2003 ASTON MARTIN DB AR1 Q ECU

A - Before Driving
1-A-15 Pull upwards on the diagonal belt to ensure secure latching and to remove
all slack from the belt. Finally, double check that the lap belt is fitted snugly,
low down across the hips, and that there are no twists.
If it is necessary for an occupant to adjust their seat or seating position during
a journey, the belt tension might be disturbed. The occupant should
therefore (as soon as it is safe to do so) gently pull down the shoulder run of
the seat belt to create some slack and then immediately release it to re-
tension the belt for the new seating position.
Seat Belt Pretensioner
The seat belt pretensioner system is designed to hold vehicle occupants
against the seat back when a frontal collision occurs.
The seat belt pretensioner system works in conjunction with the airbag
system. In a serious frontal impact, as the airbags are triggered, the
pretensioners will also be triggered. These apply additional tension to the
front seat belts to hold the front seat occupants back in their seats.
Automatic Locking Retractors (ALR)
All vehicles are fitted with an ALR seat belt in the front passenger seat.
This system is designed to securely hold child seats. The ALR system
temporarily locks the belt securing the child seat.
Securing a Child Seat (ALR System)
Fit the child seat following the manufacturers instructions. Gently pull out
the relevant inertia reel seat belt until fully extended. The ALR system will
only engage at the maximum extension point of the seat belt.

A - Before Driving
1-A-16Thread the belt tongue through the child seat as instructed by the
manufacturer. Engage the tongue into the belt buckle. Adjust the tongue
position on the belt if necessary to ensure that the lower belt run is tight and
then allow the upper run of the seat belt to fully retract until the child seat
is securely held. The ALR system will be heard 'clicking' as the seat belt
retracts. When fully retracted, pull down on the upper run of the belt to
check that the ALR lock has engaged.
Child Seat Removal (ALR System)
To remove the child seat, release the belt as normal and allow it to retract
through the seat frame. The ALR system will disengage when the belt is fully
retracted. The belt may then be worn when required as a normal inertia reel
belt. Once the ALR is disengaged, the belt must be fully extended to re-
engage the system on the next occasion that a child seat is fitted.
WARNINGS - Seat Belts - General
Wearing your seat belt is crucial to your safety. Not wearing a seat belt increases
the chance of serious injury or death in the event of an accident. Be sure that you
and your passengers always fasten their seat belts and use them properly even
though airbags are provided. Seat belt usage is mandatory in most countries and
should be used in accordance with local laws.
By reclining the seat back, you decrease the protection you get from the seat belt
in the event of a crash. Adjust the seat back to an upright position (approximately
90° to the seat base.
Make sure that the seat back is locked in place. Otherwise it could move forward
in a sudden stop or crash and cause injury.

A - Before Driving
1-A-19
SPECIAL WARNINGS ON USE OF SAFETY RESTRAINTS FOR CHILDREN:
A child, regardless of age, should always be restrained when travelling in a
vehicle. The following precautions are strongly recommended.
Do not allow children to travel in the vehicle without restraint. Approved child
seats or harnesses should always be used.
Each seat belt assembly must be used by only one occupant. It is dangerous to put
a seat belt around a child being carried on the occupants lap.
Child restraint anchorages are designed to withstand only those loads imposed
by correctly fitted child restraints. Under no circumstances are they to be used
for adult seat belts, harnesses or for attaching other items or equipment to the
vehicle
CHILDREN AND THE USE OF CHILD SAFETY SEATS
An infant or child that is not properly restrained can be seriously injured or killed
in a crash. Seat belts are designed for adults and larger children; infants and
smaller children must be restrained in an approved child safety seat.
All child restraint systems are designed to be secured by lap belts, or the lap belt
portion of a lap-shoulder belt. Children could be endangered in a crash if their
child restraints are not properly secured in the vehicle. If you choose to use a
child safety seat, follow the manufacturers instructions. Never hold a baby or
child on your lap while riding in the car.
For use in USA, the child safety seat must be in conformity with Federal Motor
Vehicle Safety Standard 213. Look for the statement on the box and seat.
Check the seat manufacturers instructions for proper use and installation - use
the correct size seat and properly secure the seat in the car in accordance with
the manufacturers instructions. Be sure to read and follow the 'Installation and
Use Instructions' provided with the child seat.
Remember that children who have outgrown child restraints should wear the
vehicle's seat belt.

A - Before Driving
1-A-22
Interior Storage
Door Storage
Open storage pockets are provided below the arm rests in both doors.
Front Armrest Storage
The front armrest lid is lockable.
The boot release switch and the
accessory socket are fitted in the
front armrest storage box.
Rear Storage
A rear storage area is provided
behind the driver and passenger
seats. Tie down straps enable
items to be secured.

B - Controls
1-B-17 The centre console contains the following controls:
• Clock and PATS Status Light
• Heating, Ventilation and Air-Conditioning Controls
• Fog Lamp, Screen Heater and Seat Heater Switches
• Radio Cassette Player (Control for the CD autochanger)
• Hazard Light Switch
• Starter Button
• Traction Control Switch
• Window Lift Switches
• Boot Release Switch
• Cigar Lighter and Ashtray
The Heating, Ventilation and Air-Conditioning Systems are fully described
in the Air-Conditioning section of this Owner's Guide.
Clock
The clock in the centre of the air conditioning control panel is set using the
buttons on the clock panel.
The left button is used to retard the time and the
right button to advance the time.
The small light between the time set buttons is the
PATS Status Light which is described in the Security
section of this Owner's Guide.
ASTON MARTIN

E - Security Systems
1-E-1
Contents
Security Systems ................................................................................. 1-E-2
System Operation - Basic Controls ......................................................1-E-3
The Passive Anti-Theft System (PATs)...................................................1-E-7
Alarm System - Operating Summary ...................................................1-E-9
Alarm Key Fob - Range and Battery Replacement ..............................1-E-10

E - Security Systems
1-E-2
Security Systems
The primary protection for your DB AR1 is provided by an electronic
security system. Protection is further enhanced by a passive anti-theft system
(PATS) which provides engine immobilisation measures if the wrong ignition
key is used. The total system has the following functions:
• Remote Arming/Disarming via a Key Fob.
• Perimeter Sensing via switches on the doors, boot lid and bonnet.
• Boot Release on the Key Fob.
• Panic Alarm triggered using the Alarm Key Fob.
• 120dB Siren with battery back-up (in markets where audible sirens are
permitted).
• Random Code Encryption to prevent electronic scanning or grabbing of
the key fob identity code.
• Passive Anti-Theft system.
Tracker System (Optional - UK only excluding Channel Isles)
• The Tracker hardware is fitted to UK cars only and may be activated for
any owners who wish to subscribe to this additional vehicle security
system. Please consult your dealer for system details and subscription
rates.

E - Security Systems
1-E-3
System Operation - Basic Controls
The system is controlled using the two button key fob. The left (key symbol)
button controls the normal locking/unlocking of the car and arms/disarms
the alarm system. The right (boot open symbol) button controls the
unlocking of the boot. The Panic Alarm feature is operated using the left key
fob button.
The security system aerial is located at the rear of the car. The key fob should
be pointed towards this area of the vehicle to ensure a strong signal. The
normal operating range of the key fob is approximately 10 metres (30 feet).
The Passive Anti-Theft feature is fully automatic and is operated via a
transponder in the ignition key head which communicates with the engine
immobiliser circuits.