2003 HONDA CIVIC HATCHBACK headlights

Check the f ollowing:
If youfindanybulbsareburnedout,
replace them as soon as possible.
Refer to the chart on page to
determinewhattypeof replacement
bulb is needed.Headlights (low and high beam)
Parking lights
Taillights
Brake lights
High-mount brake light
Turn signals
Back-up lights
Hazard light f unction
License plate lights
Side marker lights
Daytime running lights
(Canadian model)
251
Lights
Maint enance201
TURN SIGNAL
LIGHT
BACK-UP
LIGHT
SIDE MARKER
LIGHT
STOP/TAILLIGHT LICENSE PLATE
LIGHTS
HIGH-MOUNT BRAKE LIGHT

Open the hood.
Remove the electrical connector
f rom the bulb by pulling the
connector straight back.
Your car has halogen headlight
bulbs, one on each side. When
replacing a bulb, handle it by its steel
base and protect the glass from
contactwithyourskinorhard
objects. If you touch the glass, clean
it with denatured alcohol and a clean
cloth.
Theheadlightswereproperlyaimed
when your car was new. If you
regularly carry heavy items in the
cargo area, readjustment may be
required. Adjustment of the
headlights should be perf ormed by a
Honda technician or other qualif ied
mechanic.
1. 2.
Replacing a Headlight Bulb
Headlight A iming
Lights
Maint enance
202 BULB WEATHER SEAL
HOLD-DOWN WIRE CONNECTOR
Halogen headlight bulbs get very hot
when lit. Oil, perspiration, or a scratch
on the glass can cause the bulb to
overheat and shatter.

Remove the rubber weather seal
by pulling on the tab.
Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place and clip the end into
the slot.
Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked ‘‘TOP.’’
Push the electrical connector onto
the tabs of the new bulb. Make
sure it locks in place.
Turn on the headlights to test the
new bulb.Use a f lat-tipped screwdriver to
remove the holding clip f rom the
inner f ender.
Pull the inner f ender cover back.
Unclip the hold-down wire f rom its
slot by pushing it in and up. Pivot
it out of the way and remove thebulb.
If you are changing the bulb on
the driver’s side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger’s side, turn
the steering wheel to the left.
3. 4. 5. 6. 7. 1.
3.
2.
CONT INUED
Replacing a Front T urn Signal Bulb
Lights
Maint enance
203
HOLDING CLIP

Diagnosing why your engine won’t
start f alls into two areas, depending
on what you hear when you turn the
key to START (III):You hear nothing, or almost
nothing. The engine’s starter
motor does not operate at all, or
operates very slowly.
You can hear the starter motor
operating normally, or the starter
motor sounds like it is spinning
f aster than normal, but the engine
does not start up and run. When you turn the ignition switch to
START (III), you do not hear the
normal noise of the engine trying to
start. You may hear a clicking sound
or series of clicks, or nothing at all.
Check these things:
Check the transmission interlock.
The clutch pedal must be pushed
all the way to the f loor or the
starter will not operate.
Turn the ignition switch to ON (II).
Turn on the headlights and check
their brightness. If the headlights
are very dim or don’t light at all,
the battery is discharged. See
on page .230
Nothing Happens or the Starter
Motor Operates Very Slowly
Jump Starting
T aking Care of t he Unexpect ed
If Your Engine Won’t Start
228

Turn the ignition switch to START
(III). If the headlights do not dim,
check the condition of the f uses. If
thefusesareOK,thereisproba-
bly something wrong with the
electrical circuit for the ignition
switch or starter motor. You will
need a qualif ied technician to
determine the problem. (Seeon page .)
If the headlights dim noticeably or
go out when you try to start the
engine, either the battery is dis-
charged or the connections are
corroded. Check the condition of
the battery and terminal connec-
tions (see page ). You can
then try jump starting the car from
a booster battery (see page ). In this case, the starter motor’s
speed sounds normal, or even f aster
than normal, when you turn the
ignition switch to START (III), but
the engine does not run.
Do you have f uel? Turn the
ignition switch to ON (II) for a
minute and watch the f uel gauge.
The low f uel level warning light
may not be working, so you were
not reminded to f ill the tank.
There may be an electrical
problem, such as no power to the
f uel pump. Check all the f uses
(see page ).
Your car has the Immobilizer
System. You should use a
properly-coded master or valet key
to start the engine (see page ).
A key that is not properly coded
will cause the immobilizer system
indicator in the dash panel to blink
rapidly.
Are you using the proper starting
procedure? Ref er to
on page . If youfindnothingwrong,youwill
need a qualif ied technician to f ind
the problem. See
on page .
143 74
245
184 230 241
245
If Your Engine Won’t Start
T aking Care of t he Unexpect ed
Emergency T owing
T he Starter Operates Normally
Starting the
Engine Emergency
Towing
229

If something electrical in your car
stops working, the f irst thing you
should check f or is a blown f use.
Determine f rom the chart on pagesand , or the diagram on the
fuse box lid, which fuse or fuses
control that component. Check those
f uses f irst, but check all the f uses
bef ore deciding that a blown f use is
not the cause. Replace any blown
f uses and check the component’s
operation.
Turn the ignition switch to LOCK
(0). Make sure the headlights and
all other accessories are off.
Remove the cover f rom the f use
box. Check each of the large f uses in
the under-hood f use box by
looking through the top at the wire
inside. Removing these f uses
requires a Phillips-head screw-
driver.
Check the smaller f uses in the
under-hood f use box and all the
fuses in the interior fuse box by
pulling out each f use with the f use
puller provided in the interior f use
box.
3.
1. 2. 4.
243 244
CONT INUED
Checking and Replacing Fuses
Fuses
T aking Care of t he Unexpect ed
241
FUSE
BLOWN FUSE PULLER

µµµ
µ µµµµµµµµµµµµµ µ
Specif ications
T echnical Inf ormation 251
Air Conditioning
Alignment
Tires
Lights
Fuses
Battery HFC-134a (R-134a)
21.2 22.9 oz (500 550 g) SP-10
12 V
12 V 60/55 W (HB2)
21 W 0.00 in (0.0 mm)
0.08 in (2.0 mm)
0°45°
1°33’
195/60R15 88V
T125/70D15 95M
Refrigerant type
Charge quantity
Lubricant type
Toe-in
CamberCaster Size
Pressure 33 psi (230 kPa , 2.3 kgf/cm
)
30 psi (210 kPa , 2.1 kgf/cm)
60 psi (420 kPa , 4.2 kgf/cm)
12 V
12 V
12 V
12 V
21 W
21/5 W
2CP
12 V
12 V 21 W
12 V
12 V
12 V 5W5W5W
3CP5W
2CP 8W
12 V
12 V
Headlights (HI/LO)
Front turn signal
Front parking light
Side turn signal light
Front side marker
Rear turn signal lights
Stop/Taillights
Rear side marker lights
Back-up lights
High-mount brake light
License plate lights
Front ceiling light/Spotlights
Center ceiling light
Cargo area light
Interior
Under-hood
Capacity
45 AH/20 HR
12 V
12 V 5 W
See page 244 or the fuse label
attached to the inside of the fuse
box door under the dashboard.
See page 243 or the fuse box
cover. FrontRear
FrontRear
Front
Front/Rear
Spare
FrontRear
Spare

CONT INUED
BatteryCharging System ...........................
Indicator . 58, 235
............................
Jump Starting . 230
..............................
Maintenance . 184
............................
Specif ications . 251
..............................
Bef ore Driving . 127
....................................
Belts,Seat .8,43
...........................
Beverage Holders . 90
.................................
Body Repairs . 220
Brakes
.............
Break-in, New Linings . 128
...........................................
Fluid . 177
.....................
Light, Burned-out . 207
.........................................
Parking . 89
.................
System Indicator . 59, 238
........................
Wear Indicators . 147
.............................
Braking System . 147
........................
Break-in, New Car . 128
..
Brightness Control, Instruments . 67
........................
Brights, Headlights . 66
...
Accessories and Modif ications . 135
................................
Accessories . 135
.
Additional Safety Precautions . 136
............................
Modif ications . 136
ACCESSORY (Ignition Key .......................................
Position) . 73
...............
Accessory Power Socket . 92
Adding
................................
Brake Fluid . 178
...............................
Clutch Fluid . 178
..........................
Engine Coolant . 171
..................................
Engine Oil . 167
....
Manual Transmission Fluid . 177
........
Windshield Washer Fluid . 176
Additional Inf ormation About .......................
Your Seat Belts . 43
......................
Lap/Shoulder Belt . 43
...............
Seat Belt Maintenance . 45
..
Seat Belt System Components . 43
Additional Inf ormation About ...........................
Your Airbags . 46
...
Additional Safety Precautions . 51
How the Passenger Airbag
..........
Cutoff Indicator Works . 49 How Your Front Airbags
.........................................
Work . 46
....................
Airbag Components . 46
....................
Additives, Engine Oil . 168
Adjustments
..........................
Head Restraints . 82
.........................................
Mirrors . 88
.............................................
Seats . 81
...........................
Steering Wheel . 71
...............................
Airbag (SRS) . 9, 46
.....................
Air Cleaner Element . 179
................
Air Conditioning System . 96
..............................
Maintenance . 189
............................................
Usage . 96
.........................
Air Outlets (Vents) . 98
.......................
Air Pressure, Tires . 193
..................
High Speed Driving . 194
.........................
Normal Driving . 194
.......................
Alcohol in Gasoline . 254
......................................
Antif reeze . 171
Anti-thef t Steering Column
..............................................
Lock . 73
..........................
Appearance Care . 213
................................
Audio System . 104
Index
A B
I