2003 BMW 330Ci COUPE bulb

Contents

Operation, maintenance

Special operating instructions:

Break-in procedures108
Driving notes109
Antilock Brake System
(ABS)109
Brake system110

Wheels and tires:

Tire inflation pressure111
Tire condition111
Tire replacement112
Wheel and tire
combinations114
Winter tires114

In the engine compartment:

Hood116
Engine compartment
essentials118
Washer fluids120
Engine oil120
Coolant122
Brake fluid123

Maintenance:

The BMW Maintenance
System124

Laws and regulations:

California Proposition 65
warning126
OBD interface socket126

Owner service procedures

Replacement procedures:

Onboard tool kit130
Windshield wiper blades130
Lamps and bulbs131
Changing a wheel135
Run Flat tires*139
Battery140
Fuses140

Giving and receiving
assistance:

Jump-starting141
Towing the vehicle142

Technical data

Engine data146
Dimensions147
Weights148
Capacities149

handbook.book Page 10 Tuesday, July 30, 2002 12:16 PM

131
Lamps and bulbsThe lamps and bulbs make essential
contributions to the safety of your vehi-
cle. Therefore, comply fully with the fol-
lowing instructions during bulb replace-
ment. If you are not familiar with any of
the procedures, consult your BMW
center.
Do not touch the glass portion of
a new bulb with your bare hands
since even small amounts of impurities
burn in to the surface and reduce the
service life of the bulb. Use a clean
cloth, paper napkin, or a similar mate-
rial, or hold the bulb by its metallic
base.<
A replacement bulb set is available from
your BMW center.
Before working on the electrical
system, switch off the electrical
accessory you are working on or dis-
connect the cable from the negative
terminal of the battery. Failure to
observe this precaution could result in
short circuits.
To prevent injuries and damage, com-
ply with any instructions provided by
the bulb manufacturer.<
Low beams and high beamsEngine compartment, left side:
1Low beams
2High beams
H7 bulb, 55 watt
The H7 bulb is pressurized. There-
fore, wear safety glasses and pro-
tective gloves. Failure to comply with
this precaution could lead to injury if the
bulb is damaged.<
1. Turn the two release catches at the
front to the left – see arrow – to
remove the bulb holder
2. Remove and replace the bulb.
When cleaning the headlamps,
please follow the instructions in
the Caring for your vehicle brochure.<
Xenon lamps*The service life of these bulbs is very
long and the probability of a failure is
very low, provided that they are not
switched on and off an unusual number
of times. If one of these bulbs should
nevertheless fail, it is possible to con-
tinue driving with great caution using
the fog lamps, provided local traffic
laws do not prohibit this.
Because of the extremely high
voltages involved, any work on the
xenon lighting system, including bulb-
changing, should be carried out by
technically-qualified personnel only.
Otherwise, there is a risk of fatal
injury.<
OverviewControlsMaintenanceRepairsDataIndex
handbook.book Page 131 Tuesday, July 30, 2002 12:16 PM

132
Parking lamps5 watt bulb
Engine compartment, left side:
1. Turn the bulb holder to the left – see
arrow – and remove
2. Remove and replace the bulb.
Front turn signal indicators21 watt bulb
1. Using a long screwdriver, release the
inner clamp through the upper open-
ing
2. Remove the lamp by pulling it out
toward the front
3. Applying light pressure, turn the bulb
to the left. Remove and replace the
bulb
4. Insert the 2 pins on the lamp into the
guides on the vehicle
5. Push the lamp in. Carefully apply
pressure until you hear it snap into
place.
Lamps and bulbs
handbook.book Page 132 Tuesday, July 30, 2002 12:16 PM

133
Side turn signal indicators5 watt bulb
1. Use finger pressure against the rear
end of the lamp – see arrow – to
press it forward for removal
2. Apply gentle pressure to the bulb
while turning it to the left to remove.
Tail lamps1Turn signal indicator
2Backup lamp
3Tail lamp
4Tail lamp/brake lamp
Tail lamps 4: 21/4 watt bulb
Remaining bulbs: 21 watt
Right-hand luggage compartment
opening:
Bulbs in the fender:
All of the bulbs are integrated in a cen-
tral bulb holder.
1. Release the bulb holder – see arrow
in close-up view – and remove
2. Unplug the power supply fitting. Set
the bulb holder aside – on the lug-
gage compartment floor, for example
3. Applying light pressure, turn the bulb
to the left. Remove and replace the
bulb
4. Plug in the power supply fitting
5. Position the bulb holder for reinstal-
lation. Apply gentle pressure on the
button, see arrow in close-up view,
until you hear it engage.
Lamps and bulbs
OverviewControlsMaintenanceRepairsDataIndex
handbook.book Page 133 Tuesday, July 30, 2002 12:16 PM

134
Bulbs in the luggage compartment lid
1. Using a screwdriver, loosen the clip
2. Swing trim panel down – see arrow 1.
Release the bulb holder – see arrow
2 – and remove it
3. Applying light pressure, turn the bulb
to the left. Remove and replace the
bulb
4. Press the bulb holder into place,
continuing until you hear it engage
5. Reinstall the trim panel with the clip.
Center high-mount brake lampLED strip on the rear window.
Please contact your BMW center in
case of a malfunction.
Lamps and bulbs
handbook.book Page 134 Tuesday, July 30, 2002 12:16 PM

135
License plate lamps5 watt bulb
1. Place a screwdriver in the slot and
press toward the left – see arrow – to
release the lens
2. Replace the bulb.
Changing a wheel
Safety precautions in the event of
a flat tire or wheel change:
Stop the vehicle as far as possible from
passing traffic. Park on a firm, flat sur-
face. Switch on the hazard warning
flashers. Turn the steering wheel to the
straight-ahead position and engage the
steering lock. Shift into 1st or Reverse,
or if you have an automatic transmis-
sion, position the selector lever in Park,
and engage the parking brake.
All passengers should be outside the
vehicle and well away from your imme-
diate working area, behind a guardrail,
for example.
If a warning triangle or portable hazard
warning lamp is available, set it up on
the roadside at an appropriate distance
from the rear of the vehicle. Comply
with all local safety guidelines and reg-
ulations.
Change the wheel only on a level, firm
surface which is not slippery. Avoid
jacking the vehicle on a soft or slippery
support surface – snow, ice, loose
gravel, etc. – as either the vehicle or the
jack could slip sideways.
Position the jack on a firm support sur-
face.
Do not place wooden blocks or similar
objects under the jack. They could pre-
vent the jack from extending to its full
height and reduce its support capacity.
Do not lie under the vehicle or start the
engine when the vehicle is supported
by the jack. There is otherwise a risk of
fatal injury.<
Lamps and bulbs
OverviewControlsMaintenanceRepairsDataIndex
handbook.book Page 135 Tuesday, July 30, 2002 12:16 PM

Everything from A to ZA
ABS Antilock Brake System
18, 109
Accessories 5
Activated-charcoal filter 96
ADB Automatic Differential
Brake 77
Adding brake fluid 123
Air conditioning 88, 94
Air distribution 90, 94
Air nozzles 88, 92
Air outlets 88, 92
Air pressure 111
check 24
Air supply 90, 94
Airbags 18, 52
Alarm system 38
Anchorages 105
Antifreeze 122
Antilock Brake System (ABS)
18, 109
Anti-theft system 38
Armrest 98
ASC+T Automatic Stability
Control plus Traction 18,
19, 77
Ashtray
front 100
rear 100
AUC Automatic recircu-
lated-air control 95Automatic car wash, refer to
the Caring for your vehicle
brochure
Automatic climate control 92
Automatic cruise control 68
Automatic Differential Brake
(ADB) 77
Automatic dimming, interior
rearview mirror 51
Automatic headlamp
control 85
Automatic recirculated-air
control (AUC) 95
Automatic Stability Control
plus Traction (ASC+T) 18,
19, 77
Automatic transmission with
Steptronic 19, 63
Average fuel
consumption 75
Average speed 75
Avoiding unintentional
alarms 39
Axle loads 148
B
Backrest, adjusting 44
Backup lamps 62
replacing bulb 133Battery
charge 140
charge current 18
discharged 140
Belts 47
Beverage holder 98, 99
Blind, sun protection 96
Blower 90, 94
BMW High Performance
Synthetic Oils 121
BMW sports seat 44
Bore 146
Bottle holder, see Beverage
holder 98
Brake hydraulic system 18
Brake lamps
replacing bulb 133
Brake pads 19
Brake, parking 61
Brakes, malfunctions 110
Break-in procedures 108
Bulb, replacing 131
C
California Proposition 65
warning 126
Can holder, see Beverage
holder 98
Capacities 149
Car care, refer to the Caring
for your vehicle brochureCar telephone
refer to the separate
Owner's Manual
Car vacuum cleaner, con-
necting 100
Car wash, refer to the Caring
for your vehicle brochure
Cargo loading 104
Cassette player operation,
refer to the Owner's Man-
ual for Radio
CBC Cornering Brake
Control 18, 109
CD player operation, refer to
the Owner's Manual for
Radio
Cellular phone 99
Center armrest 98
Center high-mount brake
lamp 134
Central locking system 30
button 34
Charge indicator lamp 18
Check Control 72
Child-restraint mounting
system (LATCH) 56
Cigarette lighter 100
Cleaning windshield 68
Clock 73
setting, refer also to the
radio or onboard com-
puter Owner's Manual
handbook.book Page 152 Tuesday, July 30, 2002 12:16 PM

Everything from A to ZFuel tank
capacity 149
display 71
gauge 71
Fuel-injection system 146
Fuses, replacing 140
G
Gasoline 24
Gasoline gauge 71
Glove compartment 97
Grills 88, 92
Gross vehicle weight 148
H
Hands-free system 99
Harman Kardon premium
sound system 97
Hazard warning flashers 14
Hazard warning triangle 22
Head airbags 52
Head restraints 46
Headlamp flasher 86
Headlamp washer system
120, 149
Headlamps 85
automatic control 85
Heated seats 49
Heating and ventilation 92
Heavy loads 104
High beams 20, 66, 86
replacing bulb 131Holder for
beverages 98
litter bag 99
Hood release 116
Horn 14
Hydraulic brake assistant,
see DBC
Hydroplaning 109, 111
I
Ice warning 74
Icy roads 74
Ignition key 30
Ignition lock 59
Imprint 4
Indicator lamps 18
Inflation pressure 24, 111
monitoring 81
INSPECTION 72
Instrument cluster 16
Instrument lighting 86
Instrument panel 14, 16
Interface socket for onboard
diagnostics 126
Interior lamps 32, 87
remote control 32
Interior motion sensor 38
switching off 39
Interior rearview mirror 51
automatic dimming
feature 51
Interlock 59Intermittent mode 67
J
Jack 135
Jump-starting 141
K
Key Memory 58
Keys 30
with remote control 30
L
Lamps, replacing 131
LATCH child-restraint
mounting system 56
Length 147
License plate lamp
replacing bulb 135
Light switch 85
Lighter 100
LIGHTS ON warning 85
Litter bag holder 99
Load-securing devices 105
Lock, steering wheel 59
Low beams 85
automatic 85
replacing bulb 131
Lug wrench 135
Luggage compartment 35
capacity 148
floor mat 38
floor panel 37Luggage compartment lid 35
emergency operation 35
emergency release 37
remote control 32
securing separately 35
Luggage compartment light-
ing 35
Luggage rack 105
Lumbar support 45
M
M+S tires 114
Maintenance 72, 124
Malfunction displays 72
Manual transmission 62
MC operation, refer to the
Owner's Manual for Radio
MD operation, refer to the
Owner's Manual for Radio
Memory 48
Memory settings 58
Microfilter 91, 96
Microphone 99
Mirror
automatic curb monitor 49
Mirror defrosting 50
Mirror memory 48
Mirrors 50
Modifications, technical 5
Multifunction switch 66
handbook.book Page 154 Tuesday, July 30, 2002 12:16 PM