9P –8 DOORS
DAEWOO M-150 BL2
D109C566
REAR DOOR GLASS RUN
Removal Procedure
1. Remove the inside channel weatherstrip from the
rear door. Refer to Section 9G, Interior Trim.
2. Remove the outside channel weatherstrip from the
rear doors. Refer to Section 9G, Interior Trim.
3. Remove the rear door trim panel. Refer to Section
9G, Interior Trim.
4. Remove the rear door seal trim.
a. Door seal trim.
b. Door pocket handle bracket.
Important: In case of the deluxe type, remove the seal
trim after removing the door pocket handle bracket.
D109C567
5. Remove the guide piece.
Remove the screw (1).
Remove the guide piece (2).
D109C568
6. Remove the upper guide rail and the glass run.
Remove the bolts (1).
Lift up and remove the upper guide rail and the
glass run simultaneously (2).
D109C569
Installation Procedure
1. Install the upper guide rail and the rear door glass
run.
2. Install the guide piece with the screw.
3. Install the rear door seal trim.
4. Install the rear door trim panel. Refer to Section 9G,
Interior Trim.
5. Install the outside channel weatherstrip to the rear
door. Refer to Section 9G, Interior Trim.
6. Install the inside channel weatherstrip to the rear
door. Refer to Section 9G, Interior Trim.
DOORS 9P–15
DAEWOO M-150 BL2
D109C583
5. Disconnect the outside door handle rod from the door
lock.
a. Outside door handle rod.
D109C586
6. Disconnect the door lock from the vehicle.
Remove the screws (1).
Remove the door lock (2).
Important: Disconnect the actuator connector if
equipped with the central door lock system.
D109C587
Installation Procedure
Notice: Dissimilar metals in direct contact with each
other may corrode rapidly. Make sure to use the correct
fasteners to prevent premature corrosion.
1. Install the rear door lock with the screws.
Important: Connect the actuator connector if equipped
with the central door lock system.
2. Connect the outside door handle rod to the door lock.
3. Install the guide rail with the screw.
4. Install the seal trim. Refer to “Door Seal Trim” in this
section.
5. Install the door trim panel. Refer to Section 9G, Interi-
or Trim.
6. Connect the negative battery cable if equipped with
the central door lock system.
