2002 Peugeot 607 Dag check engine light

INSTRUMENTS AND CONTROLS
40
Coolant temperature indicator
When the needle is in
zone A, the
temperature is correct.
When the needle is in zone B, the
temperature is too high.
In cases where the coolant tem
perature warning light comes on
(linked to the STOPwarning light),
you must stop immediately.
Warning: wait for the engine to cool
down.
If necessary, top up the level.
Because the cooling system is pres
surised, to prevent the risk of scald
ing, turn the cap two turns to allow
the pressure to drop.
When the pressure has dropped,
remove the cap and top up the level.
Contact a PEUGEOT dealer.Engine oil level and
temperature
When the ignition is switched on, this
gauge indicates the engine oil level
for approximately 20 seconds, then it
indicates the engine oil temperature.
Engine oil level
The reading is valid only if the vehi
cle is on level ground, and the
engine has been switched off for 10
minutes.
With the ignition on, wait for the
graduated sector to light up and the
indicator needle to move.
When the needle is in zone C, the oil
level is correct.
When the needle is in zone D, the oil
level is incorrect.
There is a risk of damage to the
engine.
 Check the level with the dipstick.
You must top up the level without
exceeding the maximum level on
the gauge.
Engine oil temperature
When the needle is in zone E, the
temperature is correct.
When the needle is in zone F, the
temperature is too high.
Reduce your speed to lower the
temperature.
Service indicator and total
distance recorder
When the ignition is switched on, this
indicates servicing information for a
few seconds, then the total and trip
distances.
Service function
See the 'Service indicator' section.
Total distance recorder function
The total distance is displayed on the
left side of the screen and the trip
distance on the right side.

The engine and the ignition must
be switched off when filling with
fuel : Open the fuel filler flap by press
ing its front right hand edge,
 Unscrew the cap and hook it over
the tab located on the inside of the
flap.
When filling up your tank, do not con
tinue after the 3rd cutoff of the
pump; this could cause your vehicle
to malfunction.
The capacity of the tank is approx
imately 80 litres.  After filling the tank, screw the cap
on fully and close the flap.
Fuel filler cap open When this light comes on,
accompanied by an audible
signal and the message
'Fuel cap open' on the dis
play, screw the cap on again
and close the fuel filler flap.
YOUR 607 IN DETAIL 107
BONNET
Opening
 Pull the lever, located in the dri
ver's footwell, downwards.
 Lift the catch and raise the bon
net.
Bonnet assister struts open the bon
net and keep it open.
Closing
 Lower the bonnet and release it at
the end of its travel.
 Check that it is locked.
'Bonnet open' warning
With the ignition on (2nd notch), with
the engine running or when the vehi
cle is moving, the door open warning
light comes on, accompanied by an
audible signal and a diagram on the
multi–function display, if the bonnet
is not properly closed. FILLING WITH FUEL
Low fuel level
When the minimum fuel
level is reached, this warn
ing light comes on, accom
panied by an audible signal
and the message 'Fuel
level low' on the multifunction dis
play.
You can can still drive approxi
mately 30 miles (50 km) without
filling up with fuel.
Filling with fuel
Locking and unlocking of the fuel
filler flap, the doors and the boot is
simultaneous (except when selective
unlocking is initialised; in this case
press the unlocking button of the
remote control again).

Operating check
When a malfunction of the sys
tems occurs, the switch light
flashes and the warning light
comes on, accompanied by an
audible signal and the mes
sage 'ESP/ASR system faulty' on the
multifunction display.
Contact a PEUGEOTdealer to have the
system checked.
YOUR 607 IN DETAIL
125
The ESP system offers
exceptional safety in normal
driving, but this should not
encourage the driver to take
extra risks or drive at high
speed.
The correct functioning of this sys
tem depends on observation of the
manufacturer's recommendations
regarding wheels (tyres and rims),
the braking components and the
electronic components, as well as
the PEUGEOT assembly and opera
tion procedures.
After an impact, have the system
checked by a PEUGEOT dealer.
Disarming the ASR/ESP
systems
In exceptional conditions (starting a
vehicle which is bogged down, stuck
in snow, on soft ground...), it may be
advisable to disarm the ASR system,
so that the wheels can move freely
and regain grip.
Press the 'ESP OFF'
switch, located under the
steering wheel to the left.
The switch lights up and the
warning light comes on,
accompanied by an audible
signal and the message
'ASR/ESP system deacti
vated' on the multi–function
display : the ASR and ESP systems
no longer have any effect on the
engine operation.
These are triggered again :
 automatically if the ignition is
switched off,
 manually by pressing the switch
again.DYNAMIC STABILITY
CONTROL (ESP) AND
TRACTION CONTROL (ASR)
These systems are linked and com
plementary to the ABS system.
In the event of a significant variation
between the trajectory of the vehicle
and the path required by the driver,
the ESP system acts automatically
on the engine and on the brake of
one or more wheels, to put the vehi
cle back on course. The traction con
trol (ASR) system optimises drive, in
order to avoid the wheels slipping, by
acting on the brakes of the drive
wheels and on the engine. It also
enables the directional stability of the
vehicle to be improved during accel
eration.
Operation of the ESP
and ASR systems
When one of the two sys
tems is in operation, this
indicator light flashes.

PRACTICAL INFORMATION 151
BATTERY
Vehicles fitted with a single battery
To charge the battery using a battery charger:
 Remove the style cover to gain access to the battery,
 Disconnect the battery. Follow the instructions for use given by the
battery charger manufacturer.
 Reconnect the battery, starting with the negative () terminal ,
 Check that the terminals and connectors are clean. If they are co vered with
sulphate (whitish or greenish deposit), disconnect them and clea n them,
 Refit the style cover.
To start the vehicle from another battery:  Remove the style cover to gain access to the battery,
 Connect the red cable to the positive (+) terminals of both ba tteries,
 Connect one end of the green or black cable to the negati ve () terminal of the
slave battery,
 Connect the other end of the green or black cable to an ea rth point on the
broken down vehicle, as far as possible from the battery,
 Start the engine and let it run,
 Wait for the engine to return to idle then disconnect the cables,
 Refit the style cover.
– Never disconnect a ter
minal when the engine
is running.
– Never charge a battery without first disconnect
ing the terminals.
– Close the windows and sunroof fully before disconnecting the
battery.
– After every disconnection of the battery, switch on the ignition
and wait for 1 minute before
starting, to allow the electronic
systems to be initialised. How
ever, if slight difficulties are
experienced after this, please
contact a PEUGEOT dealer.
If electrical work is carried
out, disconnect the starter battery.
It is advisable to disconnect the battery if the vehicle is
not to be used for a period of more than one month.

PRACTICAL INFORMATION
154
T
OWING A TRAILER,
CARAVAN, BOAT ETC...
Only use original PEUGEOTtow
bars which have been tested and
approved from the design stage of
your vehicle.
The tow bar must be fitted by a
PEUGEOTdealer.
Driving advice
Distribution of loads: distribute the
load in the trailer so that the heaviest
loads are as close as possible to the
axle and the nose weight is close to
the maximum authorised without,
however, exceeding it.
Cooling: towing a trailer on a slope
increases the coolant temperature.
As the fan is electronically con
trolled, its cooling capacity is not
dependent on the engine speed.
On the contrary, use a high gear to
lower the engine speed, and reduce
your speed. In all cases, pay attention to the
coolant temperature.
Note:
in certain cases of particularly
arduous use (towing the maximum
load up a steep slope in high tem
peratures), the engine automatically
limits its power. In this case, cutting
off the air conditioning allows the
engine power to be recovered, and
therefore the towing speed to be sig
nificantly increased (approximately
12mph [20 km/h] more).
If the coolant temperature warning
light comes on, stop the vehicle and
switch off the engine as soon as pos
sible.
Tyres: check the tyre pressures of
the towing vehicle and of the trailer,
observing the recommended pres
sure.
Brakes: towing increases the brak
ing distance. Drive at a moderate
speed, change down early and brake
gradually.
Side wind: sensitivity to side wind is
increased. Drive smoothly and at a
moderate speed. Lighting
Manual adjustment
Adjust your headlamps so as not to
dazzle other road users (see section
on ''Manual adjustment of head
lamps''). Check the electrical sig
nalling of the trailer.
Automatic beam correction
For vehicles with Xenon bulbs, this
system automatically corrects the
height of the beam, whatever the
load of the vehicle. The driver is then
assured of having optimum lighting
and not causing a nuisance to other
road users.
In cases of malfunction, the driver is
alerted by means of the warning light
on the instrument panel.
In this situation the system adjusts
your headlamps to the low position.