Page 29 of 181
17-11-2003
INSTRUMENTS AND CONTROLS
32
Automatic gearbox temperature or fault warning light This comes on for a few seconds when the ignition is switched on. Illumination or flashing of this warning light while the engine is running
and the vehicle is moving indicates an automatic gearbox fault or an excessive automatic gearbox temperature.
Stop immediately.Allow the engine to run at idle (lever in position Nor P) until the warning light
switches off.
Contact a PEUGEOT dealer as soon as possible.
Coolant temperature gauge When the needle is in zone A, the
temperature is correct. When the needle is in zone B, the
temperature is too high.
Stop immediately.
Warning: allow the engine to cool
before topping up.The cooling circuit is pressurised.
To avoid any risk of scalding, unscrew the cap by two turns toallow the pressure to drop. When the pressure has dropped, remove the cap and top up the level.
Contact a PEUGEOT dealer.
Page 30 of 181
17-11-2003
INSTRUMENTS AND CONTROLS
32
Automatic gearbox temperature or fault warning light This comes on for a few seconds when the ignition is switched on. Illumination or flashing of this warning light while the engine is running
and the vehicle is moving indicates an automatic gearbox fault or an excessive automatic gearbox temperature.
Stop immediately.Allow the engine to run at idle (lever in position Nor P) until the warning light
switches off.
Contact a PEUGEOT dealer as soon as possible.
Coolant temperature gauge When the needle is in zone A, the
temperature is correct. When the needle is in zone B, the
temperature is too high.
Stop immediately.
Warning: allow the engine to cool
before topping up.The cooling circuit is pressurised.
To avoid any risk of scalding, unscrew the cap by two turns toallow the pressure to drop. When the pressure has dropped, remove the cap and top up the level.
Contact a PEUGEOT dealer.
Page 48 of 181
Superimposed display In certain cases, when a function
(radio, telephone, trip computer, ...)changes status while another func-tion is displayed, a window opensto inform you of the change, thendisappears.
MULTI-FUNCTION
DISPLAYS Presentation Monochrome display Colour display These two multi-function displays are an integral part of the audio/tele-
phone/GPS . Therefore, they are
controlled by its control keypad andby its steering wheel stalk. They enable you to obtain the follow-ing information:
Ð displaying of the audio sources
(radio, CD),
Ð displaying of the telematic systems (telephone, services, ...),
Ð displaying of the satellite naviga- tion system (see corresponding section),
Ð displaying of the trip computer (see corresponding section),
Ð the warning messages (e.g. "Warning, maximum speedexceeded") or information mes-sages (e.g. "SIM card absent") dis-
played temporarily.
YOUR BOXER IN DETAIL
50
Main screen Press the
"MAIN/DARK" button to
display the main screen , display
the information relating to the active source (radio, CD, tele-phone or navigation) and gainaccess to the following functions:
Ð Voice memory,
Ð Setup. The "Voice Memory" function per-
mits management of the recorded
voice messages. You can listen tothem again or delete them.
The messages are played in sequence,from the oldest to the most recent.
Deleting deletes all of the messages. The "Setup" function permits
modification of the general system parameters (see ¤ "Parameterconfiguration").
17-11-2003
Page 49 of 181
17-11-2003
Ð Following selection of a functionfrom the menu, the sub-menu
appears on the right-hand side of
the display .
Ð The values corresponding to each of the functions of the sub-menu appear opposite on the left-hand
side of the display .
YOUR BOXER IN DETAIL 51
Pull-down menu This is the menu associated with the application in use at the base of the
display. When the menu consists of several pages, access to the next page isby selecting the "Other menus"
function.
Parameter configuration Commands & Setup menu The "Commands & Setup" menu
provides access to the following gen- eral parameters:
Ð "Setup": choice of day/night bright- ness, display colours, voice/text message language and distanceunit,
Ð "Fleet Management": configuration of the automatic vehicle locationSMS messages,
Ð "Speed Limit Warning": setting, activation and display of exceedingof the permitted speed,
Ð "Modem": activation/deactivation of the communication between thesystem's modem and the laptop.
Page 50 of 181
YOUR BOXER IN DETAIL
52
Setup The "Day brightness" and "Night
brightness" functions enable you to
set day and night brightness values
independently. The "Colours" function controls dis-
playing on the day or night setting or changes the setting automatically inrelation to the light in the passengercompartment or switching on of thelights. The "Voice language" and "Text
language" functions enable you to
choose the language for voice recog- nition and SMS messages (Italian,German, English, Spanish, French,Portuguese, Dutch). The "Distance unit" function
enables you to choose the distance unit for the trip computer calculations(km or miles). Note: to choose the language and
the distance unit, insert the configu- ration CD-Rom. Fleet Management The
"Fleet Management" function
permits locating of the vehicle by means of the automatic transmissionof SMS messages to a control centre.
To have the SMS messages sent, you must:
Ð activate the "Sending mode" function,
Ð select a type of interval in the "Event mode" function,
Ð set the duration of the interval in the "Data frequency send" function,
Ð enter the registration number in the "Vehicle ID" function,
Ð enter the telephone number of the control centre in the "Telephone number" function,
Ð insert the SIM card.
Speed Limit Warning The "Speed Limit Warning" func-
tion enables you to monitor the speed of the vehicle.
To enable the system to detect an excessive speed and warn you ofthis, you must:
Ð activate the "Alarm" function,
Ð set the permitted speed in the "Speed Limit" function,
Ð activate the "Buzzer" function.
17-11-2003
Page 67 of 181
17-11-2003
YOUR BOXER IN DETAIL
68
Entering the PIN Enter your PIN using the numeric keypad and confirm by pressing knob Hor button
# to gain access to the network. Connection to the network is confirmed by the appea-
rance of the name of the network on the display.
Warning: if you make three mistakes in succession when entering your PIN, your SIM
card will be blocked. To release it, you will have to enter the PUK code and a new PIN.
You will be provided with the PUK code by the vendor of your SIM card (entering ofthe PUK code allows for 10 mistakes in succession, after this the SIM card is perma-nently unusable). Note: the PIN is requested each time the ignition is switched on, unless the PIN has
been stored or PIN protection is not activated on the SIM card.
Deactivation of the PIN request From the main menu, select "PIN"and enter your PIN, then select "Enable PIN search", then press knob H.
Warning: in this case, do not lose your SIM card, otherwise anyone who finds it will be able to make unlimited calls.
Telephone function screens Not in communicationThis screen indicates, at the top, the strength of signal, the name of the network, the telephone not operational message (SIM card not inserted), call diversion activated/deactivated, the presence of voice messages or text messages (SMS) notlistened to/read, the emergency call in progress message and the credit available
in the case of a pre-paid SIM card*. In communication This screen indicates, at the bottom, the time elapsed since the beginning of the com- munication, the number** or the name of your contact (if recorded in the directory) andthe status of your telephone. * If the service is available.
Page 79 of 181
17-11-2003
General menu Switch the audio/telephone/GPS on and insert the navigation CD-Rom. Press the "NAV"button to gain
access to the "Warnings" page. Note: the "Warnings" page appears
when the engine is switched on and when you select the "Navigation"function.
YOUR BOXER IN DETAIL
80
During guidance, if the navigation CD-Rom is present, the display shows various kinds of information depending on the manoeuvres to be carried out.
Current manoeuvre or compass.
Next manoeuvre to be carried out.
Next road to be taken.
Current road.
Estimated time of arrival at the destination.
Distance to the final destination.
Distance to the next manoeuvre.
Note: depending on the vehicle's situation and the reception of the GPS infor-
mation, this information may disappear from the display temporarily.
General notes on the display
Monochrome display Colour display
Page 105 of 181
17-11-2003
YOUR BOXER IN DETAIL105
SEAT BELTS
To adjust the height of the front seat belts
To lower the attachment point, press the upper control and slide itdownwards.
To raise the attachment point,slide the control upwards.
To lock the seat belts Pull the strap, then insert the buckle into the stalk. Pre-tensioning front seat belts Safety in the event of a frontal impact has been improved by the introduc-tion of pre-tensioning front seat belts.Depending on the seriousness of theimpact, the pre-tensioning systeminstantly tightens the seat belt firmlyagainst the body of the occupant. The pre-tensioning seat belts are armed when the ignition is on. Rear seat belts Minibus:
the rear seats are all fitted
with three-point inertia reel seat belts. Combi: the rear side seats are fitted
with three-point inertia reel seat
belts. The centre seats are fitted withlap seat belts
To be effective, a seat belt must be tightened asclose to the body as pos-sible.
Depending on the nature and theseriousness of the impact, thepre-tensioners may be triggeredbefore and independently of theair bags. In all cases of an air bag being triggered, the air bag warning lighton the instrument panel comeson. After an impact, have the system
checked by a PEUGEOT dealer.
