2002 PEUGEOT 807 wheel bolts
[x] Cancel search: wheel boltsPage 147 of 181
18-11-2002
YOUR 807 IN DETAIL
136
For the front, side and curtain air bags to be fully effec tive, observe the following safety rules:
• W ear a correctly adjusted seat belt.
• Sit in a normal upright position.
• Do not leave anything between the occupants of the front seats and the air bags (a child, pet, object).
This could hamper the operation of the air bags or injure th e occupants.
• All work on the air bag system is strictly forbidden unless it is ca rried out by qualified personnel of the PEUGEOT net
work.
• After an accident or if the vehicle has been stolen or broken into, have the air bag systems checked.
• The air bag systems have been designed to be fully operation al for 10 years after the vehicle has been registered.
For greater safety, have them checked by a PEUGEOT dealer within 10 years of purchase of the vehicle.
Front air bags
• Do not drive holding the steering wheel by its spokes or resti ng your hands on the centre part of the wheel.
• Passengers must not place their feet on the fascia.
• Smoke as little as possible; deployment of the air bags can cau se burns or the risk of injury from a cigarette or pipe.
• Never remove or pierce the steering wheel or hit it violently.
Side air bags
• Only put approved covers on the front seats. Contact your PEUGEOT dealer.
• Do not fix or glue anything to the front seat backs. This co uld cause injury to the chest or arms when the side air bag
inflates.
• Do not sit with the upper part of the body any nearer to the door than necessary.
Curtain air bags
• Do not fix or glue anything to the pillars or the roof. T his could cause injury to the head when the curtain air bag
inflates.
• Do not remove the bolts from the grab handles installed on the roof, they play a part in securing the curtain air bags.
Page 149 of 181
18-11-2002
YOUR 807 IN DETAIL
136
For the front, side and curtain air bags to be fully effec tive, observe the following safety rules:
• W ear a correctly adjusted seat belt.
• Sit in a normal upright position.
• Do not leave anything between the occupants of the front seats and the air bags (a child, pet, object).
This could hamper the operation of the air bags or injure th e occupants.
• All work on the air bag system is strictly forbidden unless it is ca rried out by qualified personnel of the PEUGEOT net
work.
• After an accident or if the vehicle has been stolen or broken into, have the air bag systems checked.
• The air bag systems have been designed to be fully operation al for 10 years after the vehicle has been registered.
For greater safety, have them checked by a PEUGEOT dealer within 10 years of purchase of the vehicle.
Front air bags
• Do not drive holding the steering wheel by its spokes or resti ng your hands on the centre part of the wheel.
• Passengers must not place their feet on the fascia.
• Smoke as little as possible; deployment of the air bags can cau se burns or the risk of injury from a cigarette or pipe.
• Never remove or pierce the steering wheel or hit it violently.
Side air bags
• Only put approved covers on the front seats. Contact your PEUGEOT dealer.
• Do not fix or glue anything to the front seat backs. This co uld cause injury to the chest or arms when the side air bag
inflates.
• Do not sit with the upper part of the body any nearer to the door than necessary.
Curtain air bags
• Do not fix or glue anything to the pillars or the roof. T his could cause injury to the head when the curtain air bag
inflates.
• Do not remove the bolts from the grab handles installed on the roof, they play a part in securing the curtain air bags.
Page 155 of 181
PRACTICAL INFORMATION
142
CHANGING A WHEEL
Parking the vehicle
If possible, park the vehicle on
level, stable and non slippery
ground.
Apply the handbrake, switch off
the ignition and engage first or
reverse gear (position Pfor the
automatic gearbox) .
Access to the spare wheel Open the tailgate.
Pull and turn the towing eye to
unlock the lifting tool and access
the bolt.
Unscrew the bolt fully, using the
wheelbrace 1to unwind the lifting
tool cable.
Detach the spare wheel through
the rear of the vehicle.
Take out the hinged hook via the
wheel shaft to release it. Tools
The following tools are located in the
engine compartment
1
Wheelbrace.
2 Jack
3 Removable towing eye.
4 Alloy wheel embellisher remover
Removing the wheel Place a chock 3if possible under
the wheel diagonally opposite to
the one to be changed.
Remove the trim, using the wheel
brace 1, pulling at the valve pas
sage hole.
Loosen the wheel bolts (for vehi
cles fitted with alloy wheels,
remove the wheel embellisher 4).
Remove the cover from the jack
suport holder.
Detach the jack fixing strap and
take it out from the bottom of the
jack support holder.
Place the jack 2in contact with
one of the four locating points A
on the sub frame (the one which
is closest to the wheel to be
changed).
Extend the jack 2until its base is
in contact with the ground. Ensure
that the centre line of the base of
the jack is straight above the
locating point A.
Raise the vehicle.
Unscrew the bolts and remove the
wheel.
18-11-2002
Page 156 of 181
PRACTICAL INFORMATION143
Anti theft bolts*
If your wheels are fitted with an anti
theft bolt (one per wheel), unscrew
the bolt using one of the anti theft
sockets which were given to you on
delivery of your vehicle along with
the duplicate keys and confidential
card and the wheelbrace
1.
Note: make a careful note of the
code number on the head of the anti
theft socket. This willl enable you to
obtain a duplicate anti theft socket.
* According to specification and country. Fitting a wheel
Position the wheel using the cen
tralising tool, fitted on the hub.
Tighten the bolts by hand.
Partly tighten the bolts using the
wheelbrace 1.
Fold the jack 2completely and
remove it.
Fully tighten the bolts using the
wheelbrace 1.
Replace the wheel trim, starting
by placing the wheel trim notch
opposite the valve, and press it on
using the palm of the hand.
Refit the wheel, with the valve
towards the top, under the vehicle
with the lifting tool, in line with the
illustration.
Tighten fully and check that the
wheel is lying flat against the rear
floor. For your safety, always
change the wheel:
– on level, stable, non slippery ground,
– with the handbrake on and the ignition switched off,
– with first or reverse gear engaged (position Pfor the
automatic gearbox),
– with the vehicle chocked.
Never go underneath a vehicle
that is supported only by a jack
(use a ramp).
After changing the wheel:
– have the tightening of the bolts and the tyre pressure checked
by a PEUGEOT dealer as soon
as possible.
– have the punctured wheel repaired and refit it to the vehi
cle as soon as possible.
– ask a Peugeot dealer to check that the spare wheel is fitted cor
rectly.
Fold down the ring to lock the lift
ing tool.
Put the tools in the engine com
partment.
18-11-2002