2003 Acura RSX brake light

Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
Insert the socket back into the
light assembly. Turn it clockwise
to lock it in place.
Testthelightstomakesurethe
new bulb is working.
Reinstall the high-mount brake
light cover.Insert a flat-tipped screwdriver
between the lef t edge of the lens
and the housing. The lens will
come down.Pull the bulb straight out of its
socket. Push the new bulb in until
it bottoms in the socket.
Testthelightstomakesurethe
new bulb is working.
Put the lens back into the light
assembly, right side f irst. Push on
the lef t edge until it snaps into
place.
4.
5.
6.
7.
1.2.
3.
4.
Lights
Maint enance
Replacing a Rear License Plate
Bulb
248
BULB

Remove the socket by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Install the light assembly cover.
Make sure it locks in place. Testthelightstomakesurethe
new bulb is working.
Open the hatch. Remove the light
assembly cover by pulling on the
tabontheoutsideedge. Determinewhichof thefivebulbs
is burned out: brake/taillight, turn
signal light, side marker light,
back-up light, or taillight.
2.
3.
1.
4.5.
6.
7.
Lights
Maint enance
Replacing Rear Bulbs
249
COVER

Block the rear wheels.
Fill the f uel tank.
Change the engine oil and f ilter
(see page ).
Wash and dry the exterior
completely.
Cleantheinterior.Makesurethe
carpeting, floor mats, etc. are
completely dry.
If you need to park your car f or an
extended period (more than one
month), there are several things you
should do to prepare it f or storage.
Proper preparation helps prevent
deterioration and makes it easier to
get your car back on the road. If
possible, store your car indoors.
If the car is to be stored for a
longer period, it should be
supported on jackstands so the
tires are of f the ground.
Leave one window open slightly (if
the car is being stored indoors).
Disconnect the battery.
Support the f ront and rear wiper
blade arms with a f olded towel or
ragsotheydonottouchthe
windshield.
To minimize sticking, apply a
silicone spray lubricant to all door
and hatch seals. Also, apply a body
wax to the painted surf aces that
mate with the door and hatch seals.If possible, run the engine f or a
while periodically (pref erably once
amonth).
If you store your car f or 12 months
or longer, have your Acura dealer
perf orm the inspections called f or in
the 24 months/30,000 miles (48,000
km) maintenance schedule (Normal
Conditions) as soon as you take it
out of storage (see page ). The
replacements called f or in the
maintenance schedule are not
needed unless the car has actually
reached that time or mileage. Coverthecarwitha‘‘breathable’’
cover, one made f rom a porous
material such as cotton.
Nonporous materials, such as
plastic sheeting, trap moisture,
which can damage the paint.
Leave the parking brake off. Put
the transmission in Reverse
(manual) or Park (automatic). 209
198
Maint enance
St oring Your Car
252

If you have a f lat tire while driving,
stop in a saf e place to change it.
Stopping in traf f ic or on the shoulder
of a busy road is dangerous. Drive
slowly along the shoulder until you
gettoanexitoranareatostopthat
is far away from the traffic lanes.Park the car on f irm, level and
non-slippery ground away f rom
traffic. Put the transmission in
Park (automatic) or Reverse
(manual). Apply the parking brake.Open the hatch. Pull up the f loor
mat and remove the spare tire
cover. Turn on the hazard warning lights,
and turn the ignition switch to
LOCK (0). Have all the
passengers get out of the car while
you change the tire.
If you are towing a trailer, unhitch
the trailer. Unscrew the wing bolt.
1. 2.
3.
4.
CONT INUED
Changing a Flat T ire
T aking Care of t he Unexpect ed263
TOOL KIT
JACK
The car can easily roll off the
jack, seriously injuring anyone
underneath.
Follow the directions for
changing a tire exactly, and
never get under the car when it
is supported only by the jack.

´´
To jump start your car, f ollow these
directions closely:
Open the hood and check the
physical condition of the battery
(see page ). In very cold
weather, check the condition of
the electrolyte. If it seems slushy
or like ice, do not try jump starting
until it thaws.
Turn of f all the electrical acces-
sories: heater, A/C, stereo system,
lights, etc.
Put the transmission in Neutral or
Park, and set the parking brake. Connect one jumper cable to the
positive ( ) terminal on your
Acura’s battery. Connect the other
end to the positive ( ) terminal
on the booster battery.
If your car’s battery has run down,
you may be able to start the engine
by using a booster battery. Although
this seems like a simple procedure,
you should take several precautions.
You cannot start an Acura with an
automatic transmission by pushing
or pulling it. 1.
2.
3.
191
T aking Care of t he Unexpect ed
Jump Starting
270
A battery can explode if you do
not follow the correct procedure,
seriously injuring anyone
nearby.
Keep all sparks, open flames,
and smoking materials away
from the battery.
If a battery sits in extreme cold, the
electrolyte inside can f reeze.
Attempting to jump start with a f rozen
battery can cause it to rupture.

Î
Î
Slow down by shif ting to a lower
gear, and pull to the side of the road
when it is saf e. Because of the
longer distance needed to stop, it is
hazardous to drive the car. You
should have it towed, and repaired as
soon as possible. (See on page .)
If you must drive the car a short
distance in this condition, drive
slowly and cautiously.
The Brake System Indicator
normallycomesonwhenyouturn
the ignition switch ON (II). It is a
reminder to check the parking brake.
It comes on and stays lit if you do not
f ully release the parking brake. However, if the brake pedal does not
f eel normal, you should take
immediate action. Because of the
brake system’s dual-circuit design, a
problem in one part of the system
will still give you braking at two
wheels. You will f eel the brake pedal
go down much f arther bef ore the car
begins to slow down, and you will
have to press harder on the pedal.
The distance needed to stop will be
much longer.
If it comes on at any other time, it
indicates a problem with the car’s
brake system. In most cases, the
problem is a low f luid level in the
brake f luid reservoir. Press lightly on
the brake pedal to see if it f eels normal. If it does, check the brake
f luid level the next time you stop at a
service station (see page ). If the
fluid level is low, take the car to your
dealer and have the brake system
inspected f or leaks or worn brake
pads.
219
285Emergency
Towing
Brake System Indicator
T aking Care of t he Unexpect ed278
BRAKE SYSTEM INDICATOR
U.S. indicator shown

µ
Î
Î
Î
Î
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
Î
ÎÎÎ
ÎÎÎ
Î
Specif ications
T echnical Inf ormation291
Fuses
Capacities
Battery Alignment
Tires
Lights
0.0in(0mm)
0.08 in (2.0 mm) 0°00’
Interior
Under-hood
1.8 US qt (1.7
)
1.6 US qt (1.5)
2.9 US qt (2.7
)
6.9 US qt (6.5)
2.6 US qt (2.5)
4.8 US qt (4.5)
Manual
transmission
fluid
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V55 W
55 W
21 W
21 W
21 W/5 W
21 W
5W
21 W
5W
8W
5W
8W See page
283or the fuse label
attached to the inside of the fuse
box door under the dashboard.
See page 284or the fuse box
cover.
12 V 5 W (Amber)
Capacity 12 V 36 AH/5 HR3.4 W
12 V 0°45’
1°30’
Toe-in
Camber
Caster
Size
Pressure
P205/55R16 89V
T135/70D15 99M
T125/70D16 96M P195/65R15 89H
33 psi (230 kPa , 2.3 kgf/cm
)
31 psi (220 kPa , 2.2 kgf/cm)
60 psi (420 kPa , 4.20 kgf/cm)
Headlights
Front turn signal
Front position lights
Rear turn signal lights
Brake/Taillights
High-mount brake light
Rear side marker lights
Back-up lights
License plate lights
Ceiling light
Cargo area light
Spotlights
Glove Box light Change
Total
Change
Total
U.S. cars
Canadian cars
Front/Rear
Spare
Front
Rear
Spare
High
Low
1:
2:
3:
4:Front
Rear
Front
Rear
Front
Canadian RSX
U.S. RSX
Canadian Premium
Type-S
Automatic trans-
mission fluid
Windshield
washer reservoir
1
2, 3, 4
1, 2, 3
4

Then drive in city/suburban
traffic for at least 10 minutes.
When traf f ic conditions allow, let
the vehicle coast f or several
seconds without using the
accelerator pedal or the brake
pedal.If the testing f acility determines the
readiness codes are still not set, see
your Acura dealer.
Select a nearby lightly traveled
major highway where you can
maintain a speed of 50 to 60 mph
(80to97km/h)foratleast20
minutes. Drive on the highway in
D (A/T) or 5th (M/T). Do not use
thecruisecontrol.Whentraffic
allows, drive f or 90 seconds
without moving the accelerator
pedal. (Vehicle speed may vary
slightly; this is okay.) If you cannot
do this f or a continuous 90
seconds because of traf f ic
conditions, drive f or at least 30
seconds, then repeat it two more
times (for a total of 90 seconds).
T echnical Inf ormation
St at e Emissions T est ing
300