The remaining two HomeLink® buttons can be programmed in the same way. In the event of any problems in
programming the HomeLink® Universal Transceiver, call toll-free 1-800-355-3515 (Internet: www.HomeLink.com
).
Operating the HomeLink® Universal Transceiver
Once programmed, the HomeLink® Universal Transceiver can be used in place of your hand -held transmitters.
To operate, the key must be turned to the "accessory" position (II) or the engine must be running. Press the
programmed HomeLink® button to activate the garage door, driveway gate, security lighting, home security system,
etc.
Your original hand -held transmitters may, of course, be used at any time.
Erasing programmed buttons
Individual buttons cannot be erased. To erase all three programmed buttons:
1. Turn the ignition key to the "accessory" position (II).
2. Hold down the two outside buttons on the HomeLink® Universal Transceiver for about 20 seconds, until
HomeLink®'s indicator light begins to flash.
3. Release both buttons.
The HomeLink® buttons can be reprogrammed using the procedures described on the previous page.
(HomeLink® information continues on the next page)
pg. 164 HomeLink® Universal Transceiver (option)
Reprogramming a single HomeLink® button
1. Press and hold the desired HomeLink® button. Do not release the button until step 3 has been completed.
2. When the indicator light begins to flash slowly (after approximately 20 seconds), position your hand -held
transmitter 2 to 5 in. (5 to 12 cm) away from the HomeLink® surface.
3. Press and hold the hand -held transmitter button. The HomeLink® indicator light will flash first slowly, then rapidly.
When the indicator light flashes rapidly, release both buttons.
The previously programmed device has now been erased and the new device can be activated by pressing the
HomeLink® button that has just been programmed. This procedure will not affect any other programmed HomeLink®
buttons.
NOTE:
Retain the original transmitter(s) for future programming procedures (e.g., if you purchase a new car).
For your own security, erase all programmed buttons on the HomeLink® Universal Transceiver when you sell your
car.
Metallic sun protection films should not be used on any windows in a car equipped with HomeLink® Universal
Transceiver. This could interfere with the transceiver's function.
Contents | Top of Page
ProCarManuals.com
Automatic Locking Retractor (ALR)14
Automatic transmission85, 86, 140
Geartronic87, 88
Kickdown86, 87
Auxiliary socket29, 37
B
Backrest (center) - 3-section rear seat60
Battery99, 143
Battery maintenance134, 135
Replacing the battery135
Ventilation hose135
Booster cushion12, 16
Bottle holder in rear seat58
Brake failure warning light26
Brake fluid133
Brake system18
Bulbs (list)143
Bulbs - replacing116-121
C
Capacities (oils and fluids)137
, 141
Cargo compartment cover67
Cargo compartment lighting63
Cargo eyelets64
Cargo net65
Catalytic converters - three-way101
Center armrest - 3-section rear seat61
Center backrest (3-section rear seat)60
Center console - switches29
Center head restraint - 3-section rear seat60
Center head restraint - rear seat3
Center seat head restraint59
Central locking buttons75
Chains - winter driving106
Changing wheels109, 110
Child booster cushion12, 16
Child Restraint Anchorages15
Child safety11, 12, 14, 16
Child safety locks - rear doors78
Climate controls44, 45, 46, 47
Climate system - general information43
Clock25
Clutch interlock84
Coat hanger57
Coin compartment55
ProCarManuals.com
