2003 Acura RSX battery

µ
Connect the second jumper cable
to the negative ( ) terminal on
the booster battery. Connect the
other end to the grounding strap
as shown. Do not connect this
jumper cable to any other part of
the engine.Once your car is running, discon-
nectthenegativecablefromyour
car, then from the booster battery.
Disconnect the positive cable f rom
your car, then the booster battery. Start your car. If the starter motor
still operates slowly, check the
jumper cable connections to make
sure they have good metal-to-
metal contact.
Keep the ends of the jumper cables
away from each other and any metal
on the vehicle until all are
disconnected. Otherwise, you may
cause an electrical short.
The numbers in the illustration show
you the order to connect the jumper
cables.
If the booster battery is in another
vehicle, have an assistant start
that vehicle and run it at a fast idle.
5.
4. 6.
7.
Jump Starting
T aking Care of t he Unexpect ed271
BOOSTER BATTERY

This indicator should come on when
the ignition switch is ON (II), and go
out af ter the engine starts. If it
comes on brightly when the engine
is running, it indicates that the
charging system has stopped
charging the battery.By eliminating as much of the
electrical load as possible, you can
drive several miles (kilometers)
before the battery is too discharged
to keep the engine running. Drive to
a service station or garage where
you can get technical assistance.
Immediately turn of f all electrical
accessories: radio, heater, A/C, rear
def ogger, cruise control, etc. Try not
to use other electrically-operated
controls such as the power windows.
Keep the engine running and take
extra care not to stall it. Starting the
engine will discharge the battery
rapidly.
Charging System Indicator
T aking Care of t he Unexpect ed275
CHARGING SYSTEM INDICATOR

Your car has certain ‘‘readiness
codes’’ that are part of the on-board
diagnostics f or the emissions
systems. In some states, part of the
emissions testing is to make sure
these codes are set. If they are not
set, the test cannot be completed.
If your car’s battery has been
disconnected or gone dead, these
codes are erased. It takes several
days of driving under various
conditions to set the codes again.If possible, do not take your car f or a
state emissions test until the
readiness codes are set. To check if
they are set, turn the ignition ON (II),
but do not start the engine. The
Malf unction Indicator Lamp will
come on f or 20 seconds. If it then
goes of f , the readiness codes are set.
If it blinks 5 times, the readiness
codes are not set. See State
Emissions Testing on pages and
.
300 299
Readiness Codes
Malf unction Indicator L amp
T aking Care of t he Unexpect ed277

The under-hood f use box is located
in the engine compartment next to
the battery. To open it, push the tab
as shown.
All the electrical circuits in your car
have fuses to protect them from a
short circuit or overload. These
fusesarelocatedintwoorthreefuse
boxes.
The interior f use box is underneath
the dashboard on the driver’s side.
Removethefuseboxbyturningthe
knob and pulling the lid straight out
of its hinges.
Fuses
T aking Care of t he Unexpect ed280
INTERIOR
UNDER-HOOD
TAB

µ
No.Circuits Protected
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21 25 Condenser f an
Small Light
Interior Light
Cooling Fan
Hazard
FI ECU
Horn, Stop
ABS (F/S)
Back Up
ABS Motor
Rear Demister
Heater Mortor
Power Window
Option
Lef t Headlight
Door Lock
Right Headlight
Not Used
Main Fuse Battery
Main Fuse Ignition
Spare Fuse
T aking Care of t he Unexpect ed
Fuses
284
UNDER HOOD FUSE BOX

If you decide to tow your car with all
f our wheels on the ground, make
sure you use a properly-designed and
attached tow bar. Prepare the car for
towing as described above, and leave
the ignition switch in Accessory (I)
so the steering wheel does not lock.
Make sure the radio and any
electrical accessories are turned of f
so they do not run down the battery.
Emergency T owing
T aking Care of t he Unexpect ed286
Trying to lif t or tow your car by the
bumpers will cause serious damage.
The bumpers are not designed to
support the car’s weight.
The steering system can be damaged if
the steering wheel is locked. Leave the
ignition switch in Accessory (I), and
make sure the steering wheel turns
f reely bef ore you begin towing.

µ
Î
Î
Î
Î
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
Î
ÎÎÎ
ÎÎÎ
Î
Specif ications
T echnical Inf ormation291
Fuses
Capacities
Battery Alignment
Tires
Lights
0.0in(0mm)
0.08 in (2.0 mm) 0°00’
Interior
Under-hood
1.8 US qt (1.7
)
1.6 US qt (1.5)
2.9 US qt (2.7
)
6.9 US qt (6.5)
2.6 US qt (2.5)
4.8 US qt (4.5)
Manual
transmission
fluid
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V55 W
55 W
21 W
21 W
21 W/5 W
21 W
5W
21 W
5W
8W
5W
8W See page
283or the fuse label
attached to the inside of the fuse
box door under the dashboard.
See page 284or the fuse box
cover.
12 V 5 W (Amber)
Capacity 12 V 36 AH/5 HR3.4 W
12 V 0°45’
1°30’
Toe-in
Camber
Caster
Size
Pressure
P205/55R16 89V
T135/70D15 99M
T125/70D16 96M P195/65R15 89H
33 psi (230 kPa , 2.3 kgf/cm
)
31 psi (220 kPa , 2.2 kgf/cm)
60 psi (420 kPa , 4.20 kgf/cm)
Headlights
Front turn signal
Front position lights
Rear turn signal lights
Brake/Taillights
High-mount brake light
Rear side marker lights
Back-up lights
License plate lights
Ceiling light
Cargo area light
Spotlights
Glove Box light Change
Total
Change
Total
U.S. cars
Canadian cars
Front/Rear
Spare
Front
Rear
Spare
High
Low
1:
2:
3:
4:Front
Rear
Front
Rear
Front
Canadian RSX
U.S. RSX
Canadian Premium
Type-S
Automatic trans-
mission fluid
Windshield
washer reservoir
1
2, 3, 4
1, 2, 3
4

CONT INUED
If you take your vehicle f or a state
emissions test shortly af ter the
battery has been disconnected or
gone dead, it may not pass the test.
This is because of certain ‘‘readiness
codes’’ that must be set in the on-
board diagnostics f or the emissions
systems. These codes are erased
when the battery is disconnected,
and set again only after several days
of driving under a variety of
conditions.If the testing f acility determines that
the readiness codes are not set, you
will be requested to return at a later
date to complete the test. If you must
get the vehicle re-tested within the
next two or three days, you can
condition the vehicle for re-testing
by doing the f ollowing.
Make sure the gas tank is nearly,
but not completely, f ull (around
3/4).
Make sure the vehicle has been
parked with the engine of f f or 8
hours or more.
Make sure the ambient
temperature is between 20° and
95°F. Without touching the accelerator
pedal, start the engine and let it
idle f or 20 seconds.
Keep the vehicle in Park
(automatic transmission) or
Neutral (manual transmission).
Increase the engine speed to 2,000
rpm and hold it there until the
temperature gauge rises to at least
1/4of thescale(approximately3
minutes).
St at e Emissions T est ing
T echnical Inf ormation
T esting of Readiness Codes
299