2002 Peugeot 607 Dag warning
[x] Cancel search: warningPage 42 of 167
Changing the colours
Select the desired colour, then confirm.
If required, select 'automatic
day/night' , then confirm and record
the changes.
Note: this function allows the system
to change automatically to 'Night'
colour when the vehicle lights are on.
Changing the brightness
Select the 'Brightness' function,
then confirm:
– turn the dial clockwise to increase,
– turn the dial anti clockwise to decrease.
Record the modifications.
Note: this function allows only limit
ed adjustment of the brightness,
since the screen lighting is depen
dent on the sunshine/brightness sen
sor in the vehicle.
YOUR 607 IN DETAIL 45
Insert the software CD Rom into the
drive in place of the map CD Rom.
After a few moments, the mesage
"Warning Reprogramming Sequence"
then the message "Navigation applica
tion Processing" apears, together with
a progress bar.
When the message "Software Loading
End Eject CD" appears, eject the
software CD Rom and insert the map
CD Rom into the drive.
Check that the CD Rom has loaded
correctly (see paragraph "Voice syn
thesis adjustment" in the chapter enti
tled "The satellite navigation system
with colour screen").
Page 91 of 167
YOUR 607 IN DETAIL93
THE SEATS
Manual front seats
1 Forwards backwards adjustment
Lift the lever and slide the seat forwards or backwards.
2 Seat cushion angle adjustment *
Raise the catch while pressing on or easing off the
seat back to obtain the required height.
3 Driver's seat height adjustment* Raise the catch to obtain the required height.
4 Seat back angle adjustment Raise the catch to obtain the required angle.
5 Lumbar adjustment *
Raise or lower the lever to obtain the correct position.
6 Head restraint height adjustment The head restraint has a frame with notches which
prevent the head restraint dropping down (safety
device in the event of an impact).
To raise the head restraint, push it upwards.
The setting is correct when the upper edge of the
head restraint is level with the top of the head.
To lower the head restraint, it is necessary to push
simultaneously :
–
the button located on the base of the head restraint frame ,
– the head restraint downwards.
The head restraint angle is also adjustable.
To remove the head restraint, lift it out by pressing the lug.
Warning : never drive with the head restraints removed; they
should be in place and correctly adjusted.
* Driver's seat only.
Page 100 of 167
YOUR 607 IN DETAIL
100
SEAT BELTS
Front seat belt height adjustment:
To lower the attachment point,
squeeze control 1and slide it
downwards.
To raise the attachment point,
squeeze control 1and slide it
upwards.
To lock the seat belts Pull the strap, then insert the end
into the buckle. Front seat belts with
pre tensioner and force limiter
Safety in the event of a frontal impact
has been improved by the introduc
tion of seat belts with pre tensioner
and force limiter connected to the
front air bags. Depending on the
seriousness of the impact, the pre
tensioning system instantly tightens
the seat belts firmly against the bod
ies of the occupants.
The pre tensioning seat belts are
armed when the ignition is on.
The force limiter reduces the pres
sure of the seat belt on the body of
the occupant in the event of an acci
dent.
Rear seat belts with force limiter
The rear seats are all fitted with a
three point inertia reel seat belt.
Third rear central seat belt
– pull the belt located between the
two head restraints at the left rear,
– insert the fixed buckle in the black clasp located on the left,
– insert the sliding buckle in the red and black (movable) clasp. To
release it, press the black button of
the locking clasp.
To be effective, a seat
belt must be tightened as
close to the body as pos
sible.
Depending on the nature and seri
ousness of the impact, the pre
tensioners may be triggered
before and independently of the
air bags.
In all cases, the air bag warning
light comes on.
After an impact, have the system
checked by a PEUGEOT dealer.
The system has been designed to
be fully oper ational for ten years.
Have it replaced after this period.
Page 102 of 167
Electronic engine immobiliser
This locks the engine control system
a few moments after the ignition has
been switched off and therefore pre
vents starting of the vehicle by any
one who does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code
is recognised and starting is possi
ble.
If the system does not function
correctly, the central locking button
indicator light, situated on the centre
console, flashes rapidly when the
ignition is switched on (2nd notch).
WARNING: your vehicle is no longer
protected in this event.
Contact a PEUGEOT dealer as soon
as possible. Flat battery
(CR 2025/3 volt battery)
This is indicated by illumination of a
warning light on the instrument panel
display, accompanied by an audible
signal and a message on the multi
function display.
Contact a PEUGEOT dealer to
replace the battery.
YOUR 607 IN DETAIL
102
Key in ignition
A buzzer sounds on opening the dri
ver's door, if the key has been left in
the ignition. Locating your car
To locate your car in a car park:
press button A; the courtesy lights
come on and the direction indica
tors flash for a few seconds.
Programming the
remote control
in the key Switch off the ignition.
Switch the ignition on again.
Immediately press button A.
Switch off the ignition and remove
the remote control key from the
ignition lock. The remote control
key is now working again.
Confidential card
The confidential card contains the
identification code necessary for any
work carried out by a PEUGEOT
dealer on the system. This code is
hidden by a film which should be
removed only if necessary.
Keep your card in a safe place,
never inside the vehicle.
Page 104 of 167
Electronic engine immobiliser
This locks the engine control system
a few moments after the ignition has
been switched off and therefore pre
vents starting of the vehicle by any
one who does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code
is recognised and starting is possi
ble.
If the system does not function
correctly, the central locking button
indicator light, situated on the centre
console, flashes rapidly when the
ignition is switched on (2nd notch).
WARNING: your vehicle is no longer
protected in this event.
Contact a PEUGEOT dealer as soon
as possible. Flat battery
(CR 2025/3 volt battery)
This is indicated by illumination of a
warning light on the instrument panel
display, accompanied by an audible
signal and a message on the multi
function display.
Contact a PEUGEOT dealer to
replace the battery.
YOUR 607 IN DETAIL
102
Key in ignition
A buzzer sounds on opening the dri
ver's door, if the key has been left in
the ignition. Locating your car
To locate your car in a car park:
press button A; the courtesy lights
come on and the direction indica
tors flash for a few seconds.
Programming the
remote control
in the key Switch off the ignition.
Switch the ignition on again.
Immediately press button A.
Switch off the ignition and remove
the remote control key from the
ignition lock. The remote control
key is now working again.
Confidential card
The confidential card contains the
identification code necessary for any
work carried out by a PEUGEOT
dealer on the system. This code is
hidden by a film which should be
removed only if necessary.
Keep your card in a safe place,
never inside the vehicle.
Page 106 of 167
THE ALARM
This provides two types of protec
tion, exterior and interior:
– exterior protection: when this is set, the alarm sounds if a door, the
boot or the bonnet is opened.
– interior protection: when this is set, the alarm sounds if the sensors
detect a variation in the air move
ment inside the vehicle (breaking
of a window or a movement inside
the vehicle).
Setting the alarm
Switch off the ignition and get out
of the vehicle.
Set the alarm within five minutes
of getting out of the vehicle, by
locking or deadlocking using the
remote control (button Bindicator
light flashes once per second). Note:
if you wish to lock your vehicle
without setting the alarm, use the
door lock.
When the alarm is triggered, the
siren sounds and the direction indi
cators flash for thirty seconds.
It then stops, but the alarm remains
set.
Warning: if the alarm has been trig
gered ten times in succession, on
the eleventh time it becomes inac
tive.
Note: if button B flashes rapidly, the
alarm has been triggered while you
were away from your vehicle.
Automatic activation
The alarm is activated automatically
two minutes after the door or boot
were last closed.
In order to avoid accidental trigger
ing of the alarm when a door or the
boot is opened, it is essential to
press the remote control opening
button first.
Disarming
Unlock the vehicle with the remote
control key (button Bindicator light
goes out).
Note: if the alarm has been triggered
while you were away from your car,
the rapid flashing of the indicator
light will stop when you switch on the
ignition. To set the alarm with exterior
protection only
If, while you are away from the vehi
cle, you wish to leave a window par
tially open or a pet inside the vehicle,
you should choose exterior protec
tion only.
Switch off the ignition
In the next ten seconds, press
button
Auntil indicator light B is
on continuously.
Get out of the vehicle.
Set the alarm by locking or dead
locking using the remote control
switch ( button Bindicator light
flashes once a second).
Note: when the alarm is set but the
remote control does not operate:
Unlock the doors with the key and
open the door. The alarm is trig
gered.
Switch on the ignition in the next
ten seconds. The alarm is disar
med.
Incorrect operation
When the ignition is switched on, if
button Blights for ten seconds, there
is a fault in the siren connection.
Contact a PEUGEOT dealer to have
the system checked.
YOUR 607 IN DETAIL
104
Page 107 of 167
Child safety
This prevents either of the rear doors
being opened from inside. Turn the red plastic switch a quar
ter of a turn using the ignition key.
YOUR 607 IN DETAIL 105
DOORS
Opening the doors
from outside
Opening the doors
from insideLocking / unlocking from the
inside
– Using button
Aof the centre con
sole :
This allows the doors, the boot and
the fuel filler flap to be locked or
unlocked.
– Using button B on the door :
• on the front doors this allows the doors, the boot and the fuel filler
flap to be locked or unlocked.
• on the rear doors this allows the door concerned to be locked or
unlocked.
Note : button Bis neutralised if the
vehicle is deadlocked.
' Door open' alert
With the ignition on (2nd notch), with
the engine running or when the vehi
cle is moving, if a door is not proper
ly closed then the door open warning
light comes on, accompanied by an
audible signal and a diagram indicat
ing the relevant door on the
multi–function display, if a door is not
properlyclosed.
Page 108 of 167
Vehicle unlocked
Press and hold button Cof the
remote control key or press push
button A.
Note: push button Acan be deacti
vated. Rotate control B,located
inside the boot lid, a quarter of a turn
(anti clockwise) using the key.
YOUR 607 IN DETAIL
106
THE BOOT
Opening the boot
With the vehicle locked / deadlocked
Press and hold button Cof the
remote control key.
This action will also unlock the doors
and the fuel filler flap. SUNROOF
Control the sunroof:
– manually
: lightly press the switch;
the roof stops as soon as the
switch is released.
– automatically : press the switch
down; the roof opens partially or
opens or closes completely
depending on where the switch is
pressed.
– to partially open the roof: press
part Aof the switch. To close it,
press part Bof the switch.
– to open the roof completely: press part Bof the switch.
– to close it completely: press part
A of the switch .
– safety auto reverse When the sunroof is closing and
meets an obstacle, it stops then
opens again.
Note: the sunroof shutter is manual.
Closing the boot
Press the centre of the boot lid
with both hands, until it locks.
'Boot open' warning
With the ignition on (2nd notch), with
the engine running or when the vehi
cle is moving, the door open warning
light comes on, accompanied by an
audible signal and a diagram on the
multi function display, if the boot is
not properly closed.