24
Safety check
2
Engine oil
Checking oil level
e Attention:
The red warning light
p (b7)
for engine oil pressure indicates
that the oil pump is delivering
very little oil or none at all: do
not regard this light as an oil
level indicator. Oil pressure
builds up after1-2 seconds and
the warning light goes out – the
red engine oil pressure warning
light
p should remain off when
the engine is running. Check
the oil level regularly, each time
you stop for fuel (or every sec-
ond time at the latest).
The oil level might be low if the
motorcycle has not been in use
for an extended period of time.
Under these circumstances top
up the oil level only after meas-
uring the oil level in accordance
with the instructions.
Always check engine oil level
with the engine at its regular op-
erating temperature.
Checking the oil level when the
engine is cold, just after the en-
gine has been run briefly or
when it is not properly warm will
falsify the reading, and could
lead to the engine being operat-
ed with the wrong quantity of oil
in the system.
L Note:
The oil temperature affects the
reading. The warmer the oil, the
higher the oil level in the sump.
Check the oil after a run, in or-
der to avoid overfilling.
Hold the motorcycle upright – Make sure the ground is level and firm.
– Check the oil when the engine is at operating temperature
(after the motorcycle has
been ridden, or else allow the
engine to idle until the fan
switches on)
Allow the engine to idle for at least 1 minute
Switch off the engine
Use the spark plug wrench to remove plug 1
10R13bkg4.book Seite 24 Montag, 22. September 2003 4:26 16
3
56
Starting – Riding – Parking
1
Switch on the ignition– Engine stop switch 1 in the
operating position
U
Ignition switch ON (b9)
Wait until the warning light for coolant temperature (
b7)
stops flashing
In an emergency only:
Move the kill switch 1 to posi-
tion
V
– The electronic engine man- agement, fuel pump and
starter motor electrical cir-
cuits are de-energised
Fully retract the side stand
L Note:
If the side stand is extended
and a gear engaged, you can-
not start the motorcycle.
Select neutral– Neutral indicator light
green
k (b7) ON
L Note:
Engine does not start:
– Move the gear lever to the
k
position or disengage the
clutch
Engine stops when first gear is
engaged:
– Fully retract the side stand; if necessary, consult the trou-
bleshooting chart
(
b Maintenance Instructions,
Chapter 1)
Before you start
10R13bkg4.book Seite 56 Montag, 22. September 2003 4:26 16
