2003.5 Peugeot Boxer Dag coolant temperature

17-11-2003
Recommended lubricants The oils which appear in the table opposite are suitable for most purposes.
The diagram opposite states theoptimum range of viscosity depend-ing on the temperatures at which theoils are to be used. It is also possible to use "superior quality" synthetic oils. In the absence of semi-synthetic or
synthetic oils, oils of ACEA A1/A2
and API SH/SJ/SL quality (for petrol
engines), or ACEA B1/B2 and APICD/CF quality (for diesel engines)may be used by following the"Arduous Conditions" servicingschedule, which specifies shorterintervals. Do not hesitate to ask for advice
from a PEUGEOT dealer to maintaindriving pleasure and to minimise themaintenance cost of your vehicle. For countries outside Europe, please
contact a local PEUGEOT dealer.
PEUGEOT SERVICING 27
ONLY ONLY
Manual ESSO Gear Oil BVTOTAL TRANSMISSION BVGearbox 75W80 PR 9736.41 75W80 PR 9730.A2
ONLY
Automatic ATF 4HP20
Gearbox PR 9736.22
Other recommended products
Power steering FLUIDE DA PR 9730.A1
Brake fluid PEUGEOT DOT4 Coolant
PROCOR TM 108/GLYSANTIN G33 or REVKOGEL 2000
ONLYProtection to minus 35 ¡C

17-11-2003
1 -Coolant temperature gauge.
2 - Coolant temperature warning light.
3 - Speedometer.
4 - Left-hand direction indicator.
5 - Side lights and dipped beamheadlamps indicator light.
6 - Main beam headlamps indicatorlight.
7 - Right-hand direction indicator. 8 -
Rev counter.
9 - Low fuel level warning light.
10 - Fuel gauge.
11 - Brake fluid level warning light.
12 - Traction control (ASR) warninglight.
13 - Passenger air bag disarmedwarning light.
14 - Trip distance recorder displaycontrol and zero reset button. 15 -
Front air bags warning light.
16 - Anti-lock braking system (ABS) warning light.
17 - Automatic gearbox temperatureor fault warning light.
18 - Low coolant level warning light.
19 - Service indicator, oil levelgauge, automatic gearbox
display, clock and total distance
recorder.
20 - Diesel engine pre-heatingwarning light.
21 - Engine oil pressure warninglight.
22 - Battery charge warning light.
23 - Clock setting button.
24 - Engine diagnostics warninglight.
25 - Front brake pad wear warninglight.
26 - Handbrake warning light.
27 - Water in diesel filter warninglight.
28 - Electronic immobiliser keywarning light.
INSTRUMENTS AND CONTROLS
28
PETROL-DIESEL MANUAL AND AUTOMATIC GEARBOX
INSTRUMENT PANELS

Low coolant level warning light Illumination of this warning light indicates that the coolant level is too
low.
Stop immediately.
Warning: allow the engine to cool before topping up.
The cooling circuit is pressurised.
To avoid any risk of scalding, unscrew the cap by two turns to allow the pressure
to drop. When the pressure has dropped, remove the cap and top up the level.
Contact a PEUGEOT dealer.
INSTRUMENTS AND CONTROLS 29
Engine oil pressure warning light This comes on for a few seconds when the ignition is switched on. Illumination of this warning light while the engine is running indicates
that the oil pressure or level is too low.
Stop immediately. If there is a lack of oil in the lubrication circuit, top it up.
Contact a PEUGEOT dealer as soon as possible.
INSTRUMENTS AND CONTROLS
A permanently lit warning light or one that flashes while the engine is running indicates an operating fault. The illumination of certain warninglights may be accompanied by a bleep and a message on the multi-
function display. Do not ignore this warning: contact your PEUGEOT dealer as soon as possible.
Handbrake warning light This comes on for a few seconds when the ignition is
switched on.Illumination of this warning light indi-cates that the handbrake is applied
or has not been released correctly.Coolant temperature warning light This comes on for a few seconds when the ignition is
switched on.Illumination of this warning light indi-cates an abnormal increase in thecoolant temperature.
Stop immediately.
Contact a PEUGEOT dealer.
17-11-2003

17-11-2003
INSTRUMENTS AND CONTROLS
32
Automatic gearbox temperature or fault warning light This comes on for a few seconds when the ignition is switched on. Illumination or flashing of this warning light while the engine is running
and the vehicle is moving indicates an automatic gearbox fault or an excessive automatic gearbox temperature.
Stop immediately.Allow the engine to run at idle (lever in position Nor P) until the warning light
switches off.
Contact a PEUGEOT dealer as soon as possible.
Coolant temperature gauge When the needle is in zone A, the
temperature is correct. When the needle is in zone B, the
temperature is too high.
Stop immediately.
Warning: allow the engine to cool
before topping up.The cooling circuit is pressurised.
To avoid any risk of scalding, unscrew the cap by two turns toallow the pressure to drop. When the pressure has dropped, remove the cap and top up the level.
Contact a PEUGEOT dealer.

17-11-2003
INSTRUMENTS AND CONTROLS
32
Automatic gearbox temperature or fault warning light This comes on for a few seconds when the ignition is switched on. Illumination or flashing of this warning light while the engine is running
and the vehicle is moving indicates an automatic gearbox fault or an excessive automatic gearbox temperature.
Stop immediately.Allow the engine to run at idle (lever in position Nor P) until the warning light
switches off.
Contact a PEUGEOT dealer as soon as possible.
Coolant temperature gauge When the needle is in zone A, the
temperature is correct. When the needle is in zone B, the
temperature is too high.
Stop immediately.
Warning: allow the engine to cool
before topping up.The cooling circuit is pressurised.
To avoid any risk of scalding, unscrew the cap by two turns toallow the pressure to drop. When the pressure has dropped, remove the cap and top up the level.
Contact a PEUGEOT dealer.

YOUR BOXER IN DETAIL
94
PROGRAMMABLE HEATING
(Webasto)* The programmable heating is provi-
ded to operate with the engine off. Itpermits heating of the passengercompartment, de-icing of the win-dows and pre-heating of the coolantcircuit to provide an optimum opera-ting temperature when the engine isswitched on.
* According to destination. Control panel/digital programmer The programmable heating system's control panel is located to the left ofthe instrument panel. 1.
Heating cycle indicator light.
2. Screen lighting.
3. Display of the number of the selected programme.
4. Time display button.
5. Time setting buttons.
6. Selection of the stored program-me.
7. Heating immediate start-up but-ton.
8. Time setting and display indicatorlight.
TIME DISPLAY Press button 4.
The time display indicator light 8
comes on and the time is displayed for approximately ten seconds. SETTING THE CLOCK Press button 4. The screen and the
setting indicator light 8come on.
Within ten seconds, press one of the buttons 5until the correct time is dis-
played:
Ð press button ">"to move the clock
on,
Ð press button "<"to move the clock
back.
Note: continuous pressing of buttons
">" or "<" scrolls through the digits
more quickly.
17-11-2003

17-11-2003
PRACTICAL INFORMATION
134
CHECKING THE LEVELS Oil level Check the level regularly and top
up between changes. The maxi-mum consumption is 0.5 l per
600 miles (1 000 km). Check the level with the vehicle level, engine cold, using the oillevel gauge on the instrumentpanel or the dipstick.
Dipstick
There are two marks onthe dipstick: A=maximum
Never fill past this mark.B= minimum
To maintain the reliability of engines and emissioncontrol systems, the useof additives in engine oilis prohibited.
Oil change According to the information given in
"PEUGEOT SERVICING" .
Note: avoid used oil coming into
prolonged contact with the skin.
Viscosity selection In all cases, the oil selected must meet the manufacturer's require-ments. Brake fluid level:
Ð The level must always be between the DANGER and MAXIMUM
marks in the reservoir.
Ð If the level drops substantially, contact a PEUGEOT dealer
immediately.
Fluid change:
Ð must be carried out according to the manufacturer's servicing schedule.
Ð use fluids recommended by the manufacturer, which fulfil DOT4standards.
Note: brake fluid is harmful to health
and very corrosive. Avoid all contactwith the skin. Cooling system Use the fluid recommended by the
manufacturer. When the engine is warm, the tem- perature of the coolant is controlled
by the engine fan. As this fan canoperate with the ignition keyremoved and because the coolingsystem is pressurised, wait for atleast one hour after the engine hasstopped before carrying out anywork. Slacken the cap to the first notch torelease the pressure to prevent anyrisk of scalding. When the pressurehas dropped, remove the cap andtop up the level. Note:
the coolant does not need to
be changed. Used oil Do not dispose of used oil, brake fluid or coolant into drains or into theground. Power steering reservoir  Open the reservoir, with the engine at ambient temperature.The level should always beabove the MIN. mark and closeto the MAX. mark.
Windscreen and headlamp* wash level For best quality cleaning and for your
safety, we would advise that you use
products recommended by PEUGEOT.
* According to destination.

17-11-2003
TOWING A TRAILER,
CARAVAN, BOAT etc.
Only use original PEUGEOT tow bars that have been tested andapproved from the design stage ofyour vehicle. The tow bar must be fitted by a
PEUGEOT dealer.
Your vehicle is primarily designed for transporting people and luggage butit may also be used for towing a
trailer. Driving with a trailer subjects the towing vehicle to more significantstress and its driver must be particu-larly careful. Air density decreases with altitude, thus reducing engine performance.
Above 1 000 metres, the maximum
towing load must be reduced by 10 %
and so on for every 1 000 metres ofaltitude.Driving advice Distribution of loads:
Distribute the
load in the trailer so that the heaviest items are as close as possible to theaxle and the nose weight approachesthe maximum permitted withoutexceeding it. Cooling: Towing a trailer on a slope
increases the temperature of the coolant. As the fan is electrically controlled, its cooling capacity is not dependenton the engine speed.
On the contrary, use a high gear to lower the engine speed and reduceyour speed. The maximum towing load on a long slope depends on the gradient andthe outside temperature. In all cases, pay attention to the coolant temperature. If the warning light comes on, stop
the vehicle and switch off the engineas soon as possible. Tyres:
Check the tyre pressures
of the towing vehicle and of the
trailer, observing the recommendedpressures. Braking: Towing increases the
braking distance. Lights: Check the electrical signal-
ling on the trailer.Side wind: Take into acount the
increased sensitivity to side wind.
PRACTICAL INFORMATION 149