8-17
EBU00768Transmission oil
Transmission oil measurement
1. Place the machine on a level place.
2. Warm up the engine for several minutes
and then stop it.
3. Remove the dipstick and wipe it off with a
clean rag. Insert the dipstick in the filler
hole without screwing it in.NOTE:
Wait a few minutes until the oil level settles
before checking.4. Remove the dipstick and inspect the oil
level.
5. The oil level should be between the maxi-
mum and minimum marks. If the level is
low, add oil to raise it to the proper level.
6. Install the dipstick.
q
w
e
1. Dipstick
2. Maximum level mark 3. Minimum level mark1. Jauge
2. Repère de niveau maximum 3. Repère de niveau minimum1. Varilla de nivel
2. Marca de máximo 3. Marca de mínimo
5FK-9-63-8 2/7/02 1:28 PM Page 18
8-19
Transmission oil replacement
1. Place the machine on a level place.
2. Warm up the engine for several minutes
and then stop it.
3. Place a container under the engine.
4. Remove the dipstick and drain bolt to drain
the oil.
5. Install the drain bolt and then tighten it to
the specified torque.
6. Fill the engine with oil and install the dip-
stick.
q
1. Drain bolt1. Boulon de vidange1. Perno de vaciado
Tightening torque:
Drain bolt:
20 Nm (2.0 m0kg)
5FK-9-63-8 2/7/02 1:28 PM Page 20
