2003 Acura CL light

Your car comes with two master
keys and a valet key.
The master key fits all the locks on
your car:
 Ignition
 Doors
 Trunk pass-through cover
Glovebox
 Rear console compartmentThe valet key works only in the
ignition and the door locks. You can
keep the trunk pass-through cover,
glove box, and rear console
compartment locked when you leave
your car and the valet key at a
parking f acility.
Youshouldhavereceivedakey
number plate with your keys. You
will need this key number if you ever
have to get a lost key replaced. Keepthe plate stored in a saf e place. If you
need to replace a key, use only an
Acura-approved key blank.
These keys contain electronic
circuits that are activated by the
Immobilizer System. They will not
work to start the engine if the
circuits are damaged.
Protect the keys f rom direct
sunlight, high temperature, and
high humidity.
Donotdropthekeysorsetheavy
objects on them.
Keep the keys away f rom liquids.
If they get wet, dry them immedi-
ately with a soft cloth.
The keys do not contain batteries.
Do not try to take them apart.
Keys
Keys and Locks
Inst rument s and Cont rols78
V V
A
AL
LE
E T
T K
KEEY
Y
(
( G
Gr raa y
y))
M
M
A
AS
STTE
ER
R
K
KE EY
YS S
(
( B
Bl laa c
ckk) )
K
KE
EY
Y N
NUUMM B
BEER
R P
PL
LAA T
TE
E

µµµ
µ
You can insert or
remove the key only in this position.
To switch f rom ACCESSORY to
LOCK, you must push the key in
slightly as you turn it. The shif t lever
must also be in Park. The anti-thef t
lock will lock the steering column
when you remove the key.
If the f ront wheels are turned, the
anti-thef t lock may sometimes make
it difficult to turn the key from
LOCK to ACCESSORY. Firmly turn
the steering wheel to the lef t or to
the right as you turn the key. In this position,
you can operate the audio system
and the accessory power sockets.
This is the normal key
position when driving. All f eatures
and accessories on the car are usable.
Several of the lights on the instru-
ment panel come on as a test when
you turn the ignition switch f rom
ACCESSORY to ON.
Use this position
only to start the engine. The switch
returns to ON (II) when you let go of
the key. The engine will not start if the
Immobilizer System does not
recognize the key’s coding (see page
).
You will hear a reminder beeper if
you leave the key in the LOCK (0) or
ACCESSORY (I) position and open
the driver’s door. Remove the key to
turn of f the beeper. 79
L OCK (0)
A CCESSORY (I)
ON (II)
ST A RT (III)
Keys and Locks
Inst rument s and Cont rols81

If you f orget and leave the key in the
ignition switch, Lockout Prevention
will not allow you to lock the driver’s
door. With the driver’s door open
andthekeyintheignition,both
master door lock switches are
disabled. However, if the driver’s
door is not open, the master door
lock switches are not disabled.
Pushing the switch down on the
open passenger’s door will lock both
doors. If you try to lock an open
driver’s door by pushing down the
lock tab, the tabs on both doors pop
up. Pushing down the lock tab on the
passenger’s door only locks that door.You can lock and unlock your car
with the remote transmitter. When
you push the LOCK button, both
doors lock. The parking lights, side
marker lights, taillights and license
plate light will f lash once.
When you push the LOCK button a
second time within 5 seconds after
you have locked the doors, you will
hear a beep to verify that the doors
arelockedandthesecuritysystemhas set.
When you push the UNLOCK button
once, only the driver’s door unlocks.
The passenger’s door unlocks when
you push the button a second time.
The parking lights, side marker
lights, taillights and license plate
light f lash twice each time you push
the button.
The ceiling light (if the ceiling light
switch is in the center position) will
come on when you press the
UNLOCK button. If you do not open
either door, the light stays on f or
about 10 seconds, then f ades out. If
you relock the doors with the remote
transmitter before 10 seconds have
elapsed, the light will go of f
immediately.
CONT INUED
Remote TransmitterL ockout Prevent ion
Keys and Locks
Inst rument s and Cont rols83
L L
E
E D
D
U
UN NLLO
OC CKK
B
BU UT TT
TO
ON N L
L
O
OC CKK
B
BU UT TT
TO
ON N
T
T R
RU UN NKK
R
RE EL
LE
E A
A S
SEE
B
BU UT TT
TO
ON N
P
P A
A N
NI ICC
B
BU UT TT
TO
ON N

CONT INUED
Panic mode will not activate if the
ignition switch is in the ON (II)
position. Panic mode allows you to remotely
activate your car’s security system to
attract attention. When activated, the
horn will sound, and the exterior
lights will f lash, f or about 30 seconds.
To activate panic mode, press and
hold the PANIC button for about two
seconds. To turn it back on, repeat this
procedure. The LED will come on
f or one second to indicate the
f eature has been turned on.
To cancel Panic mode bef ore 30
seconds, press any button on the
remote transmitter. You can also
turn the ignition switch to ON (II).When the remote transmitter’s
battery begins to get weak, it may
take several pushes on the button to
lock or unlock the doors, and the
LED will not light. Replace the
battery as soon as possible.
Battery type: CR2025
To replace the battery, place a cloth
on the edge of the transmitter and
remove the upper half by carefully
prying on the edge with a small f lat-
tip screwdriver.
Replacing the Battery
Panic Mode
Keys and Locks
Inst rument s and Cont rols85

The glove box light comes on only
when the parking lights are on. Open the glove box by squeezing the
handle. Close it with a f irm push.
Lock or unlock the glove box with
the master key.To open the rear console
compartment, pull up on the lever
and lif t the lid. To close, lower the lid
and push it down until it latches.
The rear console compartment can
be locked and unlocked only with the
master key. The rear console compartment is
located in the center of the rear seat.
Glove Box
Rear Console Compartment
Keys and Locks
Inst rument s and Cont rols90
R REEA
A R
R C
COON NSSOOL LEE C
COOM M P
PA
A R
RTTM
M E
EN
NT T
G
GL
LO
OV VE
E
B
BO OX X
An open glove box can cause
serious injury to your passenger
inacrash,evenifthe
passenger is wearing the seat
belt.
Always keep the glove box
closed while driving.

To get into the rear seat, open the
door and pull the release lever up on
thesideof theseat-back.Theseat-
back will tilt f orward and the entire
seat will move forward to allow
easier entry to the rear seat.After you return the seat-back to the
upright position, the seat bottom will
automatically return to its original
position.
If the seat runs into any obstacle,
such as a large package on the floor
between the f ront and rear seats
while it is moving back to its original
position, the seat will stop and move
f orward slightly.
Remove the obstacle, then move the
seat to the desired position with the
adjustment switch.
To move the driver’s seat, you can
select the memorized position with
the memory button.
Sitting down heavily in the seat as it
is moving backward can also cause
the seat to react as if it has run into
an obstacle.
Rear Seat Access
Seat A djustments
Inst rument s and Cont rols94
R RE
EL
LE
E A
A S
SEE L
LEE V
V E
ER
R

Turn the ignition switch ON (II).
Move the selector switch to L
(driver’s side) or R (passenger’s
side).
Adjust the outside mirrors with the
adjustment switch on the driver’s
door armrest:
Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.
The inside mirror can automatically
darken to reduce glare. To turn on
this feature, press the button on the
bottom of the mirror. The AUTO
indicator comes on as a reminder.
When it is on, the mirror darkens
when it senses the headlights of a
vehicle behind you, then returns to
normal visibility when the lights are
gone. Press the button again to turn
of f this sensing.1.
2. Adjusting the Power Mirrors
Mirrors
Inst rument s and Cont rols98
I IN
ND DI
ICCA A T
TO
OR R S
SE
EL
LEE C
CT TO
OR R S
SWWI ITT C
CH H
A
A U
UT TO
O B
BUUT TT
TO
ON N
S
SE
EN
NS SOOR R
I
INND DI
ICCA A T
TO
OR R
W
Wi
itth h o
ou
ut
t O
On nS
St taar r W
Wi
itth h O
OnnS
St taar r
A
A U
UT TO
O B
BUUT TT
TO
ON N

The outside mirrors are heated to re-
move fog and frost. With the ignition
switchON(II),turnontheheaters
by pressing the button. The light in
the button comes on as a reminder.
Press the button again to turn the
heaters of f .
Push the appropriate edge of the
adjustment switch to move the
mirrorright,left,up,ordown. When you f inish, move the
selector switch to the center (off)
position. This turns of f the
adjustment switch so you can’t
move a mirror out of position by
accidentally bumping the switch.
Outside mirror positions can be
stored in the driving position
memory system (see page ). With the selector switch in the
center (of f ) position, the passenger’s
side mirror will pivot downward
slightly when you shif t the
transmission into reverse. This gives
you a better view of that side of the
vehicle while parallel parking. The
mirror returns to its original position
when you take the transmission out
of reverse. 4.
3. 100
Mirrors
Inst rument s and Cont rols99
H HE
EA
A T
TE
ED
D M
MI
IRRR ROOR R B
BUUT TT
TO
ON N
A
A
D
DJ
JUUS STTM
M E
EN
NT T S
SWWI ITT C
CH H