2002 PEUGEOT 807 maintenance

PEUGEOT SERVICING
20
THE SERVICE LEVELS
Each vehicle has its own servicing cycle, defined by th e manufacturer in terms of its engine type.
This cycle consists of alternating 2 types of service, A and C, int ermediate visits and a few additional operations specific to
your vehicle; these correspond to key stages in the life of your 8 07.
At the first and each subsequent service, your dealer wi ll advise you of the type and content of the next service d ue.
Intermediate topup visit
included in the fixed inter
val services.
MAINTENANCE CYCLE FOR YOUR PETROL ENGINE 807
2 litre and 2.2 litre petrol engines: service every 2 y ears or 20 000 miles (30 000 km) maximum
1st service at
6,000 miles (10 000 km) or 6 months*.
This is necessary in order to benefit from the warranty.
MILES (KM) 20,000 (30 000) 40,000 (60 000) 60,000 (90 000) 80,0 00 (120 000) 100,000 (150 000) 120,000 (180 000)
* Whichever comes first.
These services at fixed times are carried out with a minimum of synth
etically based oil but
may also be carried out with synthetic based oilor fuel economy oil (except 2.2 litre petrol
engine)
Arduous conditions of use (see corresponding section)
18-11-2002

PEUGEOT SERVICING21
Intermediate topup visit
included in the fixed inter
val services.
MAINTENANCE CYCLE FOR YOUR 807 TURBO DIESEL HDI
2 litre HDI and 2.2 litre HDI turbo diesel engines: ser vice every 2 years or 12,000 miles (20 000km) maximum
1st service at 6,000
miles (10 000 km) or 6 months*.
This is necessary in order to benefit
from the warranty.
MILES (KM) 12,000 (20 000) 24,000 (40 000) 36,000 (60 000) 48,000 (80 000)
60,000 (100 000) 72,000 (120 000) 84,000 (140 000) 96,000 (160 000) 108,000 (180 000)
+ maintenance of the
particulate emission filter
+ maintenance of the
particulate emission filter
These fixed interval services are carried out with synthetically based oil. Fuel Economy oil or synthetic oil may also be
used.
Warning: use only 5W 40 oil for the 2.2 litre HDI engine.
Intermediate topup visit included in the fixed interval se rvices.
* Whichever comes first.
18-11-2002

PEUGEOT SERVICING23
Zero reset Y our PEUGEOT dealer carries out
this operation after each service.
However, if you carry out the service
yourself, the reset procedure is as
follows:
 Switch off the ignition,
 Press and hold the trip recorder
reset button,
 Switch on the ignition.
The display begins a countdown.
When the display shows "=0", relea
se the button; the service symbol
disappears.
Important: after this operation, if
you wish to disconnect the battery,
lock the vehicle and wait for at least
five minutes, otherwise the zero re
set will not be registered.
MAINTENANCE OF PARTS SUBJECT TO WEAR AND A CHECK OF
CONSUMABLES
Certain essential components on your vehicle are subject to checks a t specific
frequencies.
• The brake fluid is to be replaced at a maximum of every 36,000/40,000 miles
(60 000km) or every two years;
• The pollen filter must be checked at each serviceby a PEUGEOT dealer
(services and intermediate visits) or more often, depending on the environ
ment (dust, pollution, etc.);
• For HDI turbo diesel engines with particulate emission filter , maintenance
of the filterand topping up of the additive reservoirmust be carried out at a
maximum of every 48,000 miles (80 000 km) by a PEUGEOT dealer;
• Replacement of the timing belt: contact a PEUGEOT dealer.
• Air bags and pretensioning parts on seat belts must be checked every
10 years.
• Tyre pressure sensors are to be replaced every 10 years.
• The check on tyre inflation presure must be carried out cold at least once a
month.
Note: the engine coolant does not have to be replaced.
18-11-2002

18-11-2002
PEUGEOT SERVICING25
Recommendations for
approved lubricants
The oils which appear in the table
opposite are suitable for most pur
poses.
The diagram opposite states the
optimum range of viscosity depen
ding on the temperatures at which
the oils are to be used.
It is also possible to use synthetic
oils of 'superior quality'.
In the absence of semisynthetic or
synthetic oils, oils of API SH/SJ qua
lity (for petrol engines) or CD/CF
quality (for diesel engines) can be
used by following the 'Arduous
conditions' servicing schedule, which
specifies shorter service intervals.
Do not hesitate to ask for advice
from a PEUGEOT dealer to maintain
driving pleasure and to minimise the
maintenance cost of your vehicle.
For countries outside Europe, please
contact a local PEUGEOT dealer.
Manual
ONLY ONLY
gearbox ESSO GEAR OIL BV TOTAL TRANSMISSION BV
75W 80 Part no. 9736.41 75W 80
Automatic ONLY
gearbox ATF 4HP20AL4 Part no. 9736.22
Power steering ESSO ATF D TOTAL FLUIDE AT42 Part no. 9730.94
Other approved products
Power steering FLUIDE LDS*
Brake circuit PEUGEOT DOT 4
Cooling circuit PROCOR TM108/GLYSANTIN G33 or REVKOGEL 2000 ONLYProtection to –35°C
*Only in very cold climates.

YOUR 807 IN DETAIL115
Maintenance position of front
windscreen wiper
This position allows the front wind
screen wiper blades to be removed.
In the minute following switching off
of the ignition, any action on the
stalk positions the wipers against the
windscreen uprights (for Winter
parking, cleaning of the windscreen
or replacing the blades).
To park the wipers after this has
been done, switch on the ignition
and operate the stalk.
Rear windscreen wiper
Turn ring
Ato the first notch.
The wiping speed is
inversely proportional to the
speed of the vehicle.
Automatic rear windscreen wiping
 place the front wipers stalk in a
position other than 0.
 engage reverse gear.
 the rear wiper operates with inter
mittent wiping.
Note: this function cannot be dis
armed if a bicycle carrier is fitted.
Therefore, you must fit a special bicy
cle carrier, approved by PEUGEOT,
or contact a PEUGEOT dealer.
Rear windscreen wash
Turn ring Apast the first
notch: the windscreen wash
then the windscreen wiper
operate for a specified time.
Do not cover the rain
sensor located at the bot
tom centre of the wind
screen.
When using an automatic car
wash, switch off the ignition or
check that the wiper control is not
in the automatic position.
In winter it is advisable to wait for
the windscreen to completely
clear of ice before operating the
automatic wipe. In winter, in the presence
of a considerable
amount of snow or ice,
switch on the rear screen
demister. Once deicing
is complete, remove the snow or
ice which has accumulated on the
rear wiper blade. You can now
operate the rear windscreen
wiper.
Automatic timed windscreen
wipers
The automatically timed wiping is
controlled by a rain sensor fitted on
the windscreen.
In the
AUTO position, the wind
screen wipers operate automatically
and adapt their speed to the inten
sity of the rainfall.
Operating check
Activation
When the function is activated, the
message "Automatic windscreen
wipers activated" appears on the
multi–function display.
18-11-2002

YOUR 807 IN DETAIL
132


: snow programme
P ark: to immobilise the vehicle or start the engine ,
with the handbrake on or off.
R everse: to reverse(select this function with the
vehicle stationary, engine at idle).
N eutral: to start the engine and to park, with the
handbrake on.
Note: if function Nis engaged inadvertently while
driving, allow the engine to return to idle before
engaging function Dto accelerate.
D rive: for drivingin automatic mode.
M anual: for drivingin manual mode.
Moving off
With the engine running, to move off
from position P:
 it is essential to press the
brake pedal to exit position P,
 select function R, D or M, then
gradually release the pressure
on the brake pedal; the vehicle
moves off immediately.
You can also move off from position N:
 release the handbrake, with your
foot on the brake
 select function R, D or M, then
gradually release the pressure
on the brake pedal; the vehicle
moves off immediately.
WARNING
When the engine is at idle, brakes not
applied, if function R, D or M is
selected the vehicle moves even with
out the accelerator being pressed.
For this reason, do not leave
children unsupervised inside the
vehicle, with the engine running .
When maintenance operations need
to be carried out with the engine
running, apply the handbrake and
select position P.
"PORSCHE TIPTRONIC SYSTEM" AUTOMATIC GEARBOX
The four speed
automatic gearbox offers a choice between the comfort of inte
gral automatic operation , enhanced by a snow programme, or the pleasure of
manual gear changing .
Gear selection gate  Move the lever in the gate to select a function.
Once the function is selected, the corresponding indicator lig ht appears on
the instrument panel display.
If the battery is flat and the lever is in position P, it will be impossible
to change to another position.
18-11-2002

PRACTICAL INFORMATION
152
CHANGING A WINDSCREEN
WIPER BLADE
Placing the wiper blades in the
maintenance position Less than a minute after switching
off the ignition, operate the wipers
stalk to position the wiper blades
along the windscreen uprights
(maintenance position).
Changing a front wiper blade  Lift the wiper arm, then disconnect
the windscreenwash pipe.
 Unclip the blade and remove it.
 Fit the new blade.
 Reconnect the windscreenwash
pipe and push back the wiper arm.
To return the windscreen wipers
to their normal position, switch on
the ignition and operate the
wipers stalk.
Changing the rear wiper blade  Lift the wiper arm, then unclip the
blade and remove it.
 Fit the new blade and push back
the wiper arm. ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (windscreen wiper, electric
windows, sunroof, courtesy lights,
audio equipment etc.) can only be
used for thirty minutes, to prevent
discharging the battery.
After thirty minutes, the message
"Economy mode active"
appears
on the multifunction display and the
active functions are put on standby.
To resume use of these functions,
start the engine and let it run for a
few seconds.
Aflat battery will pre
vent the engine from
starting.
18-11-2002

18-11-2002
PRACTICAL INFORMATION159
ACCESSORIES FOR YOUR 807
For your PEUGEOT only use accessories and original parts approved by the manufacturer.
These accessories and parts are all adapted to your PEUGEOT, after being tested and approved for reliability and
safety, which PEUGEOT cannot guarantee for other products.
Awide choice of original accessories, approved by PEUGEOT, is availab le through the dealer network. They all carry the
PEUGEOT guarantee.
– Safety : Antitheft alarms, window engraving, wheel locks, first aid kit ...
– Comfort : Arm rest, covers compatible with side air bags, mats, boot tray, sun roof, luggage net, door
deflectors, cool box secured on the slides...
– Communication : Audio systems, telephone, handsfree kit, speakers, amplifier, CD changer, navigation
systems, rear video kit, DVD player....
– Customising : Alloy wheels, trims, aluminium or PVC door sills, aluminium interio r trim kit, mud flaps...
– Leisure : Tow bar, roof bars, roof box, snow chains, ski carrier, tailgat e bicycle carrier, interior bicycle
carrier...
– Children : Booster seats and child seats, side sun blinds and rear blind.. .
– Maintenance products : Screenwash, interior and exterior maintenance and cleaning prod ucts...
Before installing any electrical accessory on your vehicle, contact a PEUGEOT dealer.