2002 YAMAHA T105 light

EAH83301Brake light switch adjustment
The brake light switch is operated by
movement of the brake pedal. To adjust,
hold the main body of the switch so it does
not rotate and turn the adjusting nut.
Proper adjustment is achieved when the
brake light comes on just before the brake
begins to take effect.EAU01119*Checking the front brake pads
Front brake pad is provided with wear indi-
cator grooves. This indicator allow you to
check the brake pad wear without disas-
sembling the brake. To check the brake pad
wear, check the wear indicator grooves. If
the brake pad wear indicator grooves have
almost disappeared, have a Yamaha dealer
replace the brake pads as a set.
54
q
1. Brake light switch
q
q
1. Brake pad wear indicator groove (
×2)
5SD O/M-3 9/4/01 2:50 PM Page 54 (1,1)

EC000096cCImproper drive chain slack will overload
the engine and other vital parts and can
lead to chain slippage or breakage. Keep
the drive chain slack within the specified
limits.4. Tighten both locknuts, and then tight-
en the axle nut to the specified torque.
5. Adjust the brake pedal free play. (See
page 53 for adjustment procedure.)
EW000103wAfter adjusting the brake pedal free play,
check the operation of the brake light.
60
Tightening torque:
Axle nut:
60 Nm (6.0 m•kg)
5SD O/M-3 9/4/01 2:50 PM Page 60 (1,1)

3. Remove the drive chain. Thoroughly
clean the chain with solvent and lubri-
cate it. Reinstall the chain or store it in
a plastic bag (tied to frame for safe-
keeping).
4. Lubricate all control cables.
5. Block up the frame to raise both
wheels off the ground.
6. Tie a plastic bag over the exhaust pipe
outlet to prevent moisture from enter-
ing.
7. If storing in a humid or salt-air atmos-
phere, coat all exposed metal surfaces
with a light film of oil. Do not apply oil
to any rubber parts or the seat cover.
8. Remove the battery and charge it.
Store it in a dry place and recharge it
once a month. Do not store the bat-
tery in an excessively warm or cold
place (less than 0°C (32°F) or more
than 30°C (86°F)).
EUU05800NOTE:
Make any necessary repairs before storing
the motorcycle.
70
5SD O/M-3 9/4/01 2:50 PM Page 70 (1,1)

75
Model
Wheel travel:
Front 90 mm
Rear 66 mm
Electrical:
Ignition system DC. CDI
Generator system A.C. magneto
Battery type/capacity 12V5AH
Headlight type: Bulb type
Bulb wattage/quantity:
Headlight 12V25W/25W ×2
Tail/brake light 12V/5W/21W ×1
Flasher light 12V10W ×4
Meter light 14V3W ×1
Indicator light wattage/quantity:
High beam indicator light 12V1.7W ×1
Turn signal indicator light 12V1.7W ×1
Neutral indicator light 12V1.7W ×1
Gear position indicator light 12V1.7W ×4
5SD O/M-3 9/4/01 2:50 PM Page 75 (1,1)