2002 Peugeot 607 Dag boot

Rear sunblind
The blind, fitted to the rear parcel
shelf, is intended to protect occu
pants from the glare of the sun and
the lights of cars behind.
Sunblind operation:
With the engine running:  Briefly press button Don the cen
tre console to open it out.
 Briefly press button Dagain to
store it away.
Warning: Do not place anything on
the blind, to avoid it being damaged. Rear armrest
This provides access to the ski flap
from the passenger compartment.
It has two cup holders. Storage compartments
There are two storage compartments
located behind the side trim of the
boot.
The left side storage compartment is
fitted with a CD storage bracket for
eight single CDs and one double CD.
To access a storage compartment:
Push the handle downwards and
fold down the panel.
YOUR 607 IN DETAIL 121
Rear shelf compartment
This is provided for the storage of a
first aid kit.
The catch on the lid is designed to
withstand a weight of 9 lbs (4kg) on
impact.Luggage net
Six stowing rings allow the net to be
placed in different positions.

139
TYRE UNDERINFLATION
DETECTION
Sensors check the tyre pressure
during driving, and trigger a warning
in the event of malfunction (speed
greater than 15mph [25 km/h]).
Flat tyreWhen this warning light
comes on, accompanied by
an audible signal and the
message 'Tyre pressure
low' on the multifunction
display, have the tyre pressure
checked as soon as possible.
Puncture
This warning light, accom
panied by an audible signal
and the message 'Punc
tured tyre(s) detected' on
the multifunction display, is
followed by illumination of the
'STOP' warning light.
Stop immediately, avoiding any sud
den movement of the steering wheel
and the brakes.
Change the damaged (punctured or
very deflated) tyre, and have the tyre
presure checked as soon as possible.
Note: if the damaged tyre is tem
porarily stored in the boot, it will
again emit this message to remind
you of the necessity of having it
repaired. This will prevent another
warning of the same type being dis
played. Sensor(s) not detected
This warning light, accom
panied by an audible signal
and the message ' X tyre
pressure sensor(s) miss
ing ' on the multifunction
display, indicates that underinflation
detection is absent from one (or sev
eral) tyre(s).
Contact a PEUGEOT dealer to
replace the faulty sensor(s).
Note: this message is also displayed
when one of the tyres is away from
the vehicle (being repaired) or when
a wheel without a sensor is fitted.
LES INFORMATIONS PRATIQUES
All repairs and changing
of tyres on a wheel fitted
with this system must be
carried out by a
PEUGEOT dealer.
The tyre underinflation detec
tion system is an aid to driving
which does not replace the
need for the driver to be vigilant
or to drive responsibly.
This system does not remove the
necessity for having the tyre pres
sure (including that of the spare
wheel) checked regularly, to
ensure optimum dynamic perfor
mance of the vehicle and to pre
vent premature wear of the tyres,
particularly in the case of arduous
driving conditions (heavy load,
high speed).
The system may temporarily be
disturbed by radio broadcasts on
a frequency close to it.

PRACTICAL INFORMATION
140
CHANGING A WHEEL
Park the vehicle on level, stable
and nonslippery ground.
Apply the handbrake, engage first
or reverse gear (position
Pfor the
automatic gearbox) and switch off
the ignition.
Access to the spare wheel and the
jack in the boot
Detach the luggage net.
Lift the boot carpet using the lifting
hook. Secure this hook behind the
boot seal. Tools available
The following tools are located in the
polystyrene holder in the centre of
the spare wheel:
1
Wheelbrace.
2 Centralising tool.
3 Wheelbrace extension.
4 Jack fitted with a system which
enables it to be folded or unfold
ed rapidly.
5 Removable towing eye.
6 Alloy wheel trim remover.
7 Trim cover tool. Removal
For vehicles with alloy wheels fit
ted with wheel trims, pull the
centre trim by using tool
6in one
of the holes.
Loosen the wheel bolts.
Take the jack from the tool kit and
fold it by pressing the ends A.

PRACTICAL INFORMATION 141
Fold the jack by pressing at the
ends
Aand place it in one of the
four locations Eunderneath the
vehicle (the nearest one to the
wheel to be changed).
Extend the jack, first by hand, pul
ling the ends Athen using wheel
brace 1and the extension 3.
Remove a wheel bolt at the top
and fit the centralising tool 2in its
place.
Unscrew the other bolts and
remove the wheel.
Fitting a wheel
Position the wheel using the cen
tralising tool to assist you.
Tighten the bolts by hand and
remove the centralising tool.
Partly tighten the bolts using the
wheelbrace.
Fold the jack and remove it.
Fully tighten the bolts using the
wheelbrace.
Replace the wheel trim.
Put the tool holder back in posi
tion. This helps to keep the boot
floor in its correct position, to pre
vent any deformation of the floor
when loaded.
Tighten the spare wheel securing
strap to prevent noise and for your
safety in the event of impact. For your safety, always
change the wheel:
– on level, stable, nonslippery
ground,
– with the handbrake applied,
– with first or reverse gear engaged (position Pfor the
automatic gearbox),
Never go underneath a vehicle
which is supported only by a
jack (use a ramp).
After changing the wheel:
– have the tightening of the bolts and the tyre pressure checked
by a PEUGEOT dealer as soon
as possible.
– have the punctured wheel repaired and refit it to the vehi
cle as soon as possible.
Tyres fitted with the Tyre Under
Inflation Detection System.
These wheels have a pressure
sensor. Have them repaired by a
PEUGEOT dealer.

Rear lights
Rear wing lights
1 Direction indicators: PY 21 W (amber).
2 Brake lights/side lights: P21/5 W.
 Detach the luggage net.
 Lift the boot carpet with the lifting
hook. Secure this hook behind
the boot seal.
 Unclip the lower part of the sill
trim, then dislodge it by pulling
upwards.
 Remove the plastic retainer clip
securing the side trim to the
floor. 
Unclip the side trim.
 Remove the two butterfly nuts
securing the light.
 Remove the eyelet.
 Take out the lamp.
 Turn the lamp holder a quarter
turn.
 Change the faulty bulb.
 Lock the bulb holder in place.
When refitting it, ensure that the
lamp is correctly positioned and
secured.
PRACTICAL INFORMATION
144
Direction indicator repeaters:
WY 5 W (amber).
 Push the repeater forwards or
backwards and release the
assembly.
 Hold the connector and turn the
transparent cover a quarter turn.
 Change the bulb.
Amber coloured bulbs
(direction indicators and
side repeaters) must be
replaced with bulbs of
identical specification and
colour.

Rear lights
Rear wing lights
1 Direction indicators: PY 21 W (amber).
2 Brake lights/side lights: P21/5 W.
 Detach the luggage net.
 Lift the boot carpet with the lifting
hook. Secure this hook behind
the boot seal.
 Unclip the lower part of the sill
trim, then dislodge it by pulling
upwards.
 Remove the plastic retainer clip
securing the side trim to the
floor. 
Unclip the side trim.
 Remove the two butterfly nuts
securing the light.
 Remove the eyelet.
 Take out the lamp.
 Turn the lamp holder a quarter
turn.
 Change the faulty bulb.
 Lock the bulb holder in place.
When refitting it, ensure that the
lamp is correctly positioned and
secured.
PRACTICAL INFORMATION
144
Direction indicator repeaters:
WY 5 W (amber).
 Push the repeater forwards or
backwards and release the
assembly.
 Hold the connector and turn the
transparent cover a quarter turn.
 Change the bulb.
Amber coloured bulbs
(direction indicators and
side repeaters) must be
replaced with bulbs of
identical specification and
colour.

145
PRACTICAL INFORMATION
Boot lid lights
1 Reversing lights: P 21 W.
2 Fog lamps: P 21 W.
 Remove the three plastic retain
er clips securing the cover trim
(those nearest to the lamp).
 Move aside the trim. 
Turn the bulb holder a quarter
turn.
 Change the faulty bulb. Number plate lights:
W 5 W.
 Remove the transparent cover
using a screwdriver blade.
 Change the faulty bulb.

Vehicles fitted with
two batteries*
Certain vehicles, depending on the
country where the vehicle is sold, are
fitted with two batteries:
– a battery for starting, located in the engine compartment,
– a service battery, located in the boot.
The starter battery has a label show
ing that the service battery* is in the
boot.
These are special batteries.
If one of them is replaced, contact a
PEUGEOT dealer.
To charge the starter battery with
a battery charger:
remove the style cover to gain
access to the starter battery,
disconnect the battery.
Follow the instructions for use
given by the battery charger
manufacturer,
 reconnect the battery, starting with
the negative (–) terminal,
 check that the t erminals and the
connectors are clean. If they are
covered with sulphate (whitish or
greenish deposit), disconnect and
clean them,
 refit the style cover. To start the vehicle from another
battery: 
remove the style cover to gain
access to the starter battery,
 remove the maxi fuse located
near to the starter battery,
 connect the red cable to the posi
tive (+) terminals of the two batter
ies,
 connect one end of the green or
black cable to the negative () ter
minal of the additional battery,
 connect the other end of the green
or black cable to an earth point on
the vehicle which has broken
down, as far as possible from the
battery,
 start the engine and let it run,
 wait for the engine to return to idle
then disconnect the cables,
 drive a few kilometres in order to
recharge the starter battery, then
replace the maxi fuse near to it,
 refit the style cover.
To recharge the service battery,
contact a PEUGEOT dealer.
* According to country.
PRACTICAL INFORMATION
152
If electrical operations are
carried out, disconnect the starter battery and remove the maxi fuse located next to it.
It is advisable to disconnect the starter battery and remove the
maxi fuse located next to it, if the vehicle is not to be used for a
period of more than one month.