2002 Peugeot 607 Dag ESP

Flashing of the points in
the temperature setting
values indicates that
there is a malfunction of
the air conditioning. Contact your
Peugeot dealer.
11 Air intake/Recir
culation
 Press this button to
recirculate the inte
rior air.
Recirculation insulates
the passenger com
partment from outside smells and
smoke.
Avoid prolonged operation of inte
rior air recirculation (risk of con
densation and deterioration of air
quality).
 Press this button again to return
air intake to automatic control.
YOUR 607 IN DETAIL
92
12 Demisting the
rear screen
 Press this button,
with the engine
running, to demist
the rear screen and
the mirrors.
Demisting stops automatically after
fifteen minutes.  Press again to resume demisting.
If the engine is switched off before
the end of the fifteen minutes,
demisting will resume when the
engine is switched on again.
Note: it is possible to stop demisting
before it goes off automatically, by
pressing the button again.
Note: the condensation created by
the air conditioning system causes a
flow of water under the vehicle when
stationary, which is perfectly normal.9 Switching off the system
 Press the 'OFF'
button.
This action switches
off the display and the
indicator lights and disarms all the
system functions, with the exception
of demisting of the rear screen.
 Press this button, button 5or one
of the two 'AUTO' buttons again to
reactivate the system with the val
ues which were present before it
was switched off.
10 Air flow Press buttons '+'
and ''respectively
to increase or
decrease the air
flow.
As the air flow is
adjusted, the inner sections of the air
flow symbol (fan) are filled in accord
ingly on the
display.

YOUR 607 IN DETAIL95
Memorising using the buttons
To memorise:
 Place the ignition key in the 'run
ning' position (2nd notch),
 Adjust your seat and mirrors,
 Press button M,then button 1
(first driving position) or button 2
(second driving position) within
four seconds.
An audible signal confirms that a
position has been memorised.
Memorising a new position cancels
the previous one.
Recalling a memorised position
Engine off  Briefly press button 1 or 2to recall
the corresponding memorised
position. The end of the setting is
indicated by a bleep.
Note: after recalling a memorised
position five times in succession, the
function will be cancelled until the
engine is started.
Engine running
 Keep button 1 or 2pressed down
until the bleep indicates the end of
setting of the corresponding
memorised position.
Memorising seat
and mirror positions
Four driving positions can be memo
rised:
– two, using two remote control
keys (two users),
– two, using buttons M/1 and M/2.
Driving positions memorised by
the remote control key
When locking the doors, the remote
control key memorises the position
of the driver's seat and the exterior
mirrors.
When unlocking the doors, the dri
ver's seat and the exterior mirrors
resume the position memorised by
the remote control key if this has
changed in the meantime.
Each remote control key can
memorise a specific setting. Front and rear heated seats
controls
 Press the switch. The tempera
ture is regulated automatically.
 Press it again to stop operation.
Note: the command to activate heat
ing of the seat(s) remains in the
memory for two minutes after the
ignition is switched off.

YOUR 607 IN DETAIL95
Memorising using the buttons
To memorise:
 Place the ignition key in the 'run
ning' position (2nd notch),
 Adjust your seat and mirrors,
 Press button M,then button 1
(first driving position) or button 2
(second driving position) within
four seconds.
An audible signal confirms that a
position has been memorised.
Memorising a new position cancels
the previous one.
Recalling a memorised position
Engine off  Briefly press button 1 or 2to recall
the corresponding memorised
position. The end of the setting is
indicated by a bleep.
Note: after recalling a memorised
position five times in succession, the
function will be cancelled until the
engine is started.
Engine running
 Keep button 1 or 2pressed down
until the bleep indicates the end of
setting of the corresponding
memorised position.
Memorising seat
and mirror positions
Four driving positions can be memo
rised:
– two, using two remote control
keys (two users),
– two, using buttons M/1 and M/2.
Driving positions memorised by
the remote control key
When locking the doors, the remote
control key memorises the position
of the driver's seat and the exterior
mirrors.
When unlocking the doors, the dri
ver's seat and the exterior mirrors
resume the position memorised by
the remote control key if this has
changed in the meantime.
Each remote control key can
memorise a specific setting. Front and rear heated seats
controls
 Press the switch. The tempera
ture is regulated automatically.
 Press it again to stop operation.
Note: the command to activate heat
ing of the seat(s) remains in the
memory for two minutes after the
ignition is switched off.

YOUR 607 IN DETAIL
96
REAR SEATS
Rear seat
The seat back in the rear is folded
down in two parts.
Before folding down the seat back:
 lock the side seat belts.
Note: Before folding down the
2/3 part of the seat back, release the
lap belt strap by pressing the black
button of the lock.
Front armrest
To obtain a resting or driving posi
tion:
 Lift the centre handle 1and pull
the armrest forwards. To return to
the initial position, push the arm
rest backwards.
To open the lower compartment:  Raise the left handle 2. CDs and
coins can be stored here.
To open the top compartment:  Raise the right handle 3.To fold down the seat back
The unlocking controls are located in
the boot.
 pull the control corresponding to
the part of the seat back that you
wish to fold down.
It is also possible to unlock from inside the vehicle:
 lower the armrest and open the
ski flap,
 pull the button located on the
unlocking housing corresponding
to.
When putting the seat back to its original position, for your safety
make sure that it is correctly
locked.

YOUR 607 IN DETAIL97
''Isofix'' mountings*
Available on the one third side of the
rear seat, the Isofix mountings allow
fitting of a
special child seat ,
approved for PEUGEOT vehicles
and sold within its network.
The locks incorporated in the child
seat fit onto the Isofix mountings and
ensure safe, reliable and fast assem
bly.
The seat is fitted in the rearwards or
forwards facing position. In this case,
for optimium safety, it is imperative
to adjust the corresponding front
seat to the intermediate longitudinal
position, with the seat back upright. Ski flap
 Lower the armrest to access the
ski flap. Open by pulling the han
dle. The special child seat approved by
PEUGEOT is the KIDDY Isofix seat.
It can be used in the rearwards fac
ing position from birth to 13 kg and in
the forwards facing position from 9 to
18 kg.
This seat may also be used where
there are no Isofix mountings: in this
case it is compulsory to wear a
threepoint seat belt.
 Follow the instructions in the
brochure for fitting the child
seat.
* According to current legislation

YOUR 607 IN DETAIL
116
EXTERIOR MIRRORS
Adjustment from the inside Turn knob Bto the right or to the
left to select the corresponding
mirror.
 Move knob Bin all four directions
to adjust.
Folding back the mirrors electri
cally *  With the ignition on, turn knob Bto
position A.
or,
 Lock the vehicle using the remote
control.
Note: this function can be neu
tralised. Contact your PEUGEOT
dealer.
When the vehicle is parked, the
exterior mirrors can be folded
back manually. Automatically adjustable
mirrors for parking
These allow you to see the ground
(kerb, wall...) when carrying out
parking manoeuvres in reverse gear.
Tilting the mirror to the parking posi
tion:
 switch on the direction indicator
on the parking side,
 engage reverse gear.
The exterior mirror corresponding
to the side on which you are park
ing tilts downwards.
Returning the mirror to the previous
position:  change out of reverse gear.
Note: to be active, this function must
be initialised by adjusting the mirror,
with reverse gear engaged and the
direction indicator on the side of the
mirror to be adjusted switched on.
Each remote control can memorise a
specific setting.
The driver's mirror is con
vex in order to eliminate
the 'blind spot' (area at
edge defined by a dotted
line).
As a result, objects observed in
the driver's and passenger's mir
rors are in reality closer than they
appear.
This must be taken into account to
judge correctly the distance of
vehicles approaching from
behind.

YOUR 607 IN DETAIL
122
The
four speed automatic gearbox offers a choice between the comfort of inte
gral automatic operation , enhanced by a sportand a snow programme, or the
pleasure of manual gear changing .
Gear selection gate  Move the lever in the gate to select a function.
Once the function is selected, the corresponding indicator lig ht appears on the
instrument panel screen.
S: sport programme.
: snow programme.
P ark: to immobilise the vehicle and to start the
engine , with the handbrake on or off.
R everse: to reverse(select this function with the vehi
cle stationary, engine at idle).
N eutral: to start the engine and to park, with the hand
brake on.
Note: if position Nis inadvertently engaged while dri
ving, allow the engine to return to idle before engagin g
function Dto accelerate.
D rive: for driving in automatic mode.
M anual: for drivingin manual mode.
PORSCHE TIPTRONIC system' AUTOMATIC GEARBOX Moving Off
With the engine running, to move off
from position
P:
 it is essential to press the brake
pedal to exit position P,
 select function R, D or M, then
gradually release the pressure on
the brake pedal; the vehicle
moves off immediately.
You can also move off from position N:
 release the handbrake, with your
foot on the brake,
 select function R, D or M, then
gradually release the pressure on
the brake pedal; the vehicle
moves off immediately.
WARNING
When the engine is at idle, brakes not
applied, if function R, D or Mis select
ed, the vehicle moves even without
the accelerator being pressed. For
this reason, do not leave children
unsupervised inside the vehicle,
with the engine running.
When maintenance operations need
to be carried out with the engine run
ning, apply the handbrake and select
position P.

Operating check
When a malfunction of the sys
tems occurs, the switch light
flashes and the warning light
comes on, accompanied by an
audible signal and the mes
sage 'ESP/ASR system faulty' on the
multifunction display.
Contact a PEUGEOTdealer to have the
system checked.
YOUR 607 IN DETAIL
125
The ESP system offers
exceptional safety in normal
driving, but this should not
encourage the driver to take
extra risks or drive at high
speed.
The correct functioning of this sys
tem depends on observation of the
manufacturer's recommendations
regarding wheels (tyres and rims),
the braking components and the
electronic components, as well as
the PEUGEOT assembly and opera
tion procedures.
After an impact, have the system
checked by a PEUGEOT dealer.
Disarming the ASR/ESP
systems
In exceptional conditions (starting a
vehicle which is bogged down, stuck
in snow, on soft ground...), it may be
advisable to disarm the ASR system,
so that the wheels can move freely
and regain grip.
Press the 'ESP OFF'
switch, located under the
steering wheel to the left.
The switch lights up and the
warning light comes on,
accompanied by an audible
signal and the message
'ASR/ESP system deacti
vated' on the multi–function
display : the ASR and ESP systems
no longer have any effect on the
engine operation.
These are triggered again :
 automatically if the ignition is
switched off,
 manually by pressing the switch
again.DYNAMIC STABILITY
CONTROL (ESP) AND
TRACTION CONTROL (ASR)
These systems are linked and com
plementary to the ABS system.
In the event of a significant variation
between the trajectory of the vehicle
and the path required by the driver,
the ESP system acts automatically
on the engine and on the brake of
one or more wheels, to put the vehi
cle back on course. The traction con
trol (ASR) system optimises drive, in
order to avoid the wheels slipping, by
acting on the brakes of the drive
wheels and on the engine. It also
enables the directional stability of the
vehicle to be improved during accel
eration.
Operation of the ESP
and ASR systems
When one of the two sys
tems is in operation, this
indicator light flashes.