2003 FORD RANGER wiper fluid

MULTI-FUNCTION LEVER
Windshield wiper:Rotate the end
of the control away from you to
increase the speed of the wipers;
rotate towards you to decrease the
speed of the wipers.
Windshield washer:Push the end
of the stalk:
•briefly: causes a single swipe of
the wipers without washer fluid.
•a quick push and hold: the wipers
will swipe three times with
washer fluid.
•a long push and hold: the wipers and washer fluid will be activated for
up to ten seconds.
Changing the wiper blades
1. Pull the wiper arm away from the
vehicle. Turn the blade at an angle
from the wiper arm. Push the lock
pin manually to release the blade
and pull the wiper blade down
toward the windshield to remove it
from the arm.
2. Attach the new wiper to the
wiper arm and press it into place
until a click is heard.
3. Replace wiper blades every 6 months for optimum performance.
Driver Controls
50

WINDSHIELD WASHER FLUID
Add fluid to fill the reservoir if the
level is low. In very cold weather, do
not fill the reservoir completely.
Only use a washer fluid that meets
Ford specification WSB-M8B16–A2.
Refer toLubricant specifications
in this chapter.
State or local regulations on volatile
organic compounds may restrict the
use of methanol, a common
windshield washer antifreeze
additive. Washer fluids containing
non-methanol antifreeze agents
should be used only if they provide
cold weather protection without
damaging the vehicle’s paint finish,
wiper blades or washer system.
If you operate your vehicle in temperatures below 4.5°C (40°F),
use washer fluid with antifreeze protection. Failure to use washer
fluid with antifreeze protection in cold weather could result in impaired
windshield vision and increase the risk of injury or accident.
Note:Do not put washer fluid in the engine coolant reservoir. Washer
fluid placed in the cooling system may harm engine and cooling system
components.
ENGINE OIL
Checking the engine oil
Refer to the scheduled maintenance guide for the appropriate intervals
for checking the engine oil.
1. Make sure the vehicle is on level ground.
2.
Turn the engine off and wait a few minutes for the oil to drain into the
oil pan.
3. Set the parking brake and ensure the gearshift is securely latched in P
(Park) (automatic transmission) or 1 (First) (manual transmission).
4. Open the hood. Protect yourself from engine heat.
WASHERFLUIDONLY
RADIATOR
COOLANT
ONLY
Maintenance and Specifications
192

in front seat ..............................99
in rear seat ................................99
Cleaning your vehicle
engine compartment ..............182
instrument panel ....................185
interior .....................................185
plastic parts ............................184
washing ....................................181
waxing .....................................181
wheels ......................................182
wiper blades ............................184
Clutch
fluid ..........................................218
operation while driving ..........118
recommended shift speeds ....119
Console ........................................56
Coolant
checking and adding ..............200
refill capacities ................204, 229
specifications ..................233, 236
Cruise control
(see Speed control) ....................53
Customer Assistance ................146
Ford accessories for your
vehicle .............................186, 240
Ford Extended Service
Plan ..........................................173
Getting assistance outside
the U.S. and Canada ..............177
Getting roadside assistance ...146
Getting the service you
need .........................................171
Ordering additional owner’s
literature .................................178
The Dispute Settlement
Board .......................................174
Utilizing the
Mediation/Arbitration
Program ...................................177D
Daytime running lamps
(see Lamps) ................................41
Dipstick
automatic transmission
fluid ..........................................219
engine oil .................................192
Doors
lubricant specifications ..........233
Driveline universal joint and
slip yoke ....................................223
Driving under special
conditions ..................120, 125, 128
sand .........................................127
snow and ice ...........................129
through water .................127, 131
E
Emergencies, roadside
jump-starting ..........................165
Emission control system ..........215
Engine ........................................236
cleaning ...................................182
coolant .....................................200
idle speed control ...................198
lubrication
specifications ..................233, 236
refill capacities ........................229
service points ..................189–191
starting after a collision .........147
Engine block heater .................112
Engine oil ..................................192
checking and adding ..............192
dipstick ....................................192
filter, specifications ........197, 229
recommendations ...................197
refill capacities ........................229
specifications ..................233, 236
Index
244

V
Vehicle dimensions ...................236
Vehicle Identification Number
(VIN) ..........................................239
Vehicle loading ..........................132
camper bodies ........................145
Ventilating your vehicle ...........112
W
Warning lights (see Lights) .......10Washer fluid
..............................192
Water, Driving through
.............131
Windows
power
.........................................52
Windshield washer fluid and
wipers
..........................................50
checking and adding fluid
.....192
replacing wiper blades
.............50
Wrecker towing
.........................170
Index
248