Page 4 of 88

2
Introduction
12
i
General information and
controls
General view, left side ........... 4
General view, right side ......... 5
Cockpit ................................. 6
Telltale and warning lights ..... 7
Ignition switch and
steering lock ...................... 8-9
Odometer/clock .................. 10
Hazard warning flashers ...... 11
Handlebar fitting ............ 12-13
Seat .................................... 14
Topcase .........................15-16
System case .................. 17-21 Safety check
Checklist ........................ 22-23
Engine oil ....................... 24-25
Fuel ................................ 26-27
Handlebar levers ............ 28-29
Brakes ........................... 30-34
Shock-absorbers ................ 35
Spring preload .................... 36
Drive chain ......................... 37
Loads............................. 38-39
Wheels ........................... 40-42
Coolant .............................. 43
Lights ............................. 44-45
Contents
10R13bkg4.book Seite 2 Montag, 22. September 2003 4:26 16
Page 6 of 88
11
4
General information and controls
1Oil filler check/dipstick,
engine oil (
b24)
2 Clutch lever (
b28)
3 Lifting handle (
b53)
( ) Figure in bracketsbpage number for
description
4 Seat lock (b14)
5 On-board socketOE
6Coolant tank (b43)
OEOptional extra
General view, left side
1342
65
10R13bkg4.book Seite 4 Montag, 22. September 2003 4:26 16
Page 9 of 88
111
7
General information and controls
1Repeater,
flashing turn indicators left/
right green
J
2Warning light, ABS checkOE
red
D (b65)
3 Telltale light, high-beam
headlight, blue
q
4Warning light, engine oil
pressure, red
p (b59)
5 Warning light, coolant
temperature red
j (b58) 6
Telltale light,
neutral green
k
7Warning light, fuel
level down to approx.
4 litres (0.9 Imp. gal)
reserve, yellow
m
OEOptional extra
( ) Figure in brackets
bpage number for
description
Telltale and warning lights
13542
76
10r1301g4.fm Seite 7 Dienstag, 30. September 2003 1:36 13
Page 25 of 88
1
23
Safety check
2
Checklist
For this reason, check the
details in the following sections
before you start the journey:
– Fuel level
– Clutch-lever play
–Brake pressure
– Brake fluid levels (front and rear)
– Operation of the ABS warning
light
–Drive chain
– Shock-absorber setting and
spring preload
– Wheel rim and tyre condition,
spokes, tread depth and tyre
pressures
–Loading
– Coolant level
–Lights – Check regularly (every time
you stop for fuel), on the basis
of the following section:
– Engine oil level
(every second stop for fuel)
– Brake pads
If you encounter any problems
or difficulties, please contact
your BMW motorcycle dealer.
He will provide the necessary
advice and assistance.
10R13bkg4.book Seite 23 Montag, 22. September 2003 4:26 16
Page 45 of 88
1
43
Safety check
2
Checking coolant level
e Attention:
Always keep the coolant level
above the minimum mark.
Check coolant level only when
the engine is cold.
Place motorcycle on main (centre) stand or hold it verti-
cal
Check coolant at expansion tank:
MIN Minimum level
e Attention:
Never overfill the expansion
tank. Top up the coolant if neces-
sary (
b Maintenance Instruc-
tions, Chapter 2)
L Note:
If the expansion tank is full and
the coolant temperature is high
(as indicated by red warning
light
j b 58) or coolant con-
sumption is excessive, consult
an authorised BMW motorcycle
dealer.
Coolant
MIN
MAX
10R13bkg4.book Seite 43 Montag, 22. September 2003 4:26 16
Page 58 of 88
3
56
Starting – Riding – Parking
1
Switch on the ignition– Engine stop switch 1 in the
operating position
U
Ignition switch ON (b9)
Wait until the warning light for coolant temperature (
b7)
stops flashing
In an emergency only:
Move the kill switch 1 to posi-
tion
V
– The electronic engine man- agement, fuel pump and
starter motor electrical cir-
cuits are de-energised
Fully retract the side stand
L Note:
If the side stand is extended
and a gear engaged, you can-
not start the motorcycle.
Select neutral– Neutral indicator light
green
k (b7) ON
L Note:
Engine does not start:
– Move the gear lever to the
k
position or disengage the
clutch
Engine stops when first gear is
engaged:
– Fully retract the side stand; if necessary, consult the trou-
bleshooting chart
(
b Maintenance Instructions,
Chapter 1)
Before you start
10R13bkg4.book Seite 56 Montag, 22. September 2003 4:26 16
Page 60 of 88
3
58
Starting – Riding – Parking
ABS indicator light– ABS warning light1
(
b 64-69)
Coolant temperatureWarning light 2 j (red) flashes
for approx. 3 seconds after you
switch on the ignition.
The electronic engine manage-
ment system initialises itself
during this period.
e Attention:
If the coolant-temperature
warning light
j comes on,
switch off the engine and allow
it to cool down.
Check coolant level in the
expansion tank (
b43).
If the expansion tank is full, but
the warning light remains on, or
if coolant consumption is ex-
cessive, consult a specialist
workshop, preferably your au-
thorised BMW motorcycle deal-
er.
Telltale and warning lights
12
10R13bkg4.book Seite 58 Montag, 22. September 2003 4:26 16
Page 62 of 88
3
60
Starting – Riding – Parking
Riding, gear shifts
Engine speedLimit engine speed in accord-
ance with coolant temperature,
using the highest engine
speeds only when the engine
has reached its regular operat-
ing temperature.
When the revolution counter
needle enters the red zone on
the dial, the fuel supply is inter-
rupted in order to protect the
engine against overspeeding.
L Note:
The governor cuts in at
7,400 rpm.
Load changes
d Warning:
Try not to open or close the
throttle abruptly, particularly
on wet or slippery roads.
Gearshifts
L Note:
Never slip the clutch excessive-
ly when changing gear. Vary
your speed only by using the
throttle in a suitable gear, not by
slipping the clutch.
It is advisable not to exceed a
maximum of 7,000 rpm
in any
gear.
10R13bkg4.book Seite 60 Montag, 22. September 2003 4:26 16