing it.
If you try to open the moonroof in
below-f reezing temperatures, or when
it is covered with snow or ice, you can
damage the moonroof panel or motor.

Adjust the outside mirrors with the
adjustment switch on the driver’s
side of the dashboard:Turn the ignition switch ON (II).
Move the selector switch to L
(driver’s side) or R (passenger’s
side). Push the appropriate edge of the
adjustment switch to move the
mirrorright,left,up,ordown.
When you f inish, move the
selector switch to the center (off)
position. This turns of f the
adjustment switch so you can’t
move a mirror out of position by
accidentally bumping the switch.
Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.
The inside mirror has day and night
positions. The night position reduces
glare f rom headlights behind you.
Flip the tab on the bottom edge of
the mirror to select the day or night
position. 3.
1. 2. 4.
Adjusting the Power MirrorsMirrors
Mirrors
Inst rument s and Cont rols
88 TAB
SELECTOR SWITCHADJUSTMENT SWITCH

To apply the parking brake, pull the
lever up f ully. To release it, pull up
slightly, push the button, and lower
the lever. The parking brake light on
the instrument panel should go out
when the parking brake is f ully
released (see page ).
The outside mirrors are heated to re-
move fog and frost. With the ignition
switchON(II),turnontheheaters
by pressing the button. The light in
the button comes on as a reminder.
Press the button again to turn the
heaters of f .
59
On Canadian model
Mirrors, Parking Brake
Inst rument s and Cont rols
Parking Brake
89
HEATED MIRROR BUTTON
PARKING BRAKE LEVER Driving the vehicle with the parking
brake applied can damage the rear
brakes and axles.

To use an accessory power socket,
pull down on the cover.
This socket is intended to supply
power f or 12 volt DC accessories
that are rated 120 watts or less (10
amps). The ignition switch must be
in ACCESSORY (I) or ON (II).
It will not power an automotive type
cigarette lighter element.
To access the console compartment,
slide the lid f orward, then slide the
beverage holder assembly f orward.
Inst rument s and Cont rols Coat Hook A ccessory Power Socket
Console Compartment
Console Compart ment , Coat Hook, A ccessory Power Socket
92 CONSOLE COMPARTMENT
BEVERAGE HOLDER COAT HOOK
ACCESSORY POWER SOCKET

The ceiling lights (with each switch
in the center position) will also come
on when you remove the key f rom
the ignition switch. If you do not
open a door, the lights stay on, then
f ade out in about ten seconds.The f ront ceiling light also contains
two spotlights.
Turn on the spotlight by pushing the
button next to each light. Push the
button again to turn it off. You can
use the spotlights at all times.The cargo area light comes on when
you open the hatch.
The f ront and center ceiling lights
(witheachswitchinthecentre
position) come on when you unlock
the door with the key or the remote
transmitter (see page ).
76
Interior Lights
Inst rument s and Cont rols Spotlights Cargo Area Light
94

The band and f requency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction on
AM is not available.
Your Honda’s audio system provides
clear reception on both AM and FM
bands, while the preset buttons allow
you to easily select your f avorite
stations.
The anti-thef t f eature will disable the
system if it is disconnected f rom the
car’s battery. To get the system
working again, you must enter a
code number (see page ).
The ignition switch must be in
ACCESSORY (I) or ON (II) to
operate the audio system. Turn the
system on by pushing the PWR/
VOL knob or the AM/FM button.
Adjust the volume by turning the
same knob.
123
Audio System
Comf ort and Convenience Feat ures
AM/FM/CD Audio System
Operating the Radio
104 AM/FM BUTTON
SCAN INDICATOR
A.SEL
BUTTONSCAN
BUTTON
PRESET BUTTONS TUNE KNOB
SEEK BAR
PWR/VOL KNOB ST INDICATOR

You can use the instrument panel
brightness control dial to adjust the il-
lumination of the audio system (see
page ). The audio system
illuminates when the parking lights
are on, even if the radio is turned of f .
The display of your audio system
usually shows the time when the
ignition switch is in ACCESSORY (I)
or ON (II). It shows the operation
mode of the radio, CD player, or
optional CD changer/cassette player
when you operate them, and goes
back to the time display after five
seconds.You can set the time only when the
clock is displayed.
If an error occurs while operating
the CD player or optional CD
changer, the display will show the
error code and will not switch to the
time display until the error is
corrected (see pages and ). Adjust the hours by pressing and
holding the CLOCK (SCAN/RPT)
button, then pressing the H (Preset
4) button.
Adjust the minutes by pressing and
holding the CLOCK (SCAN/RPT)
button, then pressing the M (Preset
5) button.
117 118
67
CONT INUED
A udio System L ighting
Digital Clock
Audio System
Comf ort and Convenience Feat ures
109
H BUTTON
M BUTTON R BUTTON
CLOCK (SCAN/RPT) BUTTON

CONT INUED
You operate the CD player with the
same controls used f or the radio.
With the ignition switch in
ACCESSORY (I) or ON (II), insert
the disc into the CD slot. Push the
disc in half way, the drive will pull it
in the rest of the way and begin to
play. The number of the track that is
playing is shown in the display.
You can also play 3-inch (8-cm) discs
without using an adapter ring. Play
only standard round discs. Odd-
shaped CDs may jam in the drive or
cause other problems.
For best results when using CD-R
discs, use only high quality discs
labeled f or audio use. When
recording a CD-R, the recording
must be closed in order f or the disc
to be used by CD players. CD-RW
discs will not work in this unit.
Audio System
Comf ort and Convenience Feat ures
Operating the CD Player
113
CD/TAPE BUTTON
AM/FM BUTTON CD SLOT RDM BUTTON
EJECT
BUTTON
PWR/VOL KNOB SEEK/SKIP BAR RPT BUTTON
RPT INDICATOR
RDM INDICATOR