Page 377 of 429
µ
´
´ Connect the second jumper cable
to the negative ( ) terminal on
the booster battery. Connect the
other end to the grounding strap
as shown. Do not connect this
jumper cable to any other part of
the engine.
Connect one jumper cable to the
positive ( ) terminal on your
Honda’s battery. Connect the
other end to the positive ( )
terminal on the booster battery.
3.
4.
Jump Starting
T aking Care of t he Unexpect ed374
4-cylinder models6-cylinder models4-cylinder models
Page 378 of 429
Once your car is running, discon-
nectthenegativecablefromyour
car, then from the booster battery.
Disconnect the positive cable f rom
your car, then the booster battery.
The numbers in the illustrations
show you the order to connect the
jumper cables.
Start your car. If the starter motor
still operates slowly, check the
jumper cable connections to make
sure they have good metal-to-
metal contact. If the booster battery is in another
vehicle, have an assistant start
that vehicle and run it at a fast idle. Keep the ends of the jumper
cables away from each other and
any metal on the vehicle until all
are disconnected. Otherwise, you
may cause an electrical short.
7.
6. 5.
Jump Starting
T aking Care of t he Unexpect ed375
6-cylinder models 4-cylinder modelsBOOSTER
BATTERY
6-cylinder models BOOSTER
BATTERY
Page 383 of 429
By eliminating as much of the
electrical load as possible, you can
drive several miles (kilometers)
before the battery is too discharged
to keep the engine running. Drive to
a service station or garage where
you can get technical assistance.
This indicator should come on when
the ignition switch is ON (II), and go
out af ter the engine starts. If it
comes on brightly when the engine
is running, it indicates that the
charging system has stopped
charging the battery. Immediately turn of f all electrical
accessories:radio,heater,A/C,
climate control, rear def ogger, cruise
control, etc. Try not to use other
electrically-operated controls such as
the power windows. Keep the engine
running and take extra care not to
stall it. Starting the engine will
discharge the battery rapidly.
T aking Care of t he Unexpect ed
Charging System Indicator
380
CHARGING SYSTEM INDICATOR
Page 385 of 429
Your car has certain ‘‘readiness
codes’’ that are part of the on-board
diagnostics f or the emissions
systems. In some states, part of the
emissions testing is to make sure
these codes are set. If they are not
set, the test cannot be completed.
If your car’s battery has been
disconnected or gone dead, these
codes are erased. It takes several
days of driving under various
conditions to set the codes again.If possible, do not take your car f or a
state emissions test until the
readiness codes are set. Ref er to
State Emissions Testing f or more
inf ormation. (See page .)
To check if they are set, turn the
ignition ON (II), but do not start the
engine. The Malf unction Indicator
Lamp will come on f or 20 seconds. If
it then goes of f , the readiness codes
are set. If it blinks 5 times, the
readiness codes are not set.
408
Malf unction Indicator L amp
T aking Care of t he Unexpect ed
Readiness Codes
382
Page 392 of 429
µµ
Î
Î
Î
´
Î
Amps.
Amps. No.
No. Amps.
No.
CONT INUED
Circuits Protected Circuits ProtectedCircuits Protected
: 6-cylinder models
10 A
7.5 A 15 A
20 A
10 A
(30A) 10 A
15 A
10 A 6
7
8
9
10
1
2
3
4
5 20 A
30 A
7.5 A 20 A
40 A
40 A
15 A
30 A
30 A
20 A
40 A
40 A
(40 A) 40 A
100 A
50 A
50 A
11
11
12
13
14
15
16
17
17
18
18
19
20
21
22
23
Left Headlight Low Beam
(Rear Defroster Coil)
Left Headlight High Beam
Small Light
Right Headlight High Beam Right Headlight Low Beam
Back Up
FI ECU
Condenser f an
Not UsedCooling Fan
Cooling Fan
MG. Clutch
Horn, Stop
Rear Defroster
Back Up, ACC
Hazard
ABS Motor
TCS Motor
ABS F/S
TCS
Option
Option
Heater Motor
Battery
Not Used
BIG1Main
Power Window Main
Fuses
T aking Care of t he Unexpect ed389
UNDER-HOOD FUSE/RELAY BOX
Page 395 of 429
If you decide to tow your car with all
f our wheels on the ground, make
sure you use a properly-designed and
attached tow bar. Prepare the car for
towing as described above, and leave
the ignition switch in Accessory (I)
so the steering wheel does not lock.
Make sure the radio and any items
plugged into the accessory power
socket are turned of f so they do not
rundownthebattery.
Emergency T owing
T aking Care of t he Unexpect ed392
The steering system can be damaged if
the steering wheel is locked. Leave the
ignition switch in Accessory (I), and
make sure the steering wheel turns
f reely bef ore you begin towing.Trying to lif t or tow your car by the
bumpers will cause serious damage.
The bumpers are not designed to
support the car’s weight.
Page 400 of 429

µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
Î
Î
Î
ÎÎ
Î
Î
Î
T echnical Inf ormation
Specif ications ( 4-cylinder Models)
397
Battery
Fuses Lights Engine
Alignment
Tires
12 V
12 V
24/2.2 CP
12 V
12 V
60 W (HB3)
51 W (HB4)
12 V
12 V
12 V
12 V
12 V
12 V 12 V
12 V
12 V 21 W
21/5 W
18 W
3CP
8W
21 W
5W
2CP
1.1 W
8W
Capacity 12 V
12 V 38 AH/5 HR
47 AH/20 HR
Interior
Under-hood Headlights
Front turn signal/parking/side
marker lights
Rear turn signal lights
Back-up lights
License plate lights
Ceiling light
High-mount brake light
Trunk light
Door courtesy lights
Vanity mirror lights
Spotlights
See page390or the fuse label
attached to the inside of the fuse
box lid.
See page 389or the fuse box
cover. Water cooled 4-stroke i-VTEC
4-cylinder gasoline engine
Type
BorexStroke
Displacement
Compression ratio
Spark plugs 3.43 x 3.90 in (87.0 x 99.0 mm)
144 cu-in (2,354 cm
)
9.7 : 1
See spark plug maintenance sec-
tion page 320 .
Toe-in
Camber
Caster 0.00 in (0.0 mm)
0.08 in (2.0 mm)
0°1°
3°15’
Size
Pressure P205/65R15 92H
P205/60R16 91V
T135/90D15 100M
30 psi (210 kPa , 2.1 kgf/cm
)
32 psi (220 kPa , 2.2 kgf/cm)
29 psi (200 kPa , 2.0 kgf/cm)
30 psi (210 kPa , 2.1 kgf/cm)
60 psi (420 kPa , 4.2 kgf/cm)
Front
Rear
Front
Rear
Front
High
Low
1: LX
2: EXFront/Rear
Spare
Front
Rear
Spare
Stop/taillight/side marker lights
1
2
1
2
1
2
Page 402 of 429

µ
Î
Î
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
Î
Î
Î
Î
Î
Î
T echnical Inf ormation
Specif ications ( 6-cylinder Models)
399
Engine
Alignment
Lights
Battery
Fuses
Tires Type
BorexStroke
Displacement
Compression ratio
Spark plugs
Toe-in
Camber
CasterWater cooled 4-stroke
SOHC VTEC
6-cylinder gasoline engine
Headlights
Front turn signal/parking/side
marker lights
Rear turn signal lights
Back-up lights
License plate lights
Ceiling light
High-mount brake light
Trunk light
Door courtesy lights
Vanity mirror lights
Spotlights
Capacity
Interior
Under-hood Size
Pressure
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
63 W (HB3)
51 W (HB4)
24/2.2 CP
21 W
21/5 W
18 W
3CP
8W
21 W
5W
2CP
1.1 W
8W
52 AH/5 HR
65 AH/20 HR
3.39 x 3.39 in (86.0 x 86.0 mm)
183 cu-in (2,997 cm
)
10.0 : 1
0.00 in (0.0 mm)
0.08 in (2.0 mm) 0°1°
3°15’
P215/50R17 93V P205/60R16 91V
T135/90D15 100M
32 psi (220 kPa , 2.2 kgf/cm
)
T135/80R16 101M
See page 390or the fuse label
attached to the inside of the fuse
box lid.
See page 389or the fuse box
cover. 60 psi (420 kPa , 4.2 kgf/cm
)
29 psi (200 kPa , 2.0 kgf/cm)
30 psi (210 kPa , 2.1 kgf/cm)
See spark plug maintenance sec-
tion page 323 .
Front
Rear
Front
Rear
Front
High
Low
1:
2:LX-V6, EX-V6 with automatic transmission
EX-V6 with manual transmission Front/Rear
Spare
Front
Rear
Spare
Stop/taillight/side marker lights
1
2
1
2
1
2