2002 PEUGEOT 807 change time

YOUR 807 IN DETAIL91
Memorising using the buttons M,
1 and 2
T
o memorise using the buttons located
on the side of the seat: Place the ignition key in the 'running'
position (2 nd
notch),
 Adjust your seat and mirrors,
 Press button M,then button 1
(first driving position) or button 2
(second driving position) within
four seconds.
An audible signal confirms that a
position has been memorised.
Memorising a new position cancels
the previous one.
Recalling a memorised position
Engine off Briefly press button 1 or 2to recall
the corresponding memorised
position.
Note: after recalling a memorised
position five times in succession, the
function will be cancelled until the
engine is started.
Engine running Keep button 1 or 2pressed down
until the end of setting of the cor
responding memorised position.
Memorising seat and mirror
positions
Four driving positions can be memo
rised:
– two, using
two remote control
keys (two users),
– two, using buttons M/1 and M/2.
Driving positions memorised by
the remote control key
When locking the doors, the remote
control key memorises the position
of the driver's seat and the exterior
mirrors.
When unlocking the doors, the dri
ver's seat and the exterior mirrors
resume the position memorised by
the remote control key if this has
changed in the meantime.
Each remote control key can
memorise a specific setting. Front heated seat controls
The front seats can be heated sepa
rately.
Use the adjustment controls located
on the side of each seat to select the
level of heating required :
0:
Off.
1: Low.
2: Medium.
3: High.
The seat temperature is controlled
automatically.
Note: the heated seats only operate
with the engine running.
18-11-2002

YOUR 807 IN DETAIL91
Memorising using the buttons M,
1 and 2
T
o memorise using the buttons located
on the side of the seat: Place the ignition key in the 'running'
position (2 nd
notch),
 Adjust your seat and mirrors,
 Press button M,then button 1
(first driving position) or button 2
(second driving position) within
four seconds.
An audible signal confirms that a
position has been memorised.
Memorising a new position cancels
the previous one.
Recalling a memorised position
Engine off Briefly press button 1 or 2to recall
the corresponding memorised
position.
Note: after recalling a memorised
position five times in succession, the
function will be cancelled until the
engine is started.
Engine running Keep button 1 or 2pressed down
until the end of setting of the cor
responding memorised position.
Memorising seat and mirror
positions
Four driving positions can be memo
rised:
– two, using
two remote control
keys (two users),
– two, using buttons M/1 and M/2.
Driving positions memorised by
the remote control key
When locking the doors, the remote
control key memorises the position
of the driver's seat and the exterior
mirrors.
When unlocking the doors, the dri
ver's seat and the exterior mirrors
resume the position memorised by
the remote control key if this has
changed in the meantime.
Each remote control key can
memorise a specific setting. Front heated seat controls
The front seats can be heated sepa
rately.
Use the adjustment controls located
on the side of each seat to select the
level of heating required :
0:
Off.
1: Low.
2: Medium.
3: High.
The seat temperature is controlled
automatically.
Note: the heated seats only operate
with the engine running.
18-11-2002

THE ALARM
This provides two types of protection:
– exterior protection: it sounds if adoor, the tailgate, the bonnet or a
sunroof is opened.
– interior protection: it sounds if the volume inside the passenger com
partment changes (breaking of a
window or a movement inside the
vehicle).
Setting the alarm  Switch off the ignition and get out
of the vehicle.
 Set the alarm within five minutes
of getting out of the vehicle, by
locking or deadlocking using the
remote control (the red indicator
light, located in the centre of the
fascia and visible from the out
side, flashes once per second). Note:
if you wish to lock your vehicle
without setting the alarm, use the
door lock.
When the alarm is triggered, the
siren sounds and the direction indi
cator lights flash for thirty seconds.
After triggering, the alarm remains
set.
Warning: if the alarm has been trig
gered ten times in succession, on
the eleventh time it becomes inac
tive.
Note: if the red warning light, located
in the centre of the fascia, flashes
rapidly, the alarm has been triggered
while you were away from your vehi
cle. To stop it flashing, insert the
remote control key and switch on the
ignition.
Disarming
Unlock the vehicle with the remote
control key (the red indicator light,
located in the centre of the fascia,
goes out).
To set the alarm with exterior
protection only
If, while you are away from the vehi
cle, you wish to leave a window
partially open or a pet inside the
vehicle, you should choose exterior
protection only.
 Close the sunroofs, 
Switch off the ignition,
 In the next ten seconds, press
button A, located on the lefthand
side of the fascia, until the red
indicator light is on continuously,
 Get out of the vehicle,
 Within the next five minutes, set
the alarm by locking or deadlock
ing using the remote control (the
red indicator light, located in the
centre of the fascia, flashes once
a second).
Note: when the alarm is set but the
remote control does not operate:
 Unlock the doors with the key and
open the door. The alarm is
triggered.
 Switch on the ignition in the next
ten seconds. The alarm is dis
armed.
Incorrect operation
When the ignition is switched on, if
the red indicator light, located in the
centre of the fascia, comes on for ten
seconds, there is a fault in the siren
connection.
Contact a PEUGEOT dealer to have
the system checked.
Do not make any modifi
cations to the alarm sys
tem as this could cause
faults.
YOUR 807 IN DETAIL
106
18-11-2002

YOUR 807 IN DETAIL131
REAR PARKING ASSISTANCE
This system consists of four proximity
sensors, located in the rear bumper,
and a special speaker fitted in the
fascia.
This detects any obstacle (person,
vehicle, tree, gate, pavement etc.)
behind the vehicle.
Note: this function will be disarmed
automatically when the vehicle is
towing a trailer or when a bicycle
carrier is fitted (vehicle fitted with
towing attachment or bicycle carrier
recommended by PEUGEOT).
In wintry weather, ensure that the
sensors are not covered with frost or
snow.
Deactivation  Change to neutral, the system is
again inactive.
Activation
The system is activated as soon as
reverse gear is engaged; an audible
bleep shows that it is active.
The proximity information is given by
an audible signal, which becomes
more rapid as the vehicle approach
es the obstacle.
When the distance between the rear
of the vehicle and the obstacle is
less than approximately twentyfive
centimetres, the audible signal
becomes continuous.
Detection zone
If there is an operating
fault, the audible signal will
be a short bleep followed
by a long bleep when
changing to reverse gear.
18-11-2002

YOUR 807 IN DETAIL133
Automatic operation
Automatic changing of the four
gears:  select function D in the gate.
The gearbox always selects the
most suitable gear according to the
following parameters:
the style of driving,
the road profile,
the vehicle load.
The gearbox is then operating in
autoadaptive mode, without any
action on your part.
WARNING
Never select function N when the
vehicle is moving.
Never select functions Por Runless
the vehicle is stationary.
Never change between functions to
optimise braking on a slippery surface.
Notes
For immediate maximum accelera
tion without touching the gear lever,
press the accelerator pedal down as
far as it will go (kickdown). The gear
box will automatically change down
or maintain the gear selected until
maximum engine speed is reached.
When braking, the gearbox will auto
matically change down in order to
provide efficient engine braking. If you take your foot off the accelera
tor suddenly, the gearbox will not
change to a higher gear for reasons
of safety.
Snow programme
In addition to the autoadaptive pro
gramme, there is a special pro
gramme.
The programme is displayed on the
instrument panel screen.
The Snow programme improves
starting and drive when traction is
poor. 
Press button

once the vehicle
has been started and function D
selected.
The gearbox adapts to driving on
slippery roads.
Note: you can return to the auto
adaptive programme at any time.  Press button

again to switch
off the programme you are in.
Manual operation
Manual changing of the four gears:
 select function M in the gate,
 push the lever to the + sign to
change to a higher gear, 
pull the lever to the – sign to
change to a lower gear.
You can change from position D (dri
ving in automatic mode) to position
M (driving in manual mode) at any
time.
Note
It is only possible to change from one
gear to another if the vehicle speed
and engine speed permit. If they do
not, the vehicle will operate tem
porarily in automatic mode.
When the vehicle is stationary or
moving very slowly, the gearbox
automatically selects gear M1.
The

(snow) programme does not
operate in manual mode.
Operating abnormality
Any operating abnormality is indicated
by an audible signal, accompanied by
the message "Automatic gearbox
faulty" on the multifunction display
and flashing of the Snow warning
light on the instrument panel.
In this situation the gearbox operates
in downgrade mode (locked in 3rd
gear). You may feel a substantial
knock when changing from Pto R
and from N to R (this will not cause
any damage to the gearbox).
Do not exceed 60 mph (100 km/h),
keeping within the limit of local
speed restrictions.
Contact a PEUGEOT dealer as soon
as possible.
18-11-2002

REAR VIDEO KIT
This video assembly will enable the
rear passengers to pass the time
pleasantly while watching their
favourite film or playing their
favourite game, by means, in partic
ular, of the connection of a DVD
player or games console.
The rear video kit consists of: a 4/3, 6.8 inch, LCD colour
monitor ,
two high frequency, wireless, stereo headphones,
a remote control,
a base with two wired headphone outputs, a courtesy light with its
switch and a monitor release but
ton,
three audio/video sockets in the
glove compartment . The monitor's remote control incor
porates the following controls:
1.
"POWER" button to switch the
monitor on/off.
2. "SOURCE" button for selection
of the input source, AV1 or AV2.
3. "SETUP" button for selection of
the settings.
4. "VOL " and "VOL " buttons to
change the settings or
increase/decrease the volume at
the wired headphones.
5. Housing for the two LR03 batteries.
6. "MUTE" button to cut off/restore
the volume at the wired head
phones.
7. "DOMELIGHT" button to switch
the courtesy light on/off remotely.
PRACTICAL INFORMATION 157
The monitor has left/right and
up/down position adjustment. It can
also be stored in its base by folding it
and pushing it to lock it. Once stored,
the supply, and that of the wireless
headphones, is cut off automatically
after approximately fifteen minutes.
The rear video kit accepts all types of
audio/video source, PAL/NTSC com
patible, such as: DVD player, cam
corder, games console, ...
These sources are connected to the
three audio/video sockets, AV 1, in
the glove compartment only as the
AV2 sockets are not available.
18-11-2002