<5
4D@
55 <@ The four speed automatic gearbox offers a
choice between the comfort of automatic inte-
gral regulation enhanced by a sportand snow
programme , or the pleasure of manual gear
changing .
#$&"(%!" * *
%
%
+
@ %
% %
&(
&+
1&&+
1&+
1 (**%>($( ") =)(&$ "#" ") !(!
"%%+ * 1 #=# ,
%
*
(
-+
1 "#"")!(! +#'
"+
%"1
% &
"(
*
&"%
%
:+
:
* 1% -"%*"(&
+
< 1% *!-$
+
6 ,%-##(>
1* E("&<&
F("+
%"1 ,&- ,- & &
+ <%=(!,,
.
*
%%%&
>
5" ( !"($ "% +# ")
>#' +.$ "% C(" +%("(%!
6
%
: <
(
& " &=
*
* %%
(+
B * %% %&
>
3 "
(%"+
%
: <
( &
" &=
*
* %%
(+
When the engine is idling with the brakes notapplied, if function R, D
or Mis selected, the vehi-
cle moves without the acceleratorbeing pressed.
$
.% !%" $=
&)($.#! -!-+#=(.
(!(. ") =)(&$6 3(")
")!(!#-!!(!/
#
29-09-2003
D
The menu CC' 2!CC
provides access to the following functions:
– changing of the route calculation criteria,
– voice synthesis adjustment of guidance messages,
– description of the information relating to the navigation CD-Rom,
– management of the addresses stored in the directory.
'2!
The last criterion used is displayed. Select a criterion from the list, then validate by pressing the dial. When the criterion of your choice has been selected, select the
1:1
function then confirm by pressing thedial.
?!%*''!&*'!!' Select the type of voice 1( '1or
1/'( '1 , after inserting the configu-
ration CD-Rom. Adjust the volume of the voice synthesis by turning the dial, then validate bypressing the dial. '0 the volume can also be adjusted
during a message, using the audio/ telephone button or the steeringwheel control. %'('/*''& This function enables you to rename
an address stored in the directory. Select the description corresponding to the stored address to be changed. Select the
1'('1 function, then
confirm by pressing the dial. Select the 1:1function, then confirm
by pressing the dial to record the changes made.
22%E'!(%%'
"Stop guidance" During guidance, select this function then validate.
"Resume guidance" In the absence of guidance, select this function then validate to activateguidance to the last destination pro-grammed. '0 after re-starting the engine, a
screen appears enabling you to resume guidance activated before
the ignition was switched off.
+ '
+ & '(& The confidential card contains the identification code necessary for anywork carried out by a PEUGEOTdealer on the electronic immobiliser
system. This code is hidden by afilm, which should be removed only if
necessary.
4
.0( '(& +
'9
,( &
,
'6
4. -
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition.
- -
(.+
(*'(
Warning that the battery is flat is given by an audible signal accompa-nied by the message
::*';
( (. :: on the multi-func-
tion display.
To replace the battery, remove the screw then unclip the casing using acoin at the ring (CR 2016/3 volt battery). If the remote control does not work after the battery has been changed,reprogramme the remote control.
<(-(** -
(* '( Switch off the ignition.
Switch the ignition on again.
Immediately press button .
Switch off the ignition and remove the remote control key
from the ignition lock. The remotecontrol is now working again.
!"#
$!2
8 This locks the engine control system as soon as the ignition has been
switched off and therefore preventsstarting of the vehicle by anyone
who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode must be recognised for startingto be possible.
+
.* & +0' '(('. , the central locking button
indicator light, situated in the centreof the fascia, flashes rapidly whenthe ignition is switched on (2ndnotch), accompanied by an audiblesignal and the message = ;
+
&, ' +0.= on the multi-function
display. In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.
29-09-2003
29-09-2003
Make a careful note of the number on each key. The key number is coded on the label attached to the key. If the keys are lost, your PEUGEOT dealer can rapidly supply you with new keys.The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock your vehicle, without you being aware of it.
The remote control does not operate when the key is in the ignition, even when the ignition is switched off, except forreprogramming. Do not operate the deadlocking function if there is anyone inside the vehicle.Driving with the doors locked may make access to the passenger compartment by the emergency services more difficult
in an emergency. As a safety precaution (with children on board), remove the ignition key when you leave the vehicle, even for a short time.
Do not repeatedly press the button of your remote control out of range of your vehicle. You run the risk of stopping it from working and the remote control would have to be reprogrammed. When purchasing a second-hand vehicle: Ð ensure that you are given the confidential card;
Ð have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones which can start the vehicle.
Do not make any modifications to the electronic engine immobiliser system.
!"# $!"
+ & '(& The confidential card contains the identification code necessary for anywork carried out by a PEUGEOTdealer on the electronic immobiliser
system. This code is hidden by afilm, which should be removed only if
necessary.
4
.0( '(& +
'9
,( &
,
'6
4. -
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition.
- -
(.+
(*'(
Warning that the battery is flat is given by an audible signal accompa-nied by the message
::*';
( (. :: on the multi-func-
tion display.
To replace the battery, remove the screw then unclip the casing using acoin at the ring (CR 2016/3 volt battery). If the remote control does not work after the battery has been changed,reprogramme the remote control.
<(-(** -
(* '( Switch off the ignition.
Switch the ignition on again.
Immediately press button .
Switch off the ignition and remove the remote control key
from the ignition lock. The remotecontrol is now working again.
!"#
$!2
8 This locks the engine control system as soon as the ignition has been
switched off and therefore preventsstarting of the vehicle by anyone
who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode must be recognised for startingto be possible.
+
.* & +0' '(('. , the central locking button
indicator light, situated in the centreof the fascia, flashes rapidly whenthe ignition is switched on (2ndnotch), accompanied by an audiblesignal and the message = ;
+
&, ' +0.= on the multi-function
display. In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.
29-09-2003
29-09-2003
Make a careful note of the number on each key. The key number is coded on the label attached to the key. If the keys are lost, your PEUGEOT dealer can rapidly supply you with new keys.The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock your vehicle, without you being aware of it.
The remote control does not operate when the key is in the ignition, even when the ignition is switched off, except forreprogramming. Do not operate the deadlocking function if there is anyone inside the vehicle.Driving with the doors locked may make access to the passenger compartment by the emergency services more difficult
in an emergency. As a safety precaution (with children on board), remove the ignition key when you leave the vehicle, even for a short time.
Do not repeatedly press the button of your remote control out of range of your vehicle. You run the risk of stopping it from working and the remote control would have to be reprogrammed. When purchasing a second-hand vehicle: Ð ensure that you are given the confidential card;
Ð have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones which can start the vehicle.
Do not make any modifications to the electronic engine immobiliser system.
!"# $!"
29-09-2003
3
-
&(+(* 0 &
-
&(+(* & The front door opening controls per- mit complete unlocking of the vehi-cle.
However, the rear door opening controls only unlock the door concerned. /the door opening controls do
not function when the vehicle is deadlocked. '5 -@'5 -+(*
& Press button
.
This allows locking or unlocking of the doors and the tailgate. / if the vehicle is deadlocked,
button does not function. In this
case use the remote control for unlocking.
=(
=( With the engine running, an audible signal and a diagram locating thedoor briefly displayed on the multi-function display warn you that a dooris not properly closed. In addition, if the vehicle is moving, the courtesy lights flash.
&+. This prevents either of the rear doors being opened from inside.
Turn the switch a quarter of a
turn using the ignition key.
!"# $!A
29-09-2003
*00'5 -(
0'5 -+
-&
&( The tailgate is locked or unlocked by the remote control or the driver'sdoor lock.
To open, pull handle and lift the
tailgate./ the tailgate locks automatical-
ly when the vehicle is being driven at 6 mph (10 km/h) and unlocks whenone of the doors is opened if thespeed is below 6 mph (10 km/h).
= -
=( - When the engine is running, an audi- ble signal and a diagram displayedbriefly on the multi-function displaywarn you that the tailgate is not prop-erly closed. In addition, if the vehicle is being driven, the courtesy lights flash. -( This enables the tailgate to be unlocked in the event of a centrallocking fault.
– Fold back the rear seats to gain
access to the lock from inside the boot,
– Insert a small screwdriver into
hole of the lock to unlock the tailgate.
<
Your vehicle is fitted with a tinted glass panoramic roof which increas-es the light and visibility in the pas-senger compartment. Its electricconcealing shutter improves temper-ature conditions.
/ press part of the switch.
'/ press part 8of the switch.
0./ press the switch without
going past the point of resistance; the shutter stops as soon as the switch is released. 0* './ press the switch
beyond the point of resistance; one press fully opens or closes the shut-
ter. Press the switch again to stop
the shutter.
!"#
$$!